- 您现在的位置：买卖IC网 > PDF目录373691 > TS1051CSRL (Taiwan Semiconductor Co., Ltd.) Constant Voltage and Constant Current Controller For Battery Chargers and Adaptors PDF资料下载
参数资料
| 型号： | TS1051CSRL |
| 厂商： | Taiwan Semiconductor Co., Ltd. |
| 元件分类： | 基准电压源/电流源 |
| 英文描述： | Constant Voltage and Constant Current Controller For Battery Chargers and Adaptors |
| 中文描述： | 恒压恒为电池充电器和适配器电流控制器 |
| 文件页数： | 4/9页 |
| 文件大小： | 439K |
| 代理商： | TS1051CSRL |
TS1051
Constant Voltage and Constant Current Controller
For Battery Chargers and Adaptors
Principle of Operation and Application Hints (continues)
4/9
Version: B07
Current Control
The current loop is controlled via the second trans-conductance operational amplifier, the sense resistor Rsense, and
the optocoupler. The control verifies as following
* Rsense x llim = Vsense
* Rsense = Vsense / llim
Ilim is the desired limited current, Vsense is the threshold voltage for the current control loop.
As an example, with llim = 1A, Vsense = -200mV, then Rsense = 200m
Ω
.
Note that the Rsense resistor should be chosen taking into account the maximum dissipation (Plim) through it during
full load operation.
* Plim = Vsense x llim
As an example, with llim=1A, and Vsense=200mV, Plim=200mW.
Therefore, for most adapter and battery charger applications, a quarter-watt, or half-watt resistor to make the current
sensing function is sufficient.
Vsense threshold is achieved internally by a resistor bridge tied to the Vref voltage reference. Its middle point is tied to
the positive input of the current control operational amplifier, and its foot is to be connected to lower potential point of
the senseresistor as shown on the following figure. The resistors of this bridge are matched to provide the best
precision possible. The current siking outpits of the two trans-conductance operational amplifiers are common (to the
outpit of the IC). This makes an Oring function which ensures that whenever the current or the voltage reaches too
high values, the optocoupler is activated.
The relation between the controlled current and the controlled output voltage can be described with a square
characteristic as shown in the following V/I output-power graph
Output Voltage vs. Output Current
相关PDF资料 |
PDF描述 |
|---|---|
| TS1051CX6RF | Constant Voltage and Constant Current Controller For Battery Chargers and Adaptors |
| TS1082CZ-3.3 | 128 x 128 pixel format, LED or EL Backlight available |
| TS1082 | 5.0 AMP POSITIVE VOLTAGE REGULATOR |
| TS1082CZ | 5.0 AMP POSITIVE VOLTAGE REGULATOR |
| TS1082CZ-2.5 | 5.0 AMP POSITIVE VOLTAGE REGULATOR |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TS1051CX6 | 功能描述:电流和电力监控器、调节器 14 Volt 1.1mA ICC Constant Volt/Curr RoHS:否 制造商:STMicroelectronics 产品:Current Regulators 电源电压-最大:48 V 电源电压-最小:5.5 V 工作温度范围:- 40 C to + 150 C 安装风格:SMD/SMT 封装 / 箱体:HPSO-8 封装:Reel |
| TS1051CX6 RF | 制造商:SKMI/Taiwan 功能描述:SOT-26;ADAPTER IC 制造商:Taiwan Semiconductor 功能描述:OP AMP LOW POWER SINGLE SOT-26-6 |
| TS1051CX6RF | 制造商:TSC 制造商全称:Taiwan Semiconductor Company, Ltd 功能描述:Constant Voltage and Constant Current Controller For Battery Chargers and Adaptors |
| TS105-2 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Thermosensors |
| TS1052CX6 RFG | 功能描述:电流和电力监控器、调节器 Constant voltage and current controller RoHS:否 制造商:STMicroelectronics 产品:Current Regulators 电源电压-最大:48 V 电源电压-最小:5.5 V 工作温度范围:- 40 C to + 150 C 安装风格:SMD/SMT 封装 / 箱体:HPSO-8 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。