- 您现在的位置：买卖IC网 > PDF目录199556 > UCC35706DTR (TEXAS INSTRUMENTS INC) 0.02 A SWITCHING CONTROLLER, 4000 kHz SWITCHING FREQ-MAX, PDSO8 PDF资料下载
参数资料
| 型号： | UCC35706DTR |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | 0.02 A SWITCHING CONTROLLER, 4000 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封装： | GREEN, PLASTIC, MS-012AA, SOP-8 |
| 文件页数： | 16/21页 |
| 文件大小： | 604K |
| 代理商： | UCC35706DTR |
UCC25705, UCC25706, UCC35705, UCC35706
HIGH-SPEED VOLTAGE MODE PULSE WIDTH MODULATOR
SLUS473B -- NOVEMBER 1999 -- REVISED OCTOBER 2010
4
www.ti.com
pin descriptions
DISCH: A resistor to VIN sets the oscillator discharge current programming a maximum duty cycle. When grounded,
an internal comparator switches the oscillator to a quick discharge mode. A small 100-pF capacitor between DISCH
and GND may reduce oscillator jitter without impacting feed-forward performance. IDISCH must be between 25 μA
and 250 μA over the entire VIN range.
FB: Input to the PWM comparator. This pin is intended to interface with an optocoupler. Input impedance is 50-k
typical.
GND: Ground return pin.
ILIM: Provides a pulse-by-pulse current limit by terminating the PWM pulse when the input is above 200 mV. This
provides a high speed (25 ns typical) path to reset the PWM latch, allowing for a pulse-by-pulse current limit.
OUT: The output is intended to drive an external FET driver or other high impedance circuits, but is not intended to
directly drive a power MOSFET. This improves the controller’s noise immunity. The output resistance of the PWM
controller, typically 60 pull-up and 30 pull-down, will result in excessive rise and fall times if a power MOSFET
is directly driven at the speeds for which the UCC35705/6 is optimized.
RC: The oscillator can be configured to provide a maximum duty cycle clamp. In this mode the on--time is set by RT
and CT, while the off-time is set by RDISCH and CT. Since the voltage ramp on CT is proportional to VIN, feed-forward
action is obtained. Since the peak oscillator voltage is also proportional to VIN, constant frequency operation is
maintained over the full power supply input range. When the DISCH pin is grounded, the duty cycle clamp is disabled.
The RC pin then provides a low impedance path to ground CT during the off time.
VDD: Power supply pin. This pin should be bypassed with a 0.1-μF capacitor for proper operation. The undervoltage
lockout function of the UCC35705/6 allows for a low current startup mode and ensures that all circuits become active
in a known state. The UVLO thresholds on the UCC35705 are appropriate for a dc-to-dc converter application. The
wider UVLO hysteresis of the UCC35706 (typically 4 V) is optimized for a bootstrap startup mode from a high
impedance source.
VFF: The feed-forward pin provides the controller with a voltage proportional to the power supply input voltage. When
the oscillator is providing a duty cycle clamp, a current of 2 × IDISCH is sourced from the VFF pin. A single resistor
RFF between VFF and GND then set VFF to:
VFF ≈ VIN ×
2×RFF
2 × RFF + RDISCH
When the DISCH pin is grounded and the duty cycle clamp is not used, the internal current source is disabled and
a resistor divider from VIN is used to set VFF. In either case, when the voltage on VFF is less than 1.0 V, both the
output and oscillator are disabled.
相关PDF资料 |
PDF描述 |
|---|---|
| UCC3825ADW | 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| UCK4-TDY | 4-OUTPUT 600 W AC-DC PWR FACTOR CORR MODULE |
| UDA1330ATS/N2,112 | Low-cost stereo filter DAC; Package: SOT369-1 (SSOP16); Container: Tube |
| UDA1330ATS/N2,118 | Low-cost stereo filter DAC; Package: SOT369-1 (SSOP16); Container: Reel Pack, SMD, 13" |
| UDA1334ATS/N2,112 | Low power audio DAC with PLL; Package: SOT369-1 (SSOP16); Container: Tube |
相关代理商/技术参数 |
参数描述 |
|---|---|
| UCC35706DTRG4 | 功能描述:电压模式 PWM 控制器 High Speed Vltg Mode RoHS:否 制造商:Texas Instruments 输出端数量:1 拓扑结构:Buck 输出电压:34 V 输出电流: 开关频率: 工作电源电压:4.5 V to 5.5 V 电源电流:600 uA 最大工作温度:+ 125 C 最小工作温度:- 40 C 封装 / 箱体:WSON-8 封装:Reel |
| UCC35706P | 功能描述:电压模式 PWM 控制器 High Speed Vltg Mode RoHS:否 制造商:Texas Instruments 输出端数量:1 拓扑结构:Buck 输出电压:34 V 输出电流: 开关频率: 工作电源电压:4.5 V to 5.5 V 电源电流:600 uA 最大工作温度:+ 125 C 最小工作温度:- 40 C 封装 / 箱体:WSON-8 封装:Reel |
| UCC35706PG4 | 功能描述:电压模式 PWM 控制器 High Speed Vltg Mode RoHS:否 制造商:Texas Instruments 输出端数量:1 拓扑结构:Buck 输出电压:34 V 输出电流: 开关频率: 工作电源电压:4.5 V to 5.5 V 电源电流:600 uA 最大工作温度:+ 125 C 最小工作温度:- 40 C 封装 / 箱体:WSON-8 封装:Reel |
| UCC3570D | 功能描述:电压模式 PWM 控制器 Lo Pwr PWM RoHS:否 制造商:Texas Instruments 输出端数量:1 拓扑结构:Buck 输出电压:34 V 输出电流: 开关频率: 工作电源电压:4.5 V to 5.5 V 电源电流:600 uA 最大工作温度:+ 125 C 最小工作温度:- 40 C 封装 / 箱体:WSON-8 封装:Reel |
| UCC3570DG4 | 功能描述:电压模式 PWM 控制器 Lo Pwr PWM RoHS:否 制造商:Texas Instruments 输出端数量:1 拓扑结构:Buck 输出电压:34 V 输出电流: 开关频率: 工作电源电压:4.5 V to 5.5 V 电源电流:600 uA 最大工作温度:+ 125 C 最小工作温度:- 40 C 封装 / 箱体:WSON-8 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。