- 您现在的位置：买卖IC网 > Datasheet目录57 > TSL2014 (AMS-TAOS USA Inc)IC LINEAR SENSOR ARRAY 896X1 Datasheet资料下载
参数资料
| 型号： | TSL2014 |
| 厂商： | AMS-TAOS USA Inc |
| 文件页数： | 3/11页 |
| 文件大小： | 592K |
| 描述： | IC LINEAR SENSOR ARRAY 896X1 |
| 标准包装： | 30 |
| 系列： | * |
TSL2014
896 y 1 LINEAR SENSOR ARRAY
TAOS040C AUGUST 2011
2
r
r
Copyright E 2011, TAOS Inc.
The LUMENOLOGY r Company
www.taosinc.com
Terminal Functions
TERMINAL
NAME
NO.
I/O
DESCRIPTION
AO1
3
O
Analog output of section 1.
AO2
8
O
Analog output of section 2.
CLK
6
I
Clock. The clock controls the charge transfer, pixel output and reset.
GND
7
Ground (substrate). All voltages are referenced to GND.
SI1
2
I
Serial input (section 1). SI1 defines the start of the data-out sequence.
SI2
5
I
Serial input (section 2). SI2 defines the start of the data-out sequence.
SO1
4
O
Serial output (section 1). SO1 signals the end of the data out sequence and provides a signal to drive the input
of section 2 (SI2) in serial mode.
SO2
9
O
Serial output (section 2). SO2 signals the end of the data out sequence and provides a signal to drive the input
of another device for cascading.
VDD
1, 10
Supply voltage. Supply voltage for both analog and digital circuits.
Detailed Description
The sensor consists of 896 photodiodes arranged in a linear array. Light energy impinging on a photodiode
generates photocurrent, which is integrated by the active integration circuitry associated with that pixel. During
the integration period, a sampling capacitor connects to the output of the integrator through an analog switch.
The amount of charge accumulated at each pixel is directly proportional to the light intensity and the integration
time. The integration time is the interval between two consecutive output periods.
The output and reset of the integrators is controlled by two 448-bit shift registers and reset logic. A 448-pixel
output cycle is initiated by clocking in a logic 1 into the SI input of a section for one positive going clock edge
(see Figures1 and 2)
. The two 448-pixel sections may be operated independently using a single clock input
or connected in series to form a 896-pixel array. Each section has an independent output (AO), which may be
connected together for the 896-pixel function.
When operating in the 896-pixel mode, as the SI pulse is clocked through the 896-bit shift register, the charge
on the sampling capacitor of each pixel is sequentially connected to a charge-coupled output amplifier that
generates a voltage output, AO. When the bit position goes low, the pixel integrator is reset. On the 897
th
clock
rising edge, the SI pulse is clocked out of the shift register (S2) and the output assumes a high-impedance state.
Note that this 897
th
clock pulse is required to terminate the output of the 896
th
pixel and return the internal logic
to a known state. A subsequent SI pulse can be presented as early as the 898
th
clock pulse, thereby initiating
another pixel output cycle.
The voltage developed at analog output (AO) is given by:
V
out
= V
drk
+ (R
e
) (E
e
) (t
int
)
where:
V
out
is the analog output voltage for white condition
V
drk
is the analog output voltage for dark condition
R
e
is the device responsivity for a given wavelength of light given in V/(糐/cm
2
)
E
e
is the incident irradiance in 糤/cm
2
t
int
is integration time in seconds
AO is driven by a source follower that requires an external pulldown resistor (330-?typical). The output is
nominally 0 V for no light input, 2 V for normal white-level, and 3.4 V for saturation light level. When the device
is not in the output phase, AO is in a high impedance state.
A 0.1 糉 bypass capacitor should be connected between V
DD
and ground as close as possible to the device.
For proper operation, after meeting the minimum hold time condition, SI must go low before the next rising edge of the clock.
相关PDF资料 |
PDF描述 |
|---|---|
| TSL202R | IC LINEAR SENSOR ARRAY 128X1 |
| TSL208R | IC LINEAR SENSOR ARRAY 512X1 |
| TSL210 | IC LINEAR SENSOR ARRAY 640X1 |
| TSL230BRD-TR | IC LIGHT TO FREQUENCY CONV 8SOIC |
| TSL235RSM-LF | IC LIGHT TO FREQUENCY CONV 3SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TSL201CL | 制造商:TAOS Inc 功能描述:IC LINEAR SENSOR ARRAY 64X1 |
| TSL201CL-LF | 制造商:AMS 功能描述:Linear Sensor Array |
| TSL201R | 功能描述:光频率和光电压 Linear Sensor Array 200dpi 64pix RoHS:否 制造商:ams 峰值波长:1000 nm 工作电源电压:5 V 最大工作温度:+ 85 C 最小工作温度:- 25 C 安装风格: 封装 / 箱体: |
| TSL201RLF | 制造商:TAOS Inc 功能描述:IC LINEAR SENSOR ARRAY CL |
| TSL201-R-LF | 功能描述:IC LIGHT SENSOR ARRAY 8-DIP RoHS:是 类别:传感器，转换器 >> 专用 系列:* 标准包装:40 系列:* |
发布紧急采购，3分钟左右您将得到回复。