- 您现在的位置：买卖IC网 > PDF目录136905 > TSC80C31-20CHR (ATMEL CORP) 8-BIT, 20 MHz, MICROCONTROLLER, CQCC44 PDF资料下载
参数资料
| 型号： | TSC80C31-20CHR |
| 厂商： | ATMEL CORP |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 8-BIT, 20 MHz, MICROCONTROLLER, CQCC44 |
| 封装： | LCC-44 |
| 文件页数： | 39/143页 |
| 文件大小： | 4602K |
| 代理商： | TSC80C31-20CHR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页当前第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页第122页第123页第124页第125页第126页第127页第128页第129页第130页第131页第132页第133页第134页第135页第136页第137页第138页第139页第140页第141页第142页第143页
133
XMEGA A3BU [DATASHEET]
8362F–AVR–02/2013
39.
Errata
39.1
ATxmega256A3BU
39.1.1 Rev. G
AWeX fault protection restore is not done correct in Pattern Generation Mode
1.
AWeX fault protection restore is not done correctly in Pattern Generation Mode
When a fault is detected the OUTOVEN register is cleared, and when fault condition is cleared, OUTOVEN is
restored according to the corresponding enabled DTI channels. For Common Waveform Channel Mode (CWCM),
this has no effect as the OUTOVEN is correct after restoring from fault. For Pattern Generation Mode (PGM),
OUTOVEN should instead have been restored according to the DTILSBUF register.
Problem fix/Workaround
For CWCM no workaround is required.
For PGM in latched mode, disable the DTI channels before returning from the fault condition. Then, set correct
OUTOVEN value and enable the DTI channels, before the direction (DIR) register is written to enable the correct
outputs again.
For PGM in cycle-by-cycle mode there is no workaround.
39.1.2 Rev. E-F
Not sampled
39.1.3 rev. D
ADC unsigned mode non-functional
ADC increased noise when using internal 1.0V reference at low temperature
DAC offset calibration range too small when using AVCC as reference
Register ANAINIT in MCUR will always read as zero
CPU clock frequency limited to 24MHz
CPU clock frequency limited to 20MHz if using both application section and boot section
High active current consumption at low frequency
USB Transfer Complete interrupt generated for each IN packet in Multipacket Mode
Disabling the USART transmitter does not automatically set the TxD pin direction to input
AWeX PWM output after fault restarted with wrong values
TWI inactive bus timeout from BUSY bus state
TOSC32 as RTC32 clock output Non-functional
Pending asynchronous RTC32 interrupts will not wake up device
Pending full asynchronous pin change interrupts will not wake the device
1.
ADC Unsigned mode non-functional
The ADC Unsigned mode is non-functional.
Problem fix/Workaround
相关PDF资料 |
PDF描述 |
|---|---|
| TSC80C31-25IBB | 8-BIT, 25 MHz, MICROCONTROLLER, PQCC44 |
| TSC80C31-L16IBD | 8-BIT, 16 MHz, MICROCONTROLLER, PQCC44 |
| TSC80C51CXXX-20CID | 8-BIT, MROM, 20 MHz, MICROCONTROLLER, CQCC44 |
| TSC80C51CXXX-36CIR | 8-BIT, MROM, 36 MHz, MICROCONTROLLER, CQCC44 |
| TSC80C51CXXX-L16IHR | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CQCC44 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TSC80C31-20CHR/883 | 制造商:TEMIC 制造商全称:TEMIC Semiconductors 功能描述:CMOS 0 to 44 MHz Single-Chip 8 Bit Microcontroller |
| TSC80C31-20CI | 制造商:TEMIC 制造商全称:TEMIC Semiconductors 功能描述:CMOS 0 to 44 MHz Single-Chip 8 Bit Microcontroller |
| TSC80C31-20CIB/883 | 制造商:TEMIC 制造商全称:TEMIC Semiconductors 功能描述:CMOS 0 to 44 MHz Single-Chip 8 Bit Microcontroller |
| TSC80C31-20CID/883 | 制造商:TEMIC 制造商全称:TEMIC Semiconductors 功能描述:CMOS 0 to 44 MHz Single-Chip 8 Bit Microcontroller |
| TSC80C31-20CIR/883 | 制造商:TEMIC 制造商全称:TEMIC Semiconductors 功能描述:CMOS 0 to 44 MHz Single-Chip 8 Bit Microcontroller |
发布紧急采购，3分钟左右您将得到回复。