- 您现在的位置：买卖IC网 > PDF目录297667 > V23809-C8-T11 (INFINEON TECHNOLOGIES AG) DATACOM, ETHERNET TRANSCEIVER, XFO PDF资料下载
参数资料
| 型号： | V23809-C8-T11 |
| 厂商： | INFINEON TECHNOLOGIES AG |
| 元件分类： | 网络接口 |
| 英文描述： | DATACOM, ETHERNET TRANSCEIVER, XFO |
| 封装： | 9.80 MM HEIGHT MODULE |
| 文件页数： | 3/5页 |
| 文件大小： | 229K |
| 代理商： | V23809-C8-T11 |
Fiber Optics
V23809-C8–T10, MM 1300 nm LED Fast Ethernet/FDDI/ATM Transceiver (ST)
3
Transmitter Electro-Optical Characteristics
Notes
1. Measured at the end of 5 meters of 62.5/125/0.275 graded index
fiber using calibrated power meter and a precision test ferrule.
Cladding modes are removed. Values valid for EOL and worst-case
temperature.
2. The input data pattern is a 12.5 MHz square wave pattern.
3. Center wavelength is defined as the midpoint between the two
50% levels of the optical spectrum of the LED.
4. Spectral width (full width, half max) is defined as the difference
between 50% levels of the optical spectrum of the LED.
5. 10% to 90% levels. Measured using the 12.5 MHz square wave
pattern with an optoelectronic measurement system (detector
and oscilloscope) having 3 dB bandwidth ranging from less than
0.1 MHz to more than 750 MHz.
6. Extinction Ratio is defined as PL/PH x 100%. Measurement system
as in Note 5.
7. Optical Power Low is the output power level when a steady state
low data pattern (FDDI Quiet Line state) is used to drive the trans-
mitter. Value valid <1 ms after input low.
8. Test method as for FDDI-PMD. Jitter values are peak-to-peak.
9. Duty Cycle Distortion is defined as 0.5 [(width of wider state) minus
(width of narrower state)]. It is measured with stream of Idle
Symbols (62.5 MHz square wave).
10.Measured with the same pattern as for FDDI-PMD.
11. Measured with the Halt Line state (12.5 MHz square wave).
Receiver Electro-Optical Characteristics
Notes
1. Pattern: Manchester coding / NRZI (no scrambling)
2. For a bit error rate (BER) of less than 1x10E–12 over a receiver eye
opening of least 1.5 ns. Measured with a 223–1 PRBS at 155 MBd.
3. For a BER of less than 1x10E-12. Measured in the center of the eye
opening with a 223-1 PRBS at 155 MBd.
4. Measured at an average optical power level of –20 dBm with a 62.5
MHz square wave.
5. All jitter values are peak-to-peak. RX output jitter requirements are
not considered in the ATM standard draft. In general the same
requirements as for FDDI are met.
6. Measured at an average optical power level of –20 dBm.
7. Measured at –33 dBm average power.
8. An increase in optical power through the specified level will
cause the SIGNAL detect output to switch from a Low state to
a High state.
9. A decrease in optical power through the specified level will
cause the SIGNAL detect output to switch from a High state to
aLow state.
10. PECL compatible. Load is 50
into VCC –2 V. Measured under DC
conditions. For dynamic measurements a tolerance of 50 mV should
be added for VCC=5 V.
Transmitter
Symbol
Min.
Typ.
Max.
Units
Data Rate
DR
170
MBaud
Launched Power
(Average) into 62.5
m
Fiber for –C8–C10(1, 2)
PO
–20
–16
–14
dBm
Launched Power
(Average) into 62.5
m
Fiber for –C8–C11(1, 2)
–22
–17
Center Wavelength(2, 3)
λC
1270
1360
nm
Spectral Width
(FWHM)(2, 4)
Dl
170
Output Rise/Fall Time,
10%–90%(2, 5)
tR, tF
0.6
2.5
ns
Temperature
Coefficient of Optical
Output Power
TCp
0.03
dB/°C
Extinction Ratio
(Dynamic)(2, 6)
ER
10
%
Optical Power Low(7)
PTD
–45
dBm
Overshoot
OS
10
%
Duty Cycle
Distortion(8, 9)
tDCD
0.6
ns
Data Dependent
Jitter(8, 10)
tDDJ
0.3
Random Jitter(8, 11)
tRJ
0.6
Receiver
Symbol
Min.
Typ.
Max.
Units
Data Rate
DR
5(1)
170
MBaud
Sensitivity
Average Power)(2)
PIN
–33
–31
dBm
Sensitivity (Average
Power) Center(3)
–35.5
Saturation (Average
Power)(3)
PSAT
–14
–11
Duty Cycle
Distortion(4, 5)
tDCD
1ns
Deterministic
Jitter(5, 6)
tDJ
1
Random Jitter(5, 7)
tRJ
Signal Detect
Assert Level(8)
PSDA
–42.5
–30
dBm
Signal Detect
Deassert Level(9)
PSDD
–45
–31.5
Signal Detect
Hysteresis
PSDA–
PSDD
1.0
dB
Output Low
Voltage(10)
VOL–VCC –1810
–1620
mV
Output High
Voltage(10)
VOH–VCC –1025
–880
Output Data
Rise/Fall Time,
20%–80%
tR, tF
1.3
ns
Output SD
Rise/Fall Time,
20%–80%
40
相关PDF资料 |
PDF描述 |
|---|---|
| V23809-C8-T10 | DATACOM, ETHERNET TRANSCEIVER, XFO |
| V23809-F7-T10 | DATACOM, ETHERNET TRANSCEIVER, XFO |
| V23826-H18-C13 | TRANSCEIVER, SMA9 |
| V24A6V5H400BN2 | 1-OUTPUT 400 W DC-DC REG PWR SUPPLY MODULE |
| V24A28E400B3 | 1-OUTPUT 400 W DC-DC REG PWR SUPPLY MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| V23809E11C10 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:FIBER OPTIC TRANSCEIVER |
| V23809-E1-E16 | 制造商:Infineon Technologies AG 功能描述:SINGLE MODE 155 MBD ATM/SDH/SONET 1X9 TRANSCEIVER |
| V23809-E1-E17 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:FIBER OPTIC TRANSCEIVER |
| V23809E1E30 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:FIBER OPTIC TRANSCEIVER |
| V23809F7C10 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:FIBER OPTIC TRANSCEIVER |
发布紧急采购，3分钟左右您将得到回复。