- 您现在的位置：买卖IC网 > PDF目录150819 > TS5A3166DCKR (TEXAS INSTRUMENTS INC) 1-CHANNEL, SGL POLE SGL THROW SWITCH, PDSO5 PDF资料下载
参数资料
| 型号： | TS5A3166DCKR |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 多路复用及模拟开关 |
| 英文描述： | 1-CHANNEL, SGL POLE SGL THROW SWITCH, PDSO5 |
| 封装： | GREEN, PLASTIC, SC-70, 5 PIN |
| 文件页数： | 5/24页 |
| 文件大小： | 655K |
| 代理商： | TS5A3166DCKR |
TS5A3166
0.9 W SPST ANALOG SWITCH
SCDS186 FEBRUARY 2005
www.ti.com
13
PIN DESCRIPTION
PIN
NUMBER
NAME
DESCRIPTION
1
NO
Normally open
2
COM
Common
3
GND
Digital ground
4
IN
Digital control pin to connect COM to NO
5
V+
Power supply
PARAMETER DESCRIPTION
SYMBOL
DESCRIPTION
VCOM
Voltage at COM
VNO
Voltage at NO
ron
Resistance between COM and NO ports when the channel is ON
rpeak
Peak on-state resistance over a specified voltage range
ron(flat)
Difference between the maximum and minimum value of ron in a channel over the specified range of conditions
INO(OFF)
Leakage current measured at the NO port, with the corresponding channel (NO to COM) in the OFF state under
worst-case input and output conditions
INO(PWROFF)
Leakage current measured at the NO port during the power-down condition, V+ = 0
ICOM(OFF)
Leakage current measured at the COM port, with the corresponding channel (COM to NO) in the OFF state under
worst-case input and output conditions
ICOM(PWROFF)
Leakage current measured at the COM port during the power-down condition, V+ = 0
INO(ON)
Leakage current measured at the NO port, with the corresponding channel (NO to COM) in the ON state and the output
(COM) open
ICOM(ON)
Leakage current measured at the COM port, with the corresponding channel (COM to NO) in the ON state and the output
(NO) open
VIH
Minimum input voltage for logic high for the control input (IN)
VIL
Maximum input voltage for logic low for the control input (IN)
VI
Voltage at the control input (IN)
IIH, IIL
Leakage current measured at the control input (IN)
tON
Turn-on time for the switch. This parameter is measured under the specified range of conditions and by the propagation
delay between the digital control (IN) signal and analog output (COM or NO) signal when the switch is turning ON.
tOFF
Turn-off time for the switch. This parameter is measured under the specified range of conditions and by the propagation
delay between the digital control (IN) signal and analog output (COM or NO) signal when the switch is turning OFF.
QC
Charge injection is a measurement of unwanted signal coupling from the control (IN) input to the analog (NO or COM)
output. This is measured in coulomb (C) and measured by the total charge induced due to switching of the control input.
Charge injection, QC = CL × VCOM, CL is the load capacitance, and VCOM is the change in analog output voltage.
CNO(OFF)
Capacitance at the NO port when the corresponding channel (NO to COM) is OFF
CCOM(OFF)
Capacitance at the COM port when the corresponding channel (COM to NO) is OFF
CNO(ON)
Capacitance at the NO port when the corresponding channel (NO to COM) is ON
CCOM(ON)
Capacitance at the COM port when the corresponding channel (COM to NO) is ON
CI
Capacitance of control input (IN)
OISO
OFF isolation of the switch is a measurement of OFF-state switch impedance. This is measured in dB in a specific
frequency, with the corresponding channel (NO to COM) in the OFF state.
BW
Bandwidth of the switch. This is the frequency at which the gain of an ON channel is 3 dB below the DC gain.
THD
Total harmonic distortion describes the signal distortion caused by the analog switch. This is defined as the ratio of root
mean square (RMS) value of the second, third, and higher harmonic to the absolute magnitude of the fundamental
harmonic.
I+
Static power-supply current with the control (IN) pin at V+ or GND
相关PDF资料 |
PDF描述 |
|---|---|
| TPS3825-33DBVTG4 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO5 |
| TPS5102IDBTRG4 | 3 A DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO30 |
| TPS61032RSARG4 | 4.5 A BATTERY CHARGE CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PQCC16 |
| TPS65023RSB | 3-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC40 |
| TPS659102A1RSLR | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC48 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TS5A3166DCKR | 制造商:Texas Instruments 功能描述:IC ANALOG SWITCH SINGLE SPST SC-70-5 制造商:Texas Instruments 功能描述:IC, ANALOG SWITCH, SINGLE, SPST, SC-70-5 |
| TS5A3166DCKRE4 | 功能描述:模拟开关 IC 1-Ohm SPST 5-V/3.3-V Sng-Ch Analog Switch RoHS:否 制造商:Texas Instruments 开关数量:2 开关配置:SPDT 开启电阻（最大值）:0.1 Ohms 切换电压（最大）: 开启时间（最大值）: 关闭时间（最大值）: 工作电源电压:2.7 V to 4.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:DSBGA-16 |
| TS5A3166DCKRG4 | 功能描述:模拟开关 IC 1O SPST Ana Sw RoHS:否 制造商:Texas Instruments 开关数量:2 开关配置:SPDT 开启电阻（最大值）:0.1 Ohms 切换电压（最大）: 开启时间（最大值）: 关闭时间（最大值）: 工作电源电压:2.7 V to 4.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:DSBGA-16 |
| TS5A3166QDCKRQ1 | 功能描述:1 Circuit IC Switch 1:1 900 mOhm SC-70-5 制造商:texas instruments 系列:汽车级，AEC-Q100 包装:剪切带（CT） 零件状态:有效 开关电路:SPST - 常开 多路复用器/解复用器电路:1:1 电路数:1 导通电阻（最大值）:900 毫欧 通道至通道匹配（ΔRon）:- 电压 -?电源，单（V+）:1.65 V ~ 5.5 V 电压 - 电源，双（V±）:- 开关时间（Ton, Tof）（最大值）:7ns，11.5ns -3db 带宽:200MHz 电荷注入:1pC 沟道电容 （CS(off），CD（off））:19pF，18pF 电流 - 漏泄（IS（off））（最大值）:80nA 串扰:- 工作温度:-40°C ~ 125°C（TA） 封装/外壳:5-TSSOP，SC-70-5，SOT-353 供应商器件封装:SC-70-5 标准包装:1 |
| TS5A3166YZPR | 功能描述:模拟开关 IC 1-Ohm SPST 5-V/3.3-V Sng-Ch Analog Switch RoHS:否 制造商:Texas Instruments 开关数量:2 开关配置:SPDT 开启电阻（最大值）:0.1 Ohms 切换电压（最大）: 开启时间（最大值）: 关闭时间（最大值）: 工作电源电压:2.7 V to 4.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:DSBGA-16 |
发布紧急采购，3分钟左右您将得到回复。