- 您现在的位置：买卖IC网 > PDF目录385016 > TS5A23166YEPR (Texas Instruments, Inc.) 0.9-ohm DUAL SPST ANALOG SWITCH 5-V/3.3-V 2-CHANNEL ANALOG SWITCH PDF资料下载
参数资料
| 型号： | TS5A23166YEPR |
| 厂商： | Texas Instruments, Inc. |
| 英文描述： | 0.9-ohm DUAL SPST ANALOG SWITCH 5-V/3.3-V 2-CHANNEL ANALOG SWITCH |
| 中文描述： | 0.9欧姆双路SPST模拟开关5-V/3.3-V 2通道模拟开关 |
| 文件页数： | 15/22页 |
| 文件大小： | 331K |
| 代理商： | TS5A23166YEPR |
www.ti.com
TS5A23166
0.9-
DUAL SPST ANALOG SWITCH
5-V/3.3-V 2-CHANNEL ANALOG SWITCH
SCDS196–MAY 2005
PIN DESCRIPTION
PIN NUMBER
1
2
3
4
5
6
7
8
NAME
NO1
COM1
IN2
GND
NO2
COM2
IN1
V
+
DESCRIPTION
Normally closed
Common
Digital control pin to connect COM to NO
Digital ground
Normally closed
Common
Digital control pin to connect COM to NO
Power Supply
PARAMETER DESCRIPTION
SYMBOL
V
COM
V
NO
r
on
r
on(flat)
I
NO(OFF)
DESCRIPTION
Voltage at COM
Voltage at NO
Resistance between COM and NO ports when the channel is ON
Difference between the maximum and minimum value of ron in a channel over the specified range of conditions
Leakage current measured at the NO port, with the corresponding channel (NO to COM) in the OFF state
Leakage current measured at the NO port, with the corresponding channel (NO to COM) in the ON state and the output
(COM) open
Leakage current measured at the COM port, with the corresponding channel (COM to NO) in the OFF state
Leakage current measured at the COM port, with the corresponding channel (COM to NO) in the ON state and the output
(NO) open
Minimum input voltage for logic high for the control input (IN)
Maximum input voltage for logic low for the control input (IN)
Voltage at the control input (IN)
Leakage current measured at the control input (IN)
Turn-on time for the switch. This parameter is measured under the specified range of conditions and by the propagation
delay between the digital control (IN) signal and analog output (COM or NO) signal when the switch is turning ON.
Turn-off time for the switch. This parameter is measured under the specified range of conditions and by the propagation
delay between the digital control (IN) signal and analog output (COM or NO) signal when the switch is turning OFF.
Charge injection is a measurement of unwanted signal coupling from the control (IN) input to the analog (NO or COM)
output. This is measured in coulomb (C) and measured by the total charge induced due to switching of the control
input.Charge injection, Q
C
= C
L
×
V
COM
, C
L
is the load capacitance and
V
COM
is the change in analog output voltage.
Capacitance at the NO port when the corresponding channel (NO to COM) is OFF
Capacitance at the NO port when the corresponding channel (NO to COM) is ON
Capacitance at the COM port when the corresponding channel (COM to NO) is OFF
Capacitance at the COM port when the corresponding channel (COM to NO) is ON
Capacitance of IN
OFF isolation of the switch is a measurement of OFF-state switch impedance. This is measured in dB in a specific
frequency, with the corresponding channel (NO to COM) in the OFF state.
Bandwidth of the switch. This is the frequency in which the gain of an ON channel is –3 dB below the DC gain.
Total harmonic distortion is defined as the ratio of the root mean square (RMS) value of the second, third, and higher
harmonics to the magnitude of fundamental harmonic.
Static power-supply current with the control (IN) pin at V
+
or GND
This is the increase in I
+
for each control (IN) input that is at the specified voltage, rather than at V
+
or GND.
I
NO(ON)
I
COM(OFF)
I
COM(ON)
V
IH
V
IL
V
I
I
IH
, I
IL
t
ON
t
OFF
Q
C
C
NO(OFF)
C
NO(ON)
C
COM(OFF)
C
COM(ON)
C
I
O
ISO
BW
THD
I
+
I
+
15
相关PDF资料 |
PDF描述 |
|---|---|
| TS5A23167DCTR | 0.9-W DUAL SPST ANALOG SWITCH 5-V/3.3-V 2-CHANNEL ANALOG SWITCH |
| TS5A23167YEPR | 0.9-W DUAL SPST ANALOG SWITCH 5-V/3.3-V 2-CHANNEL ANALOG SWITCH |
| TS5A3159YEPR | Thermal Magnetic Circuit Breaker; Current Rating:20A; Voltage, DC:125V; No. of Poles:1; Mounting:Panel; Mounting Type:Panel Screw; Trip Time (Seconds):0.7-20 RoHS Compliant: Yes |
| TS5A3159YZPR | Thermal Magnetic Circuit Breaker; Current Rating:50A; Voltage, DC:125V; No. of Poles:1; Mounting:Panel; Mounting Type:Panel Screw; Trip Time (Seconds):0.7-20 RoHS Compliant: Yes |
| TS5A3167YEPR | 0.9 OHM SPST ANALOG SWITCH |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TS5A23166YZPR | 功能描述:模拟开关 IC .9-Ohm Dual SPST 5-V 3.3V 2Ch Anlg Switch RoHS:否 制造商:Texas Instruments 开关数量:2 开关配置:SPDT 开启电阻（最大值）:0.1 Ohms 切换电压（最大）: 开启时间（最大值）: 关闭时间（最大值）: 工作电源电压:2.7 V to 4.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:DSBGA-16 |
| TS5A23166YZTR | 功能描述:模拟开关 IC 0.9-Ohm Dual SPST Analog Switch RoHS:否 制造商:Texas Instruments 开关数量:2 开关配置:SPDT 开启电阻（最大值）:0.1 Ohms 切换电压（最大）: 开启时间（最大值）: 关闭时间（最大值）: 工作电源电压:2.7 V to 4.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:DSBGA-16 |
| TS5A23167 | 制造商:TI 制造商全称:Texas Instruments 功能描述:0.9-W DUAL SPST ANALOG SWITCH 5-V/3.3-V 2-CHANNEL ANALOG SWITCH |
| TS5A23167DCTR | 制造商:TI 制造商全称:Texas Instruments 功能描述:0.9-W DUAL SPST ANALOG SWITCH 5-V/3.3-V 2-CHANNEL ANALOG SWITCH |
| TS5A23167DCUR | 功能描述:模拟开关 IC 0.9-OHM DUAL SPDT ANALOG SWITCH RoHS:否 制造商:Texas Instruments 开关数量:2 开关配置:SPDT 开启电阻（最大值）:0.1 Ohms 切换电压（最大）: 开启时间（最大值）: 关闭时间（最大值）: 工作电源电压:2.7 V to 4.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:DSBGA-16 |
发布紧急采购，3分钟左右您将得到回复。