- 您现在的位置：买卖IC网 > PDF目录68420 > TPS62732DRY (TEXAS INSTRUMENTS INC) SWITCHING REGULATOR, 3000 kHz SWITCHING FREQ-MAX, PDSO6 PDF资料下载
参数资料
| 型号： | TPS62732DRY |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHING REGULATOR, 3000 kHz SWITCHING FREQ-MAX, PDSO6 |
| 封装： | 1 X 1.50 MM, 0.60 MM HEIGHT, PLASTIC, MO-287UFAD, SON-6 |
| 文件页数： | 14/27页 |
| 文件大小： | 4698K |
| 代理商： | TPS62732DRY |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页
V
IN
GND
V
OUT
C
1
C2
L1
Totalarea
islessthan
12mm
SLVSAC3
– MAY 2011
These are the basic signals that need to be measured when evaluating a switching converter. When the
switching waveform shows large duty cycle jitter or the output voltage or inductor current shows oscillations, the
regulation loop may be unstable. This is often a result of board layout and/or L-C combination.
As a next step in the evaluation of the regulation loop, the load transient response is tested. The time between
the application of the load transient and the turn on of the High Side MOSFET, the output capacitor must supply
all of the current required by the load. VOUT immediately shifts by an amount equal to ΔI(LOAD) x ESR, where ESR
is the effective series resistance of COUT. ΔI(LOAD) begins to charge or discharge CO generating a feedback error
signal used by the regulator to return VOUT to its steady-state value. The results are most easily interpreted when
the device operates in PWM mode.
During this recovery time, VOUT can be monitored for settling time, overshoot or ringing that helps judge the
converter
’s stability. Without any ringing, the loop has usually more than 45° of phase margin.
Because the damping factor of the circuitry is directly related to several resistive parameters (e.g., MOSFET
rDS(on)) that are temperature dependant, the loop stability analysis has to be done over the input voltage range,
load current range, and temperature range.
LAYOUT CONSIDERATIONS
As for all switching power supplies, the layout is an important step in the design. Especially RF designs demand
careful attention to the PCB layout. Care must be taken in board layout to get the specified performance. If the
layout is not carefully done, the regulator could show poor line and/or load regulation, stability issues as well as
EMI problems and interference with RF circuits. It is critical to provide a low inductance, impedance ground path.
Therefore, use wide and short traces for the main current paths. The input capacitor should be placed as close
as possible to the IC pins as well as the inductor and output capacitor. Use a common Power GND node and a
different node for the Signal GND to minimize the effects of ground noise. Keep the common path to the GND
PIN, which returns the small signal components and the high current of the output capacitors as short as
possible to avoid ground noise. The VOUT line should be connected to the output capacitor and routed away
from noisy components and traces (e.g. SW line).
Figure 33. Recommended PCB Layout for TPS62730
Copyright
2011, Texas Instruments Incorporated
21
相关PDF资料 |
PDF描述 |
|---|---|
| TPS62732DRYR | SWITCHING REGULATOR, 3000 kHz SWITCHING FREQ-MAX, PDSO6 |
| TPS62735DRY | SWITCHING REGULATOR, 3000 kHz SWITCHING FREQ-MAX, PDSO6 |
| TPS62731DRY | SWITCHING REGULATOR, 3000 kHz SWITCHING FREQ-MAX, PDSO6 |
| TPS62734DRYT | SWITCHING REGULATOR, 3000 kHz SWITCHING FREQ-MAX, PDSO6 |
| TPS62735DRYR | SWITCHING REGULATOR, 3000 kHz SWITCHING FREQ-MAX, PDSO6 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS62732DRYR | 功能描述:直流/直流开关转换器 SD Cnvtr w/ Bypass Mode RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| TPS62732DRYT | 功能描述:直流/直流开关转换器 SD Cnvtr w/ Bypass Mode RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| TPS62733DRYR | 功能描述:直流/直流开关转换器 SD Cnvtr w/ Bypass Mode RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| TPS62733DRYT | 功能描述:直流/直流开关转换器 SD Cnvtr w/ Bypass Mode RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| TPS62733EVM-726 | 制造商:Texas Instruments 功能描述:TPS62733EVM-726 制造商:Texas Instruments 功能描述:TPS62733EVM-726 - Boxed Product (Development Kits) 制造商:Texas Instruments 功能描述:EVAL MODULE FOR TPS62733-726 制造商:Texas Instruments 功能描述:TPS62733 Eval Mod |
发布紧急采购，3分钟左右您将得到回复。