参数资料
型号: TPS65136RTE
厂商: TEXAS INSTRUMENTS INC
元件分类: 稳压器
英文描述: 1.12 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PQCC16
封装: 3 X 3 MM, PLASTIC, WQFN-16
文件页数: 3/21页
文件大小: 721K
代理商: TPS65136RTE
2
o
c
S
V
(1 D)
I =
f
2
L
-
g
(1)
in
L
S
V
D
i
=
L
f
D
g
+
out
in
sw
I
V
D
I
=
2
f
L
1
D
-
g
(2)
Overvoltage Protection
Short-Circuit Protection
Soft-Start Operation
Start-Up Sequencing
8.7ms
V
pos
V
neg
T0298-01
Output-Current Mismatch
Input Capacitor Selection
www.ti.com ............................................................................................................................................................. SLVS831A – APRIL 2008 – REVISED JULY 2008
The inductor ripple current when operating in CCM can also be calculated.
Last but not least, the converter switch peak current is calculated.
The device monitors both the positive and negative output voltages. The positive regulator monitors the positive
output and reduces the current limit when the output voltage exceeds the overvoltage protection limit. The
negative output is clamped using a zener diode, typically to –7.6 V.
Both outputs are protected against short circuits either to GND or against the other output. For the positive
output, the device switching frequency and the current limit are reduced in case of a short circuit.
The device increases the current limit during soft-start operation to avoid high inrush currents during start-up.
The current limit typically ramps up to its full-current limit within 100
s.
The TPS65136 includes an internal, fixed start-up sequence, where the negative output voltage rail comes up
after the positive output voltage rail. The device starts the positive rail first, and an internal counter delays the
start-up of the negative rail, typically by 8.7 ms. The negative rail is clamped, typically to –0.4 V, until the internal
timer commands the negative rail to start up.
Figure 15. Start-Up Sequencing
The device operates best when the current of the positive output is similar to the current of the negative output.
However, the device is able to regulate an output-current mismatch between the outputs of up to 30%. If the
output-current mismatch becomes much larger, then one of the outputs goes out of regulation.
The device typically requires a 10-
F ceramic input capacitor. Larger values can be used to lower the input
voltage ripple. Table 1 lists capacitors suitable for use on the TPS65136 input.
Copyright 2008, Texas Instruments Incorporated
11
Product Folder Link(s): TPS65136
相关PDF资料
PDF描述
TPS65136RTER 1.12 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PQCC16
TPS65150PWPR 3-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO24
TPS65161APWP 5.5 A SWITCHING REGULATOR, 900 kHz SWITCHING FREQ-MAX, PDSO28
TPS65161PWPRG4 4.2 A SWITCHING REGULATOR, 900 kHz SWITCHING FREQ-MAX, PDSO28
TPS65161BPWP SWITCHING REGULATOR, 900 kHz SWITCHING FREQ-MAX, PDSO28
相关代理商/技术参数
参数描述
TPS65136RTER 功能描述:LED照明驱动器 Dual Pos and Neg Output Reg RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
TPS65136RTER 制造商:Texas Instruments 功能描述:DC/DC Converter IC
TPS65136RTERG4 功能描述:LED照明驱动器 Dual Pos & Neg Output Reg RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
TPS65137ADSCR 功能描述:LED照明驱动器 Dual Pos & Neg Out puts w/Dig Vneg Adj RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
TPS65137AEVM-366 功能描述:电源管理IC开发工具 TPS65137A Eval Mod RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V