- 您现在的位置：买卖IC网 > Datasheet目录887 > ULT-5/5-D48P-C (Murata Power Solutions Inc)DC/DC CONVERTER 5V 5A 25W BRICK Datasheet资料下载
参数资料
| 型号： | ULT-5/5-D48P-C |
| 厂商： | Murata Power Solutions Inc |
| 文件页数： | 5/26页 |
| 文件大小： | 0K |
| 描述： | DC/DC CONVERTER 5V 5A 25W BRICK |
| 标准包装： | 98 |
| 系列： | ULT |
| 类型： | 隔离 |
| 输出数： | 1 |
| 电压 - 输入（最小）： | 36V |
| 电压 - 输入（最大）： | 75V |
| Voltage - Output 1： | 5V |
| 电流 - 输出（最大）： | 5A |
| 电源（瓦） - 制造商系列： | 25W |
| 电压 - 隔离： | 1.5kV（1500V） |
| 特点： | 具有远程开/关功能和 UVLO |
| 安装类型： | 通孔 |
| 封装/外壳： | 8-DIP 模块，1/32 砖 |
| 尺寸/尺寸： | 0.92" L x 0.75" W x 0.35" H（23.4mm x 19.1mm x 8.9mm） |
| 包装： | 托盘 |
| 工作温度： | -40°C ~ 85°C |
| 效率： | 89% |
| 电源（瓦特）- 最大： | 25W |
| 其它名称： | 811-2335 |
ULT Series
Thirty-Second-Brick Isolated DC/DC Converters
with 2:1 Wide Input Range
Performance Speci?cation Notes
? All speci?cations are typical unless noted. Ambient temperature =
+25°Celsius, V IN is nominal, output current is maximum rated nominal.
External output capacitance consists of 400μF capacitors across output
pins; one 33μF low ESR, and three 1μF external input capacitors. All caps
are low ESR.
Testing must be kept short enough that the converter does not appreciably
heat up during testing. For extended testing, use plenty of air?ow. See
derating curves for temperature performance. All models are stable and
regulate within spec without external cacacitance.
? Input Ripple Current is tested and speci?ed over a 5-20 MHz bandwidth
? Regulation speci?cations describe the deviation as the input line voltage
or output load current is varied from a nominal midpoint value to either
extreme (50% load).
? Do not exceed maximum power ratings, sense limits or output overvoltage
when adjusting output trim values.
? Output overload protection is non-latching. When the output overload
is removed, the output will automatically recover.
? All models are fully operational and meet published speci?cations,
including “cold start” at –40°C.
and uses a special set of external ?lters only for the Ripple Current speci-
?cations. Input ?ltering is C IN = 33 μF, C BUS = 220 μF, L BUS = 12?μH. Use
capacitor rated voltages which are twice the maximum expected voltage.
Capacitors must accept high speed AC switching currents.
? Note that Maximum Current Derating Curves indicate an average current
at nominal input voltage. At higher temperatures and/or lower air?ow, the
converter will tolerate brief full current outputs if the average RMS current
over time does not exceed the Derating curve. All Derating curves are
presented at sea level altitude. Be aware of reduced power dissipation
with increasing density altitude.
? Mean Time Before Failure (MTBF) is calculated using the Telcordia (Bel-
core) SR-332 Method 1, Case 3, Issue 1, ground ?xed conditions. Operat-
ing temperature = +25°C, full output load, natural air convection.
? The output may be shorted to ground inde?nitely with no damage. The
Output Short Circuit Current shown in the speci?cations is an average con-
sisting of very short bursts of full rated current to test whether the output
circuit can be repowered.
? The On/Off pin allows the converter to be turned on or off by an external
device such as a switch, a transistor, a logic gate, or an optical isolator.
If the “logic pin” is left ?oating the measured voltage will be outside the
limit's in the data sheet. Those numbers de?ne the levels needed for the
11
12
13
14
15
The converter will shut off if the input falls below the undervoltage thresh-
old. It will not restart until the input exceeds the Input Start Up Voltage.
Output noise may be further reduced by installing an external ?lter. See
the Application Notes. Use only as much output ?ltering as needed and no
more . Larger caps (especially low-ESR ceramic types) may slow transient
response or degrade dynamic performance. Thoroughly test your applica-
tion with all components installed.
If reverse polarity is accidentally applied to the input, always connect an
external fast blow input fuse in series with the +V IN input.
Although extremely unlikely, failure of the internal components of this
product may expose external application circuits to dangerous voltages,
currents, temperatures or power levels. Please thoroughly verify all ap-
plications before committing them to service. Be sure to include appropri-
ately rated FUSES (see speci?cations and Application Notes) to reduce the
risk of failure.
Special care should be exercised so that Input Voltage Transient does not
exceed speci?ed Max 100V/100ms. At normal input a large transient spike
can be generated as a result of distribution inductance and high inrush
current charging input cap on converter. This can be eliminated with 33μF
electrolytic capacitor mounted close to Converter input. The series resis-
tance (500mΩ < ESR < 700mΩ) is essential in this solution.
“control function” to take place and do not represent the voltage that may
be present on the logic pin.
www.murata-ps.com/support
MDC_ULT Series.F01 Page 5 of 26
相关PDF资料 |
PDF描述 |
|---|---|
| UM2NPAT | BATTERY S-HD 1.5V C SIZE W/TAB |
| UMA1V470MDD | CAP ALUM 47UF 35V 20% RADIAL |
| UMK107SD102JA-T | CAP CER 1000PF 5% 50V 0603 |
| UNL6W30K-F | CAP FILM 30UF 600VDC SNAP |
| UNR-3.3/3-D5SM-C | DC/DC SM 3A 5-3.3V NON-ISO |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ULTI-BOOM-FB | 制造商:Ultimate Support Systems 功能描述:Microphone Boom 制造商:ULTIMATE SUPPORT 功能描述:MICROPHONE BOOM |
| ULTI-BOOM-TB | 制造商:Ultimate Support Systems 功能描述:Telescoping Microphone Boom 制造商:ULTIMATE SUPPORT 功能描述:TELESCOPING MICROPHONE BOOM |
| ULTKIT | 制造商:JATON 功能描述:WOODSCREW CSK KIT |
| ULTMT-SK-265 | 功能描述:开发板和工具包 - ARM FEZ ULTIMATE KIT .net MF Dev Tool RoHS:否 制造商:Arduino 产品:Development Boards 工具用于评估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口类型:DAC, ICSP, JTAG, UART, USB 工作电源电压:3.3 V |
| ULTRA 100 TX2 5-PACK | 制造商:Promise Technologies 功能描述:ONLY USE FOR PELCO - Bulk |
发布紧急采购，3分钟左右您将得到回复。