参数资料
型号: TSC80251G2D-24IBR
厂商: Atmel
文件页数: 37/77页
文件大小: 0K
描述: IC MCU 8BIT 24MHZ HI SPD 44-PLCC
标准包装: 500
系列: 8x251
核心处理器: C251
芯体尺寸: 8/16-位
速度: 24MHz
连通性: EBI/EMI,I²C,Microwire,SPI,UART/USART
外围设备: POR,PWM,WDT
输入/输出数: 32
程序存储器类型: ROMless
RAM 容量: 1K x 8
电压 - 电源 (Vcc/Vdd): 4.5 V ~ 5.5 V
振荡器型: 内部
工作温度: -40°C ~ 85°C
封装/外壳: 44-LCC(J 形引线)
包装: 带卷 (TR)
42
AT/TSC8x251G2D
4135F–8051–11/06
To preserve the secrecy of the encryption key byte sequence, the Encryption Array can
not be verified.
Notes: 1. When a MOVC instruction is executed, the content of the ROM is not encrypted. In
order to fully protect the user program code, the lock bit level 1 (see Table 33) must
always be set when encryption is used.
2. If the encryption feature is implemented, the portion of the on-chip code memory that
does not contain program code should be filled with “random” byte values to prevent
the encryption key sequence from being revealed.
Signature Bytes
The TSC80251G2D derivatives contain factory-programmed Signature Bytes. These
bytes are located in non-volatile memory outside the memory address space at 30h,
31h, 60h and 61h. To read the Signature Bytes, perform the procedure described in sec-
tion Verify Algorithm, using the verify signature mode (see Table 37). Signature byte
values are listed in Table 35.
Table 35.
Signature Bytes (Electronic ID)
Programming Algorithm
Figure 6 shows the hardware setup needed to program the TSC87251G2D
EPROM/OTPROM areas:
The chip has to be put under reset and maintained in this state until completion of
the programming sequence.
PSEN# and the other control signals (ALE and Port 0) have to be set to a high level.
Then PSEN# has to be to forced to a low level after two clock cycles or more and it
has to be maintained in this state until the completion of the programming sequence
(see below).
The voltage on the EA# pin must be set to VDD.
The programming mode is selected according to the code applied on Port 0 (see
Table 36). It has to be applied until the completion of this programming operation.
The programming address is applied on Ports 1 and 3 which are respectively the
Most Significant Byte (MSB) and the Least Significant Byte (LSB) of the address.
The programming data are applied on Port 2.
The EPROM Programming is done by raising the voltage on the EA# pin to VPP,
then by generating a low level pulse on ALE/PROG# pin.
The voltage on the EA# pin must be lowered to VDD before completing the
programming operation.
It is possible to alternate programming and verifying operation (See Paragraph
Verify Algorithm). Please make sure the voltage on the EA# pin has actually been
lowered to VDD before performing the verifying operation.
Signature Address
Signature Data
Vendor
Atmel
30h
58h
Architecture
C251
31h
40h
Memory
32 kilobytes EPROM or
OTPROM
60h
F7h
32 kilobytes MaskROM
or ROMless
77h
Revision
TSC80251G2D
derivative
61h
FDh
相关PDF资料
PDF描述
PIC16C56-HS/P IC MCU OTP 1KX12 18DIP
PIC16C72A-04I/SP IC MCU OTP 2KX14 A/D PWM 28DIP
PIC16C63A-20/SP IC MCU OTP 4KX14 PWM 28DIP
PIC16C63A-20/SO IC MCU OTP 4KX14 PWM 28SOIC
PIC16LF871-I/P IC PIC MCU FLASH 2KX14 40DIP
相关代理商/技术参数
参数描述
TSC80251G2DL16CB 制造商:Atmel Corporation 功能描述:
TSC80251G2D-L16CB 功能描述:IC MCU 8BIT 16MHZ LO VOLT 44PLCC RoHS:否 类别:集成电路 (IC) >> 嵌入式 - 微控制器, 系列:8x251 标准包装:9 系列:87C 核心处理器:8051 芯体尺寸:8-位 速度:40/20MHz 连通性:UART/USART 外围设备:POR,WDT 输入/输出数:32 程序存储器容量:32KB(32K x 8) 程序存储器类型:OTP EEPROM 大小:- RAM 容量:256 x 8 电压 - 电源 (Vcc/Vdd):4.5 V ~ 5.5 V 数据转换器:- 振荡器型:内部 工作温度:0°C ~ 70°C 封装/外壳:40-DIP(0.600",15.24mm) 包装:管件
TSC80251G2D-L16CBR 功能描述:IC MCU 8BIT 16MHZ LO VOLT 44PLCC RoHS:否 类别:集成电路 (IC) >> 嵌入式 - 微控制器, 系列:8x251 标准包装:1,500 系列:AVR® ATtiny 核心处理器:AVR 芯体尺寸:8-位 速度:16MHz 连通性:I²C,LIN,SPI,UART/USART,USI 外围设备:欠压检测/复位,POR,PWM,温度传感器,WDT 输入/输出数:16 程序存储器容量:8KB(4K x 16) 程序存储器类型:闪存 EEPROM 大小:512 x 8 RAM 容量:512 x 8 电压 - 电源 (Vcc/Vdd):2.7 V ~ 5.5 V 数据转换器:A/D 11x10b 振荡器型:内部 工作温度:-40°C ~ 125°C 封装/外壳:20-SOIC(0.295",7.50mm 宽) 包装:带卷 (TR)
TSC80251G2D-L16CE 功能描述:IC MCU 8BIT 16MHZ LO VOLT 44VQFP RoHS:否 类别:集成电路 (IC) >> 嵌入式 - 微控制器, 系列:8x251 标准包装:9 系列:87C 核心处理器:8051 芯体尺寸:8-位 速度:40/20MHz 连通性:UART/USART 外围设备:POR,WDT 输入/输出数:32 程序存储器容量:32KB(32K x 8) 程序存储器类型:OTP EEPROM 大小:- RAM 容量:256 x 8 电压 - 电源 (Vcc/Vdd):4.5 V ~ 5.5 V 数据转换器:- 振荡器型:内部 工作温度:0°C ~ 70°C 封装/外壳:40-DIP(0.600",15.24mm) 包装:管件
TSC80251G2D-L16CED 制造商:Atmel Corporation 功能描述:MCU 8-Bit/16-Bit 8x251 C251 CISC ROMLess 3.3V/5V 44-Pin VQFP