- 您现在的位置：买卖IC网 > PDF目录69533 > TS5A2066DCURE4 (TEXAS INSTRUMENTS INC) DUAL 1-CHANNEL, SGL POLE SGL THROW SWITCH, PDSO8 PDF资料下载
参数资料
| 型号： | TS5A2066DCURE4 |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 多路复用及模拟开关 |
| 英文描述： | DUAL 1-CHANNEL, SGL POLE SGL THROW SWITCH, PDSO8 |
| 封装： | GREEN, PLASTIC, VSSOP-8 |
| 文件页数： | 8/28页 |
| 文件大小： | 653K |
| 代理商： | TS5A2066DCURE4 |
第1页第2页第3页第4页第5页第6页第7页当前第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
SCDS184D – JANUARY 2005 – REVISED APRIL 2010
www.ti.com
Table 2. PIN DESCRIPTION
NO.
NAME
DESCRIPTION
1
NO1
Normally open
2
COM1
Common
3
IN2
Digital control to connect COM to NO
4
GND
Digital ground
5
NO2
Normally open
6
COM2
Common
7
IN1
Digital control to connect COM to NO
8
V+
Power supply
Table 3. PARAMETER DESCRIPTION
SYMBOL
DESCRIPTION
VCOM
Voltage at COM
VNO
Voltage at NO
ron
Resistance between COM and NO ports when the channel is ON
Δron
Difference of ron between channels in a specific device
ron(flat)
Difference between the maximum and minimum value of ron in a channel over the specified range of conditions
INO(OFF)
Leakage current measured at the NO port, with the corresponding channel (NO to COM) in the OFF state
Leakage current measured at the NO port, with the corresponding channel (NO to COM) in the ON state and the output
INO(ON)
(COM) open
ICOM(OFF)
Leakage current measured at the COM port, with the corresponding channel (COM to NO) in the OFF state
Leakage current measured at the COM port, with the corresponding channel (COM to NO) in the ON state and the output
ICOM(ON)
(NO) open
VIH
Minimum input voltage for logic high for the control input (IN)
VIL
Maximum input voltage for logic low for the control input (IN)
VI
Voltage at the control input (IN)
IIH, IIL
Leakage current measured at the control input (IN)
Turn-on time for the switch. This parameter is measured under the specified range of conditions and by the propagation
tON
delay between the digital control (IN) signal and analog output (COM or NO) signal when the switch is turning ON.
Turn-off time for the switch. This parameter is measured under the specified range of conditions and by the propagation
tOFF
delay between the digital control (IN) signal and analog output (COM or NO) signal when the switch is turning OFF.
Charge injection is a measurement of unwanted signal coupling from the control (IN) input to the analog (NO or COM)
QC
output. This is measured in coulomb (C) and measured by the total charge induced due to switching of the control
input.Charge injection, QC = CL × ΔVCOM, CL is the load capacitance and ΔVCOM is the change in analog output voltage.
CNO(OFF)
Capacitance at the NO port when the corresponding channel (NO to COM) is OFF
CNO(ON)
Capacitance at the NO port when the corresponding channel (NO to COM) is ON
CCOM(OFF)
Capacitance at the COM port when the corresponding channel (COM to NO) is OFF
CCOM(ON)
Capacitance at the COM port when the corresponding channel (COM to NO) is ON
CI
Capacitance of IN
OFF isolation of the switch is a measurement of OFF-state switch impedance. This is measured in dB in a specific
OISO
frequency, with the corresponding channel (NO to COM) in the OFF state.
Crosstalk is a measurement of unwanted signal coupling from an ON channel to an adjacent ON channel (NC1 to NC2).
XTALK
This is measured in a specific frequency and in dB.
BW
Bandwidth of the switch. This is the frequency in which the gain of an ON channel is –3 dB below the DC gain.
Total harmonic distortion is defined as the ratio of the root mean square (RMS) value of the second, third, and higher
THD
harmonics to the magnitude of fundamental harmonic.
I+
Static power-supply current with the control (IN) pin at V+ or GND
16
Copyright 2005–2010, Texas Instruments Incorporated
Product Folder Link(s): TS5A2066
相关PDF资料 |
PDF描述 |
|---|---|
| TS5A2066DCTRE4 | DUAL 1-CHANNEL, SGL POLE SGL THROW SWITCH, PDSO8 |
| TS5A23159DGSTE4 | DUAL 1-CHANNEL, SGL POLE DOUBLE THROW SWITCH, PDSO10 |
| TS5A23159RSERG4 | DUAL 1-CHANNEL, SGL POLE DOUBLE THROW SWITCH, PQCC10 |
| TS5A23159RSER | DUAL 1-CHANNEL, SGL POLE DOUBLE THROW SWITCH, PQCC10 |
| TS5A23160DGSRE4 | DUAL 1-CHANNEL, SGL POLE DOUBLE THROW SWITCH, PDSO10 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TS5A2066DCURG4 | 功能描述:模拟开关 IC 2Ch 10-Ohm SPST Ana Sw RoHS:否 制造商:Texas Instruments 开关数量:2 开关配置:SPDT 开启电阻（最大值）:0.1 Ohms 切换电压（最大）: 开启时间（最大值）: 关闭时间（最大值）: 工作电源电压:2.7 V to 4.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:DSBGA-16 |
| TS5A2066YEPR | 制造商:TI 制造商全称:Texas Instruments 功能描述:DUAL-CHANNEL 10-W SPST ANALOG SWITCH |
| TS5A2066YZPR | 功能描述:模拟开关 IC Dual-Ch 10-Ohm SPST Ana Sw RoHS:否 制造商:Texas Instruments 开关数量:2 开关配置:SPDT 开启电阻（最大值）:0.1 Ohms 切换电压（最大）: 开启时间（最大值）: 关闭时间（最大值）: 工作电源电压:2.7 V to 4.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:DSBGA-16 |
| TS5A21366 | 制造商:TI 制造商全称:Texas Instruments 功能描述:0.75-Ω DUAL SPST ANALOG SWITCH WITH 1.8-V COMPATIBLE INPUT LOGIC |
| TS5A21366_1 | 制造商:TI 制造商全称:Texas Instruments 功能描述:0.75-?? DUAL SPST ANALOG SWITCH WITH 1.8-V COMPATIBLE INPUT LOGIC |
发布紧急采购，3分钟左右您将得到回复。