- 您现在的位置：买卖IC网 > PDF目录276704 > V62/06657-05XE (TEXAS INSTRUMENTS INC) 6.5 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO20 PDF资料下载
参数资料
| 型号： | V62/06657-05XE |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | 6.5 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO20 |
| 封装： | GREEN, PLASTIC, HTSSOP-20 |
| 文件页数： | 5/21页 |
| 文件大小： | 614K |
| 代理商： | V62/06657-05XE |
www.ti.com
Dead-Time Control and MOSFET Drivers
Overcurrent Protection
Thermal Shutdown
Power Good (PWRGD)
SGLS376A – FEBRUARY 2007 – REVISED MARCH 2007
Adaptive dead-time control prevents shoot-through current from flowing in both N-channel power MOSFETs
during the switching transitions by actively controlling the turn-on times of the MOSFET drivers. The high-side
driver does not turn on until the gate drive voltage to the low-side FET is below 2 V. The low-side driver does not
turn on until the voltage at the gate of the high-side MOSFETs is below 2 V. The high-side and low-side drivers
are designed with 300-mA source and sink capability to quickly drive the power MOSFETs gates. The low-side
driver is supplied from VIN, while the high-side drive is supplied from the BOOT pin. A bootstrap circuit uses an
external BOOT capacitor and an internal 2.5-
bootstrap switch connected between the VIN and BOOT pins.
The integrated bootstrap switch improves drive efficiency and reduces external component count.
The cycle by cycle current limiting is achieved by sensing the current flowing through the high-side MOSFET
and differential amplifier and comparing it to the preset overcurrent threshold. The high-side MOSFET is turned
off within 200 ns of reaching the current limit threshold. A 100-ns leading edge blanking circuit prevents false
tripping of the current limit. Current limit detection occurs only when current flows from VIN to PH when sourcing
current to the output filter. Load protection during current sink operation is provided by thermal shutdown.
The device uses the thermal shutdown to turn off the power MOSFETs and disable the controller if the junction
temperature exceeds 150
°C. The device is released from shutdown when the junction temperature decreases to
10
°C below the thermal shutdown trip point and starts up under control of the slow-start circuit. Thermal
shutdown provides protection when an overload condition is sustained for several milliseconds. With a persistent
fault condition, the device cycles continuously; starting up by control of the soft-start circuit, heating up due to
the fault, and then shutting down upon reaching the thermal shutdown point.
The power good circuit monitors for under voltage conditions on VSENSE. If the voltage on VSENSE is 10%
below the reference voltage, the open-drain PWRGD output is pulled low. PWRGD is also pulled low if VIN is
less than the UVLO threshold, or SS/ENA is low, or thermal shutdown is asserted. When VIN = UVLO threshold,
SS/ENA = enable threshold, and VSENSE > 90% of Vref, the open drain output of the PWRGD pin is high. A
hysteresis voltage equal to 3% of Vref and a 35-s falling edge deglitch circuit prevent tripping of the power good
comparator due to high frequency noise.
13
相关PDF资料 |
PDF描述 |
|---|---|
| VE-B04-MX | 1-OUTPUT 75 W DC-DC BOOSTER MODULE |
| VE-B6L-IU | 1-OUTPUT 200 W DC-DC BOOSTER MODULE |
| VE-B6L-IY | 1-OUTPUT 50 W DC-DC BOOSTER MODULE |
| VE-BN0-MV | 1-OUTPUT 150 W DC-DC BOOSTER MODULE |
| VE-PU3Y-EXX | 2-OUTPUT AC-DC REG PWR SUPPLY MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| V6207602-01XE | 制造商:TI 制造商全称:Texas Instruments 功能描述:4 ppm100 A SOT23-6 SERIES VOLTAGE REFERENCES |
| V6207602-02XE | 制造商:TI 制造商全称:Texas Instruments 功能描述:4 ppm100 A SOT23-6 SERIES VOLTAGE REFERENCES |
| V6207602-03XE | 制造商:TI 制造商全称:Texas Instruments 功能描述:4 ppm100 A SOT23-6 SERIES VOLTAGE REFERENCES |
| V6207602-04XE | 制造商:TI 制造商全称:Texas Instruments 功能描述:4 ppm100 A SOT23-6 SERIES VOLTAGE REFERENCES |
| V6207602-05XE | 制造商:TI 制造商全称:Texas Instruments 功能描述:4 ppm100 A SOT23-6 SERIES VOLTAGE REFERENCES |
发布紧急采购，3分钟左右您将得到回复。