- 您现在的位置：买卖IC网 > PDF目录225492 > V300A2E160BS2 1-OUTPUT 160 W DC-DC REG PWR SUPPLY MODULE PDF资料下载
参数资料
| 型号： | V300A2E160BS2 |
| 元件分类： | 电源模块 |
| 英文描述： | 1-OUTPUT 160 W DC-DC REG PWR SUPPLY MODULE |
| 文件页数： | 12/13页 |
| 文件大小： | 584K |
| 代理商： | V300A2E160BS2 |
Vicor Corp. Tel: 800-735-6200, 978-470-2900 Fax: 978-475-6715
300V Maxi Family
Rev. 8.7
Page 8 of 13
Set your site on VICOR at vicorpower.com
Module Enable/Disable
The module may be disabled by pulling PC below 2.3 V with
respect to the –Input. This may be done with an open collector
transistor, relay, or optocoupler. Multiple converters may be
disabled with a single transistor or relay either directly or via
“OR’ing” diodes. See Figure 1.
Primary Auxiliary Supply
At 5.7 V, PC can source up to 1.5 mA. In the example shown
in Figure 3, PC powers a module enabled LED.
Module Alarm
The module contains “watchdog” circuitry which monitors
input voltage, operating temperature and internal operating
parameters. In the event that any of these parameters are
outside of their allowable operating range, the module will
shut down and PC will go low. PC will periodically go high
and the module will check to see if the fault (as an example,
overtemperature) has cleared. If the fault has not been cleared,
PC will go low again and the cycle will restart. The SC pin
will go low in the event of a fault and return to its normal
state after the fault has been cleared. See Figures 2 and 4.
+IN
PC
PR
–IN
Disable
Disable = PC <2.3 V
Figure 1 — Module enable/disable.
Figure 3 — LED on-state indicator.
+IN
PC
PR
–IN
4 k
Ω
"Module
Enabled"
+IN
PC
PR
–IN
Optocoupler
4 k
Ω
Alarm
1.00V
+OUT
+S
SC
–S
–OUT
Comparator
+OUT
+S
SC
–S
– OUT
+IN
PC
PR
–IN
Input Undervoltage
2-20 ms typ.
f (VIN)
Auto
Restart
5.7 Vdc
(0-3 mA)
50
Ω
SW2
SW3
1.23
Vdc
6 K
1 K
SW1
SW1, 2, & 3
shown in
"Fault" position
Input Overvoltage (See Note 1)
Overtemperature
Module Faults
1
Not applicable for 300 Vdc input family
1 M
Figure 2 — PC/SC module alarm logic.
Figure 5 — Isolated on-state indicator.
2–20 ms typical
Fault
SC
PC
1.23 V
5.7 V
40
μs typ.
Figure 4 — PC/SC module alarm timing.
Figure 6 — Secondary side on-state indicator.
CONTROL FUNCTIONS - PC PIN
相关PDF资料 |
PDF描述 |
|---|---|
| V300A2M160BG3 | 1-OUTPUT 160 W DC-DC REG PWR SUPPLY MODULE |
| V300A2T160BG2 | 1-OUTPUT 160 W DC-DC REG PWR SUPPLY MODULE |
| V300A36M500B2 | 1-OUTPUT 500 W DC-DC REG PWR SUPPLY MODULE |
| V300A36T400BS3 | 1-OUTPUT 400 W DC-DC REG PWR SUPPLY MODULE |
| V300A3V3C200BS | 1-OUTPUT 200 W DC-DC REG PWR SUPPLY MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| V300A2E160BS3 | 功能描述:CONVERTER MOD DC/DC 2V 160W 制造商:vicor corporation 系列:Maxi 包装:散装 零件状态:* 类型:隔离模块 输出数:1 电压 - 输入（最小值）:180V 电压 - 输入（最大值）:375V 电压 - 输出 1:2V 电压 - 输出 2:- 电压 - 输出 3:- 电流 - 输出（最大值）:80A 功率（W） - 制造系列:160W 电压 - 隔离:3kV（3000V） 应用:ITE（商业） 特性:OVP，UVLO 安装类型:通孔 封装/外壳:整砖 大小/尺寸:4.60" 长 x 2.20" 宽 x 0.54" 高（116.8mm x 55.9mm x 13.7mm） 工作温度:-10°C ~ 100°C 效率:74% 功率（W） - 最大值:160W 标准包装:1 |
| V300A2E24B | 制造商:VICOR 制造商全称:Vicor Corporation 功能描述:FasTrak Maxi E-Grade Family DC-DC Converter |
| V300A2E24B1 | 制造商:VICOR 制造商全称:Vicor Corporation 功能描述:FasTrak Maxi E-Grade Family DC-DC Converter |
| V300A2E24B2 | 制造商:VICOR 制造商全称:Vicor Corporation 功能描述:FasTrak Maxi E-Grade Family DC-DC Converter |
| V300A2E24BL | 制造商:VICOR 制造商全称:Vicor Corporation 功能描述:FasTrak Maxi E-Grade Family DC-DC Converter |
发布紧急采购，3分钟左右您将得到回复。