参数资料
| 型号： | UCC2892D |
| 厂商： | Texas Instruments |
| 文件页数： | 12/41页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR FLYBK ISO CM 16SOIC |
| 标准包装： | 40 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 1MHz |
| 占空比： | 74% |
| 电源电压： | 8.5 V ~ 16 V |
| 降压： | 无 |
| 升压： | 无 |
| 回扫： | 是 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 16-SOIC（0.154"，3.90mm 宽） |
| 包装： | 管件 |
| 其它名称： | 296-15884-5 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页当前第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页
UCC2891, UCC2892
UCC2893, UCC2894
SLUS542F ? OCTOBER 2003 ? REVISED JULY 2009
DETAILED PIN DESCRIPTIONS (continued)
VIN (pin 16 ? UCC2891 and UCC2893 only)
The UCC2891 and UCC2893 controllers are equipped with a high voltage, P-channel JFET start up device to
initiate operation from the input power source of the converter in applications where the input voltage does not
exceed the 110-V maximum rating of the start up transistor. In these applications, the VIN pin can be connected
directly to the positive terminal of the input power source. The internal JFET start up transistor provides
approximately 15-mA charge current for the energy storage capacitor (C BIAS ) connected across the VDD (pin
14) and PGND (pin 11) terminals. Note that the start up device is turned off immediately when the voltage on
the VDD pin exceeds approximately 13.5 V, the controller ’s undervoltage lockout threshold for turn-on. The
JFET is also disabled at all times when the high-current gate drivers are switching to protect against excessive
power dissipation and current through the device. When using the internal JFET for startup, the external load
on VDD must be limited to less than 4 mA.
For more information on biasing the UCC2891 family, refer to the Setup Guide and Additional Application
Information Sections of this datasheet.
LINEOV (pin 16 ? UCC2892 and UCC2894 only)
In the UCC2892 and UCC2894 controllers the high-voltage start-up device is not utilized thus pin 16 is used
for a different function. This input monitors the incoming power source to provide an accurate overvoltage
protection with user programmable hysteresis for the power supply controlled by the controller. The circuit
implementation of the overvoltage protection function is identical to the technique used for monitoring the input
power rail for undervoltage lockout. This allows implementing an accurate threshold and hysteresis using only
one pin. The input voltage of the power supply is scaled to the precise 1.27-V threshold of the overvoltage
protection comparator by an external resistor divider (R IN3 , R IN4 in Figure 7). Once the line monitor ’s input
threshold is exceeded, an internal current source gets connected to the LINEOV pin. The current generator is
programmed by the R DEL resistor connected to pin 1 of the controller. The actual current level is given as:
I HYST +
V REF
2
1
R DEL
0.05
(8)
As this current flows through R IN4 of the input divider, the overvoltage protection hysteresis is a function of I HYST
and R IN4 allowing accurate programming of the hysteresis of the line monitoring circuit.
For more information on how to program the overvoltage protection, refer to the Setup Guide of this datasheet.
12
www.ti.com
相关PDF资料 |
PDF描述 |
|---|---|
| AHA106M63E16B-F | CAP ALUM 10UF 63V 20% SMD |
| ACC22DRYN-S13 | CONN EDGECARD 44POS .100 EXTEND |
| SXR680M050ST | CAP ALUM 68UF 50V 20% RADIAL |
| SXR471M010ST | CAP ALUM 470UF 10V 20% RADIAL |
| ACC22DRYH-S13 | CONN EDGECARD 44POS .100 EXTEND |
相关代理商/技术参数 |
参数描述 |
|---|---|
| UCC2892DG4 | 功能描述:电流型 PWM 控制器 UCC289x Current Mode Active Clamp RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| UCC2892DR | 功能描述:电流型 PWM 控制器 UCC289x Current Mode Active Clamp RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| UCC2892DRG4 | 功能描述:电流型 PWM 控制器 UCC289x Current Mode Active Clamp RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| UCC2892PW | 功能描述:电流型 PWM 控制器 UCC289x Current Mode Active Clamp RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| UCC2892PWG4 | 功能描述:电流型 PWM 控制器 UCC289x Current Mode Active Clamp RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
发布紧急采购，3分钟左右您将得到回复。