- 您现在的位置：买卖IC网 > PDF目录150819 > TPS65070TRSLRQ1 (TEXAS INSTRUMENTS INC) POWER SUPPLY SUPPORT CKT, PQCC48 PDF资料下载
参数资料
| 型号： | TPS65070TRSLRQ1 |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 电源管理 |
| 英文描述： | POWER SUPPLY SUPPORT CKT, PQCC48 |
| 封装： | 6 X 6 MM, 0.4 MM PITCH, PLASTIC, QFN-48 |
| 文件页数： | 18/90页 |
| 文件大小： | 1375K |
| 代理商： | TPS65070TRSLRQ1 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页当前第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页
IIN -MAX
900mA
500mA
150mA
750mA
400mA
I O
U
T
I BA
T
I I
N
www.ti.com
SLVSAP7 – JANUARY 2011
POWER DOWN
The charger remains in a power down mode when the input voltage at the AC or USB pin is below the
under-voltage lockout threshold VUVLO. During the power down mode the host commands at the control pins are
not interpreted.
POWER-ON RESET
The charger resets when the input voltage at the AC or USB pin enters the valid range between VUVLO and
VOVLO. All internal timers and other circuit blocks are reset. The device then waits for a time period TDGL(PGOOD),
after which CHARGER ACTIVE Bit indicates the input power status, and the Iset pin is interpreted.
POWER-PATH MANAGEMENT
There are two inputs to the power path called AC and USB. Both inputs support the same voltage rating but are
typically set to a different current limit with AC beeing at the higher limit and USB at the lower. If voltage is
applied at both inputs and both are enabled in register PPATH1 (default setting), AC will be preferred over USB.
In this case, the deivce is only powered from AC and there is no current from USB. If voltage at AC is removed,
the USB input will become and is powered from USB. The current at the input pin AC or USB of the power path
manager is shared between charging the battery and powering the system load on the SYS pin. Priority is given
to the system load. The input current is monitored continuously. If the sum of the charging and system load
currents exceeds the preset maximum input current (programmed internally by I2C), the charging current is
reduced automatically. See the electrical characteristics or the register desciption for the default current limit on
AC and USB for the different family members.
Figure 26 illustrates what happens in an example case where the battery fast-charge current is set to 500mA, the
input current limit is set at 900mA and the system load varies from 0 to 750mA.
Figure 26. Power Path Functionality
SYS Output
The SYS pin is the output of the power path. When is turned off and there is no voltage at AC or USB, the SYS
output is disconnected internally from the battery. When is turned on by pulling PB_IN =LOW, the voltage at SYS
will ramp with a soft-start. During soft start, the voltage at SYS is ramped with a 30mA current source until the
voltage reached 1.8V. During the soft start, the SYS pin must not be loaded by an external load.
BATTERY CHARGING
When Bit CHARGER ENABLE in register CHGCONFIG1 is set to 1, battery charging can begin. First, the device
checks for a short-circuit on the BAT pin: IBAT(SC) is turned on till the voltage on the BAT pin rises above VBAT(SC).
If conditions are safe, it proceeds to charge the battery.
The battery is charged in three phases: conditioning pre-charge, constant current fast charge (current regulation)
and a constant voltage tapering-off (voltage regulation). In all charge phases, an internal control loop monitors
the IC junction temperature and reduces the charge current if the internal temperature threshold is exceeded.
Figure 27 shows what happens in each of the three phases:
Copyright 2011, Texas Instruments Incorporated
25
相关PDF资料 |
PDF描述 |
|---|---|
| TS3810CXDRF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO3 |
| TC151B2012EOA723 | 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
| TC151A1813EOA713 | 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
| TC151A2914EOA713 | 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
| TC151A4921EOA723 | 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS650721RSLT | 制造商:Texas Instruments 功能描述: |
| TPS65072EVM-430 | 功能描述:电源管理IC开发工具 TPS65072 Eval Mod RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| TPS65072RSLR | 功能描述:PMIC 解决方案 Sgl Chip Power Sol for Nav Sys RoHS:否 制造商:Texas Instruments 安装风格:SMD/SMT 封装 / 箱体:QFN-24 封装:Reel |
| TPS65072RSLT | 功能描述:PMIC 解决方案 Sgl Chip Power Sol for Nav Sys RoHS:否 制造商:Texas Instruments 安装风格:SMD/SMT 封装 / 箱体:QFN-24 封装:Reel |
| TPS650731EVM-430 | 功能描述:电源管理IC开发工具 TPS650731 Eval Mod RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
发布紧急采购，3分钟左右您将得到回复。