- 您现在的位置：买卖IC网 > PDF目录69520 > TPS63021DSJT (TEXAS INSTRUMENTS INC) 4.5 A SWITCHING REGULATOR, 2600 kHz SWITCHING FREQ-MAX, PDSO14 PDF资料下载
参数资料
| 型号： | TPS63021DSJT |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | 4.5 A SWITCHING REGULATOR, 2600 kHz SWITCHING FREQ-MAX, PDSO14 |
| 封装： | 3 X 4 MM, GREEN, PLASTIC, VSON-14 |
| 文件页数： | 7/24页 |
| 文件大小： | 1403K |
| 代理商： | TPS63021DSJT |
OUT
FB
V
R1 = R2 ×
- 1
V
÷
è
L1
VIN
VINA
EN
PS/SYNC
GND
L2
VOUT
FB
PGND
L
1
C2
C1
VIN
VOUT
TPS6302x
PG
Power Good
Output
C3
PS/SYNC
R1
R2
R3
(
)
IN1
OUT
s
L1 =
V
× 0.5 ×
A
-
OUT
s
L2 = V
× 0.5 ×
A
www.ti.com
SLVS916 – APRIL 2010
APPLICATION INFORMATION
DESIGN PROCEDURE
The TPS6302x dc/dc converters are intended for systems powered by one-cell Li-Ion or Li-Polymer battery with a
typical voltage between 2.3 V and 4.5 V. They can also be used in systems powered by a double or triple cell
Alkaline, NiCd, or NiMH battery with a typical terminal voltage between 1.8V and 5.5V . Additionally, any other
voltage source with a typical output voltage between 1.8V and 5.5V can power systems where the TPS6302x is
used.
PROGRAMMING THE OUTPUT VOLTAGE
Within the TPS6302x family there are fixed and adjustable output voltage versions available. To properly
configure the fixed output voltage devices, the FB pin is used to sense the output voltage. This means that it
must be connected directly to VOUT. For the adjustable output voltage versions, an external resistor divider is
used to adjust the output voltage. The resistor divider must be connected between VOUT, FB and GND. When
the output voltage is regulated properly, the typical value of the voltage at the FB pin is 500mV. The maximum
recommended value for the output voltage is 5.5V. The current through the resistor divider should be about 100
times greater than the current into the FB pin. The typical current into the FB pin is 0.01mA, and the voltage
across the resistor between FB and GND, R2, is typically 500 mV. Based on these two values, the recommended
value for R2 should be lower than 500k
, in order to set the divider current at 1mA or higher. It is recommended
to keep the value for this resistor in the range of 200k
. From that, the value of the resistor connected between
(1)
Figure 21. Typical Application Circuit for Adjustable Output Voltage Option
INDUCTOR SELECTION
To properly configure the TPS6302x devices, an inductor must be connected between pin L1 and pin L2. To
estimate the inductance value, Equation 2 and Equation 3 can be used.
(2)
(3)
In Equation 2 the minimum inductance value, L1 for step down mode operation is calculated. VIN1 is the
Copyright 2010, Texas Instruments Incorporated
15
相关PDF资料 |
PDF描述 |
|---|---|
| TPS63021DSJ | 4.5 A SWITCHING REGULATOR, 2600 kHz SWITCHING FREQ-MAX, PDSO14 |
| TPS63030DSK | 1.1 A SWITCHING REGULATOR, 2600 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS63031DSKT | 1.1 A SWITCHING REGULATOR, 2600 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS63030DSKRG4 | 1.1 A SWITCHING REGULATOR, 2600 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS63031DSK | 1.1 A SWITCHING REGULATOR, 2600 kHz SWITCHING FREQ-MAX, PDSO10 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS630240EVM-553 | 功能描述:TPS63024x - DC/DC, Step Up or Down 1, Non-Isolated Outputs Evaluation Board 制造商:texas instruments 系列:- 零件状态:有效 主要用途:DC/DC，步升/步降 输出和类型:1，非隔离 功率 - 输出:- 电压 - 输出:3.3V 电流 - 输出:1.5A 电压 - 输入:2.5 V ~ 5.5 V 稳压器拓扑:降压-升压 频率 - 开关:2.5MHz 板类型:完全填充 所含物品:板 使用的 IC/零件:TPS63024x 标准包装:1 |
| TPS630241YFFT | 功能描述:Buck-Boost Switching Regulator IC Positive Fixed 2.9V 1 Output 2.12A (Switch) 20-UFBGA, DSBGA 制造商:texas instruments 系列:- 包装:剪切带（CT） 零件状态:有效 功能:升压/降压 输出配置:正 拓扑:降压-升压 输出类型:固定 输出数:1 电压 - 输入（最小值）:2.3V 电压 - 输入（最大值）:5.5V 电压 - 输出（最小值/固定）:2.9V 电压 - 输出（最大值）:- 电流 - 输出:2.12A（开关） 频率 - 开关:2.5MHz 同步整流器:是 工作温度:-40°C ~ 85°C（TA） 安装类型:表面贴装 封装/外壳:20-UFBGA，DSBGA 供应商器件封装:20-DSBGA 标准包装:1 |
| TPS630242YFFT | 功能描述:Buck-Boost Switching Regulator IC Positive Fixed 3.3V 1 Output 2.12A (Switch) 20-UFBGA, DSBGA 制造商:texas instruments 系列:- 包装:剪切带（CT） 零件状态:有效 功能:升压/降压 输出配置:正 拓扑:降压-升压 输出类型:固定 输出数:1 电压 - 输入（最小值）:2.3V 电压 - 输入（最大值）:5.5V 电压 - 输出（最小值/固定）:3.3V 电压 - 输出（最大值）:- 电流 - 输出:2.12A（开关） 频率 - 开关:2.5MHz 同步整流器:是 工作温度:-40°C ~ 85°C（TA） 安装类型:表面贴装 封装/外壳:20-UFBGA，DSBGA 供应商器件封装:20-DSBGA 标准包装:1 |
| TPS63024YFFR | 功能描述:BUCK-BOOST ADJ 2.12A 20DSBGA 制造商:texas instruments 系列:- 包装:剪切带（CT） 零件状态:在售 功能:升压/降压 输出配置:正 拓扑:降压升压 输出类型:可调式 输出数:1 电压 - 输入（最小值）:2.3V 电压 - 输入（最大值）:5.5V 电压 - 输出（最小值/固定）:2.5V 电压 - 输出（最大值）:3.6V 电流 - 输出:2.12A（开关） 频率 - 开关:2.5MHz 同步整流器:是 工作温度:-40°C ~ 85°C（TA） 安装类型:表面贴装 封装/外壳:20-UFBGA 供应商器件封装:20-DSBGA 标准包装:1 |
| TPS63024YFFT | 功能描述:Buck-Boost Switching Regulator IC Positive Adjustable 2.5V 1 Output 2.12A (Switch) 20-UFBGA, DSBGA 制造商:texas instruments 系列:- 包装:剪切带（CT） 零件状态:有效 功能:升压/降压 输出配置:正 拓扑:降压-升压 输出类型:可调式 输出数:1 电压 - 输入（最小值）:2.3V 电压 - 输入（最大值）:5.5V 电压 - 输出（最小值/固定）:2.5V 电压 - 输出（最大值）:3.6V 电流 - 输出:2.12A（开关） 频率 - 开关:2.5MHz 同步整流器:是 工作温度:-40°C ~ 85°C（TA） 安装类型:表面贴装 封装/外壳:20-UFBGA，DSBGA 供应商器件封装:20-DSBGA 标准包装:1 |
发布紧急采购，3分钟左右您将得到回复。