- 您现在的位置：买卖IC网 > PDF目录297706 > V62/09616-01XE (TEXAS INSTRUMENTS INC) 4-CHANNEL, SGL ENDED MULTIPLEXER, PDSO14 PDF资料下载
参数资料
| 型号： | V62/09616-01XE |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 多路复用及模拟开关 |
| 英文描述： | 4-CHANNEL, SGL ENDED MULTIPLEXER, PDSO14 |
| 封装： | PLASTIC, MS-012AB, SOIC-14 |
| 文件页数： | 7/25页 |
| 文件大小： | 860K |
| 代理商： | V62/09616-01XE |
R = 663
NGxR
W -
F
I
(6)
V
O
V
I
=
R
+
F
I
1+
Z
(S)
1+
R
F
R
G
a
R
R NG
+
F
I
Z
(S)
1+
a
NG
1+
R
F
R
G
NG = 1+
R
F
R
G
(4)
=
LoopGain
Z
(S)
R +R
F
I NG
(5)
600
550
500
450
400
350
300
250
200
150
100
NoiseGain
0
20
10
15
5
F
eedbackResistor(
)
W
www.ti.com........................................................................................................................................................................................... SBOS444 – DECEMBER 2008
RI, the buffer output impedance, is a critical portion of
The OPA4872 is internally compensated to give a
the bandwidth control equation. RI for the OPA4872 is
maximally flat frequency response for RF = 523 at
typically about 30
. A current-feedback op amp
NG = 2 on ±5-V supplies. Evaluating the denominator
senses an error current in the inverting node (as
of Equation 5 (which is the feedback transimpedance)
opposed to a differential input error voltage for a
gives an optimal target of 663
. As the signal gain
voltage-feedback op amp) and passes this on to the
changes, the contribution of the NG × RI term in the
output through an internal frequency dependent
feedback transimpedance will change, but the total
transimpedance gain. The Typical Characteristics
show this open-loop transimpedance response. This
gives an approximate equation for optimum RF over
open-loop response is analogous to the open-loop
signal gain:
voltage gain curve for a voltage-feedback op amp.
Developing the transfer function for the circuit of
Figure 32 gives Equation 4:
As the desired signal gain increases, this equation
will eventually predict a negative RF. A somewhat
subjective limit to this adjustment also can be set by
holding RG to a minimum value of 20 . Lower values
load both the buffer stage at the input and the output
stage, if RF gets too low, actually decreasing the
bandwidth. Figure 33 shows the recommended RF
versus NG for ±5-V operation. The values for RF
versus gain shown here are approximately equal to
where:
the
values
used
to
generate
the
Typical
Characteristics. They differ in that the optimized
values used in the Typical Characteristics are also
correcting for board parasitics not considered in the
simplified analysis leading to Equation 5. The values
This formula is written in a loop-gain analysis format,
shown in Figure 33 give a good starting point for
where the errors arising from a noninfinite open-loop
design where bandwidth optimization is desired.
gain are shown in the denominator. If Z(S) were
infinite over all frequencies, the denominator of
Equation 4 would reduce to 1 and the ideal desired
signal gain shown in the numerator would be
achieved.
The
fraction
in
the
denominator
of
Equation 4 determines the frequency response.
Equation 5 shows this as the loop-gain equation:
If 20 × log(RF + NG × RI) were drawn on top of the
open-loop
transimpedance
plot,
the
difference
between the two calculations would be the loop gain
at a given frequency. Eventually, Z(S) rolls off to equal
the denominator of Equation 5, at which point the
loop gain reduces to 1 (and the curves intersect).
This
point
of
equality
is
where
the
amplifier
Figure 33. Feedback Resistor vs Noise Gain
closed-loop frequency response given by Equation 4
starts to roll off, and is exactly analogous to the
frequency at which the noise gain equals the
The total impedance going into the inverting input
open-loop voltage gain for a voltage-feedback op
may be used to adjust the closed-loop signal
amp. The difference here is that the total impedance
bandwidth. Inserting a series resistor between the
in the denominator of Equation 5 may be controlled
inverting input and the summing junction increases
somewhat separately from the desired signal gain (or
the feedback impedance (denominator of Equation 4),
NG).
decreasing the bandwidth.
Copyright 2008, Texas Instruments Incorporated
15
Product Folder Link(s): OPA4872-EP
相关PDF资料 |
PDF描述 |
|---|---|
| V62C31162048LL-70KI | 128K X 16 STANDARD SRAM, 70 ns, PDSO44 |
| V6300ETO-92 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PBCY3 |
| V6300KSOT-23 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO5 |
| V6300GTO-92 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PBCY3 |
| V6300BSOT-23 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| V62-09620-01XA | 制造商:TI 制造商全称:Texas Instruments 功能描述:MIXED SIGNAL MICROCONTROLLER |
| V620H011M | 制造商:OMRON Industrial Automation 功能描述: 制造商:Omron Corporation 功能描述: |
| V620H015M | 制造商:OMRON Industrial Automation 功能描述: |
| V620H025M | 制造商:OMRON Industrial Automation 功能描述: 制造商:Omron Corporation 功能描述: |
| V620TE01 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:VOLTAGE CONTROLLED OSCILLATOR |
发布紧急采购，3分钟左右您将得到回复。