参数资料
型号: TPS63700DRCTG4
厂商: TEXAS INSTRUMENTS INC
元件分类: 稳压器
英文描述: 1.14 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PDSO10
封装: 3 X 3 MM, GREEN, PLASTIC, SON-10
文件页数: 7/25页
文件大小: 668K
代理商: TPS63700DRCTG4
C
min +
I
OUT
V
OUT
f
S
DV
V
OUT *
V
IN
DVESR + IOUT
R
ESR
www.ti.com
SLVS530B – SEPTEMBER 2005 – REVISED NOVEMBER 2007
The following inductor series from different suppliers have been tested with the TPS63700 converter:
Table 2. List of Inductors
Output Voltage
Vendor
SUGGESTED INDUCTOR
VLF4012 4.7 mH
–5V
TDK
SLF6025-4.7 mH
LPS4018 4.7 mH
–5V
Coilcraft
LPS3015 4.7 mH
–12V
Sumida
CDRH5D18 10 mH
–12V
Coilcraft
MOS6020 10 mH
Capacitor Selection
Input Capacitor
At least a 10-mF ceramic input capacitor is recommended for a good transient behavior of the regulator, and EMI
behavior of the total power supply circuit.
Output Capacitors
One of the major parameters necessary to define the capacitance value of the output capacitor is the maximum
allowed output voltage ripple of the converter. This ripple is determined by two parameters of the capacitor, the
capacitance and the ESR. It is possible to calculate the minimum capacitance needed for the defined ripple,
supposing that the ESR is zero, by using Equation 6 for the inverting converter output capacitor.
(6)
Parameter f is the switching frequency and ΔV is the maximum allowed ripple.
With a chosen ripple voltage in the range of 10 mV, a minimum capacitance of 12 mF is needed. The total ripple
is larger due to the ESR of the output capacitor. This additional component of the ripple can be calculated using
(7)
An additional ripple of 2 mV is the result of using a typical ceramic capacitor with an ESR in a 10-m
Ω range. The
total ripple is the sum of the ripple caused by the capacitance, and the ripple caused by the ESR of the capacitor.
In this example, the total ripple is 12 mV. Additional ripple is caused by load transients. When the load current
increases rapidly, the output capacitor must provide the additional current until the inductor current has been
increased by the control loop by setting a higher on-time at the main switch (duty cycle). The higher duty cycle
results in longer inductor charging periods. But the rate of increase of the inductor current is also limited by the
inductance itself. When the load current decreases rapidly, the output capacitor needs to store the excessive
energy (stored in the inductor) until the regulator has decreased the inductor current by reducing the duty cycle.
The recommendation is to use higher capacitance values, as the previous calculations show.
Stabilizing the Control Loop
Feedback Divider
To speed up the control loop, a feed-forward capacitor of 10 pF is recommended in the feedback divider, parallel
to R3.
To avoid coupling noise into the control loop from the feed-forward capacitor, the feed-forward effect can be
bandwidth-limited by adding series resistor R4. A value in the range of 100 k
is suitable. The higher the
resistance, the lower the noise coupled into the control loop system.
Copyright 2005–2007, Texas Instruments Incorporated
15
Product Folder Link(s): TPS63700
相关PDF资料
PDF描述
TLVH431BCLPE3 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 1.24 V, PBCY3
TLVH431BQLPE3 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 1.24 V, PBCY3
TPS63010YFF 2.4 A SWITCHING REGULATOR, 2600 kHz SWITCHING FREQ-MAX, BGA20
TC151B2118EOA713 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8
TC151A2826EOA723 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8
相关代理商/技术参数
参数描述
TPS63700EVM-139 功能描述:电源管理IC开发工具 TPS63700-139 Eval Mod RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V
TPS63710DRRT 功能描述:LOW NOISE, 1A SYNCHRONOUS INVERT 制造商:texas instruments 系列:* 包装:剪切带(CT) 零件状态:在售 安装类型:表面贴装 封装/外壳:12-WFDFN 裸露焊盘 供应商器件封装:12-SON(3x3) 标准包装:1
TPS642000DBVR 制造商:Texas Instruments 功能描述:
TPS64200DBVR 功能描述:DC/DC 开关控制器 Adj Hi-Efficient Step-Dwn 20uA SOT-23 RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK
TPS64200DBVRG4 功能描述:DC/DC 开关控制器 Adj Hi-Efficient Step-Dwn 20uA SOT-23 RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK