参数资料
型号: UBA2037TS/N1,118
厂商: NXP Semiconductors
文件页数: 5/14页
文件大小: 0K
描述: IC DVR FULL BRIDGE 28-SSOP
标准包装: 1,000
类型: HID 灯控制器
频率: 100kHz
电流 - 电源: 500µA
电流 - 输出: 200mA
电源电压: 10.5 V ~ 13.5 V
工作温度: -40°C ~ 125°C
封装/外壳: 28-SSOP(0.209",5.30mm 宽)
供应商设备封装: 28-SSOP
包装: 带卷 (TR)
其它名称: 935284482118
NXP Semiconductors
UBA2037
Full bridge control IC for HID general lighting
Table 3. Driver
Gate driver output voltages as function of the logical levels at the pins BD, SU, DD and CLK.
Device
BD
SU
DD
CLK
GHL
GHR
GLL
GLR
state
Start-up
state
1
0
-
-
-
-
-
-
0 (= V SHL )
0 (= V SHL )
0 (= V SHR )
0 (= V SHR )
0 (= V PGND)
1 (= V VDD )
0 (= V PGND )
1 (= V VDD )
Oscillation
1
-
-
-
0 (= V SHL )
0 (= V SHR )
0 (= V PGND ) 0 (= V PGND )
state
0
0
0
1
-
1
-
1
0 (= V SHL )
0 (= V SHL )
0 (= V SHR )
1 (= V FSR )
1 (= V VDD )
1 (= V VDD )
1 (= V VDD )
0 (= V PGND )
0
1
1
0
1 (= V FSL )
0 (= V SHR )
0 (= V PGND ) 1 (= V VDD )
0
1
0 [1]
1 →
0 [2]
GHL
GHR
GLL
GLR
[1]
[2]
If pin DD = 0 the bridge enters the state (oscillation state and pin BD = 0 and pin SU = 1) in the prede?ned
position: V GHL = V FSL , V GLR = V VDD , V GLL = V PGND , and V GHR = V SHR .
Only if the level of pin CLK changes from logical 1 to 0, the level of outputs GHL, GHR, GLL and GLR
changes.
If there is no external clock available, the internal oscillator can be used. The design
equation for the bridge oscillator frequency is shown in Equation 1 .
K osc × R osc × C osc
1
f bridge = ---------------------------------------------
(1)
R osc and C osc are external components connected to the RC pin (R osc connected to pin
VDD and C osc connected to pin SGND). In this situation the pins V DD(CLK) , CLK and
V SS(CLK ) can be connected to SGND.
The clock signal, coming from either pin RC or pin CLK, can be divided by two in order to
obtain a 50 % duty-cycle gate drive signal. This can be achieved by applying a voltage to
the DD input lower than V IL(DD) (e.g. connect pin DD to pin SGND).
7.4 Non-overlap time
In the full bridge con?guration the non-overlap time is de?ned as the time between turning
off the two conducting MOSFETs and turning on the two other MOSFETs. The
non-overlap time is realized by means of an adaptive non overlap circuit. With an adaptive
non-overlap, the application determines the duration of the non overlap and makes the
non-overlap time optimal for each frequency. The non-overlap time is determined by the
duration of the falling slope of the relevant half bridge voltage. The occurrence of a slope
is sensed internally. The minimum non-overlap time is internally ?xed.
7.5 Start-up delay
A simple RC ?lter (R between pin VDD and pin SU; C between pin SU and pin SGND) or
a control signal from a processor can be used to make a start-up delay. This can be
bene?cial for those applications in which building up the high voltage takes a larger
amount of time: A start-up delay will ensure that the HID system will not start up before
this high voltage has been reached.
UBA2037_1
? NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 01 — 30 October 2008
5 of 14
相关PDF资料
PDF描述
UBA2070T/N1,518 IC CCFL DRIVER 16-SOIC
UBA2071ATS/N1,118 IC DVR HALF BRIDGE 24-SSOP
UC3843ANG IC REG CTRLR FLYBK ISO PWM 8-DIP
UC3844BVD1R2G IC REG CTRLR PWM CM 8-SOIC
UC3845NG IC REG CTRLR PWM CM 8-DIP
相关代理商/技术参数
参数描述
UBA2040U/N3,025 功能描述:功率驱动器IC UBA2040U/UNCASED/JAR RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
UBA2050 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:One-chip telephone ICs with speech, dialler and ringer functions
UBA2050A 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:One-chip telephone ICs with speech, dialler and ringer functions
UBA2050AT 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:One-chip telephone ICs with speech, dialler and ringer functions
UBA2050T 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:One-chip telephone ICs with speech, dialler and ringer functions