- 您现在的位置：买卖IC网 > PDF目录97771 > TS3V556IDT (STMICROELECTRONICS) DUAL PULSE; RECTANGULAR, 2 MHz, TIMER, PDSO14 PDF资料下载
参数资料
| 型号： | TS3V556IDT |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 模拟波形发生器 |
| 英文描述： | DUAL PULSE; RECTANGULAR, 2 MHz, TIMER, PDSO14 |
| 封装： | MICRO, PLASTIC, SO-14 |
| 文件页数： | 5/8页 |
| 文件大小： | 104K |
| 代理商： | TS3V556IDT |
TS3V556
5/8
Do
no
t u
se
for
new
design
TYPICAL CHARACTERISTICS
Figure 1 : Supply Current (each timer) versus
Supply Voltage
APPLICATION INFORMATION
MONOSTABLE OPERATION
In the monostable mode,the timer functions as a
one-shot. Referring to figure 2 the external capac-
itor is initially held discharged by a transistor in-
side the timer.
Figure 2 :
The circuit triggers on a negative-going input sig-
nal when the level reaches 1/3 VCC. Once trig-
gered,the circuit remains in this state until the set
time has elapsed,even if it is triggered again dur-
ing this interval. The duration of the output HIGH
state is given by t = 1.1 R x C.
Notice that since the charge rate and the threshold
level of the comparator are both directly propor-
tional to supply voltage, the timing interval is inde-
pendent of supply. Applying a negative pulse si-
multaneously to the Reset terminal (pin 4 or 10)
and the Trigger terminal (pin 2 or 8) during the tim-
ing cycle discharges the external capacitor and
causes the cycle to start over. The timing cycle
now starts on the positive edge of the reset pulse.
During the time the reset pulse is applied, the out-
put is driven to its LOW state.
When a negative trigger pulse is applied to the
trigger terminal, the flip-flop is set, releasing the
short circuit across the external capacitor and driv-
ing the output HIGH. The voltage across the ca-
pacitor increases exponentially with the time con-
stant
τ = R x C.
When the voltage across the capacitor equals 2/3
VCC, the comparator resets the flip-flop which then
discharges the capacitor rapidly and drives the
output to its LOW state.
Figure 3 shows the actual waveforms generated in
this mode of operation.
When Reset is not used, it should be tied high to
avoid any possible or false triggering.
Figure 3 :
CC
SUPPLY VOLTAGE, V
(V)
CC
S
U
P
L
Y
C
U
R
E
N
T,
I
(
A
)
300
200
100
0
4
8
12
16
VCC
Reset
Trigger
Out
R
C
Control Voltage
0.01 F
1/2
TS3V556
CAPACITOR VOLTAGE = 2.0V/div
t = 0.1 ms / div
INPUT = 2.0V/div
OUTPUT VOLTAGE = 5.0V/div
R = 9.1k , C = 0.01 F , R = 1.0k
L
Do
no
t u
se
for
new
design
相关PDF资料 |
PDF描述 |
|---|---|
| TS4-45B01 | 1 FUNCTIONS, 45 MHz, 7.5 kHz BW(delta f), MONOLITHIC CRYSTAL FILTER |
| TS4041DILT-1.2 | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 1.225 V, PDSO3 |
| TSA5511D | PLL FREQUENCY SYNTHESIZER, 1300 MHz, PDSO18 |
| TSB5387P | 1 FUNCTIONS, 38.9 MHz, SAW-VIDEO/SOUND FILTER |
| TSD0914-01 | 959 MHz(Tx)-960 MHz(Tx), 914 MHz(Rx)-915 MHz(Rx), DUPLEXER |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TS3V556IN | 功能描述:计时器和支持产品 USE 511-TS556IN RoHS:否 制造商:Micrel 类型:Standard 封装 / 箱体:SOT-23 内部定时器数量:1 电源电压-最大:18 V 电源电压-最小:2.7 V 最大功率耗散: 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装:Reel |
| TS3V712E | 制造商:TI 制造商全称:Texas Instruments 功能描述:7-CHANNEL VIDEO SWITCH |
| TS3V712E_1002 | 制造商:TI 制造商全称:Texas Instruments 功能描述:7-CHANNEL VIDEO SWITCH |
| TS3V712EL | 制造商:TI 制造商全称:Texas Instruments 功能描述:7-CHANNEL VIDEO SWITCH WITH INTEGRATED LEVEL SHIFTERS |
| TS3V712ELRTGR | 功能描述:视频开关 IC 7Ch1:2 Video Switch RoHS:否 制造商:Texas Instruments 开关数量:4 开启电阻（最大值）:12 Ohms 传播延迟时间: 开启时间（最大值）: 关闭时间（最大值）: 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:WQFN-42 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。