- 您现在的位置：买卖IC网 > PDF目录1251 > UM245R (FTDI, Future Technology Devices International Ltd)MOD USB PARALLEL FIFO DEV FT245R PDF资料下载
参数资料
| 型号： | UM245R |
| 厂商： | FTDI, Future Technology Devices International Ltd |
| 文件页数： | 22/27页 |
| 文件大小： | 0K |
| 描述： | MOD USB PARALLEL FIFO DEV FT245R |
| 产品培训模块： | USB Introduction |
| 产品目录绘图： | UM245R |
| 标准包装： | 5 |
| 主要目的： | 接口，USB 2.0 至并行 FIFO 电桥 |
| 嵌入式： | 否 |
| 已用 IC / 零件： | FT245R |
| 主要属性： | 300kBps 到 1MBps USB 至并行 FIFO，通过 4 线接口连接 |
| 次要属性： | 免版税驱动器 |
| 已供物品： | 板 |
| 产品目录页面： | 633 (CN2011-ZH PDF) |
| 相关产品： | 768-1012-6-ND - IC USB TO PARALLEL FIFO 32-QFN 768-1011-6-ND - IC USB TO PARALLEL FIFO 28-SSOP 768-1012-1-ND - IC USB TO PARALLEL FIFO 32-QFN 768-1011-1-ND - IC USB TO PARALLEL FIFO 28-SSOP 768-1012-2-ND - IC USB TO PARALLEL FIFO 32-QFN 768-1011-2-ND - IC USB TO PARALLEL FIFO 28-SSOP |
| 其它名称： | 768-1020 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页当前第22页第23页第24页第25页第26页第27页
Document Reference No.: FT_000202
UM245R USB - Parallel FIFO Development Module Datasheet Version 1.04
Clearance No.: FTDI# 124
7.4 Bus Powered with 3.3V Logic Drive / IO Supply Voltage
Figure 7.4 USB Bus Powered 3.3V Logic Drive
Figure 7.4 shows a configuration where a jumper switch is used to allow the FT245R to be interfaced with
a 3.3V or 5V logic devices. Th e FT245R?s VCCIO pin is either supplied with 5V from the USB bus (connect
together pins 2 and 3 on J1), or with 3.3V from the FT245R?s 3V3OUT pin (connect together pins 1 and 2
on J1 as shown). The supply to UM245R?s 3V3 pin can also be used to supply up t o 50mA to external
logic.
Please note the following in relation to bus powered designs of this type:
i)
The PWREN# signal should be used to power down external logic during USB suspend mode, in
order to comply with the limit of 500μA (2.5mA with remote wake-up enabled). If this is not
possible, use the configuration shown in Section 7.3
ii) The maximum current source from USB Bus during normal operation should not exceed 100mA,
otherwise a bus powered design with power switching ( Section 7.3 ) should be used.
Another possible configuration would be to use a discrete LDO which is supplied by the 5V on the USB
bus to supply 2.8V - 1.8V to the VIO pin and to the external logic. VCC would be supplied with the 5V
from the USB bus. With VIO connected to the output of the low dropout regulator would, in turn, will
cause the FT245R I/O pins to drive out at 2.8V - 1.8V logic levels.
For USB bus powered circuits some considerations have to be taken into account when selecting the
regulator:
iii) The regulator must be capable of sustaining its output voltage with an input voltage as low as
4.35V. A Low Drop Out (LDO) regulator must be selected.
iv) The quiescent current of the regulator must be low in order to meet the USB suspend total
current requirement of <= 500μA /2.5mA during USB suspend.
An example of a regulator family that meets these requirements is the MicroChip MCP17xx Series of
devices ( www.microchip.com ). These devices can supply up to 250mA current and have a quiescent
current of under 1μA.
? Copyright 2009 Future Technology Devices International Ltd
21
相关PDF资料 |
PDF描述 |
|---|---|
| UMTS 2 | FUSE 2A 250V TLAG IEC SMD |
| UPG1-4-61-303-01 | MAGNETIC CIRC BRKR SP 30A TOG SW |
| UPL111-1-60-503 | MAGNETIC CIRCUIT PROTECTOR 50A |
| UPL2000-D1/B | BNC PLUG CRIMP STR 7538CBL 50/PK |
| UPL2000-D20/B | BNC PLUG CRIMP STR 1505F 50/PK |
相关代理商/技术参数 |
参数描述 |
|---|---|
| UM246 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC |
| UM246M | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC |
| UM247 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC |
| UM247M | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC |
| UM248 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC |
发布紧急采购，3分钟左右您将得到回复。