- 您现在的位置：买卖IC网 > PDF目录382721 > UDA1351H (NXP SEMICONDUCTORS) 96 kHz IEC 958 audio DAC PDF资料下载
参数资料
| 型号： | UDA1351H |
| 厂商： | NXP SEMICONDUCTORS |
| 元件分类： | 消费家电 |
| 英文描述： | 96 kHz IEC 958 audio DAC |
| 中文描述： | SPECIALTY CONSUMER CIRCUIT, PQFP44 |
| 封装： | PLASTIC, QFP-44 |
| 文件页数： | 10/36页 |
| 文件大小： | 157K |
| 代理商： | UDA1351H |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
2000 Feb 18
10
Philips Semiconductors
Preliminary specification
96 kHz IEC 958 audio DAC
UDA1351H
8.2
Clock regeneration and lock detection
The UDA1351H contains an on-board PLL for
regenerating a system clock from the IEC 958 input
bitstream or the incoming digital data stream via the data
input interface. In addition to the system clock for the
on-board digital sound processing the PLL also generates
a 256f
s
clock output for use in the application. In the
absence of an input signal the clock will generate a
minimum frequency to warrant system functionality.
Note
: in case of no input signal, the PLL generates a
minimum frequency and the output spectrum shifts
accordingly. Since the analog output does not have a
analog mute, this means noise which is out of band noise
under normal operation conditions, can move into the
audio band.
When the on-board clock has locked to the incoming
frequency the lock indicator bit will be set and can be read
via the L3 interface. Internally the PLL lock indication is
combined with the PCM status bit of the input data stream.
When both the IEC 958 decoder and the on-board clock
have locked to the incoming signal and the input data
stream is PCM data, then pin LOCK will be asserted.
However, when the IC is locked but the PCM status bit
reports non-PCM data then pin LOCK is returned to LOW
level.
The lock indication output can be used, for example, for
muting purposes. The lock signal can be used to drive an
external analog muting circuit to prevent out of band noise
to become audible in case the PLL runs at its minimum
frequency (e.g. when there is no SPDIF input signal).
8.3
Mute
The UDA1351H is equipped with a cosine roll-off mute in
the DSP data path of the DAC part. Muting the DAC, by
pin MUTE (in static mode) or via bit MT (in L3 mode) will
result in a soft mute as presented in Fig.3. The cosine
roll-off soft mute takes 32
×
32 samples = 24 ms at a
sampling frequency of 44.1 kHz.
When operating in the L3 control mode the device will
mute on start-up. In L3 mode it is necessary to explicitly
switch off the mute for audio output by means of the MT bit
in the L3 register.
In the L3 mode pin MUTE does not have any function (the
same holds for several other pins) and can either be left
open-circuit (since it has an internal pull-down resistor) or
be connected to ground.
handbook, halfpage
mute
factor
0
1
3
0
0.8
MGS755
2
0.6
0.4
0.2
t (ms)
Fig.3 Mute as a function of raised cosine roll-off.
相关PDF资料 |
PDF描述 |
|---|---|
| UDA1351TS | 96 kHz IEC 958 audio DAC |
| UDA1352HL | 48 kHz IEC 60958 audio DAC |
| UDA1360 | Low-voltage low-power stereo audio ADC |
| UDA1360TS | Low-voltage low-power stereo audio ADC |
| UDA1361 | 96 kHz sampling 24-bit stereo audio ADC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| UDA1351H/N1,551 | 功能描述:数模转换器- DAC 96 KHZ SPDIF DAC RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| UDA1351H/N1,557 | 功能描述:数模转换器- DAC 96 KHZ SPDIF DAC RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| UDA1351TS | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:96 kHz IEC 958 audio DAC |
| UDA1351TS/N1,512 | 功能描述:数模转换器- DAC 96KHZ SPDIF DAC RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| UDA1351TS/N1,518 | 功能描述:音频数/模转换器 IC 96KHZ SPDIF DAC RoHS:否 制造商:Texas Instruments 转换器数量: 分辨率:16 bit 接口类型:I2S, UBS 转换速率: 信噪比:98 dB 工作电源电压:5 V DAC 输出端数量:2 工作温度范围:- 25 C to + 85 C 电源电流:23 mA 安装风格:SMD/SMT 封装 / 箱体:TQFP-32 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。