- 您现在的位置：买卖IC网 > Datasheet目录368 > VLA504-01 (Powerex Inc)IC IGBT GATE DVR ISO 3A Datasheet资料下载
参数资料
| 型号： | VLA504-01 |
| 厂商： | Powerex Inc |
| 文件页数： | 5/6页 |
| 文件大小： | 0K |
| 描述： | IC IGBT GATE DVR ISO 3A |
| 标准包装： | 21 |
| 配置： | 高端或低端 |
| 输入类型： | 非反相 |
| 延迟时间： | 400ns |
| 电流 - 峰： | 3A |
| 配置数： | 1 |
| 输出数： | 1 |
| 高端电压 - 最大（自引导启动）： | 1200V |
| 电源电压： | 14 V ~ 15 V |
| 工作温度： | -20°C ~ 60°C |
| 安装类型： | 通孔 |
| 封装/外壳： | 14-SIP（12 引线） |
| 供应商设备封装： | 模块 |
| 包装： | 散装 |
| 配用： | BG2B-3015-ND - KIT DEV BOARD 2CN 3A FOR IGBT BG1A-KA-ND - KIT DEV BOARD FOR IGBT |
Powerex, Inc., 173 Pavilion Lane, Youngwood, Pennsylvania 15697-1800 (724) 925-7272
VLA504-01
Hybrid IC IGBT Gate Driver
General Description
The VLA504-01-01 is a hybrid integrated circuit designed
to provide gate drive for high power IGBT modules.
This circuit has been optimized for use with Powerex
NF-Series and A-Series IGBT modules. However, the
output characteristics are compatible with most MOS
gated power devices. The VLA504-01 features a com-
pact single-in-line package design. The upright mount-
ing minimizes required printed circuit board space to
allow efficient and flexible layout. The VLA504-01
converts logic level control signals into fully isolated
+15V/-8V gate drive with up to 5A of peak drive current.
Control signal isolation is provided by an integrated high
speed opto-coupler. Short circuit protection is provided
by means of destauration detection.
Short Circuit Protection
Figure 1 shows a block diagram of a typical desatura-
tion detector. In this circuit, a high voltage fast recovery
diode (D1) is connected to the IGBT’s collector to moni-
tor the collector to emitter voltage. When the IGBT is
in the off state, V CE is high and D1 is reverse biased.
With D1 off the (+) input of the comparator is pulled up
to the positive gate drive power supply (V+) which is
normally +15V. When the IGBT turns on, the com-
parators (+) input is pulled down by D1 to the IGBT’s
V CE(sat) . The (-) input of the comparator is supplied with
a fixed voltage (V TRIP ). During a normal on-state condi-
tion the comparator’s (+) input will be less than V TRIP
and it’s output will be low. During a normal off-state
condition the comparator’s (+) input will be larger than
V+
D1
+
V TRIP and it’s output will be high. If the IGBT turns on
into a short circuit, the high current will cause the IGBT’s
collector-emitter voltage to rise above V TRIP even
though the gate of the IGBT is being driven on. This
abnormal presence of high VCE when the IGBT is
supposed to be on is often called desaturation. Desatu-
ration can be detected by a logical AND of the driver’s
input signal and the comparator output. When the output
of the AND goes high a short circuit is indicated. The
output of the AND can be used to command the IGBT
to shut down in order to protect it from the short circuit.
A delay (t TRIP ) must be provided after the comparator
output to allow for the normal turn on time of the IGBT.
The tTRIP delay is set so that the IGBTs Vce has
enough time to fall below V TRIP during normal turn on
switching. If t TRIP is set too short, erroneous desatura-
tion detection will occur. The maximum allowable t TRIP
delay is limited by the IGBT’s short circuit withstanding
capability. In typical applications using Powerex IGBT
modules the recommended limit is 10μs.
Operation of the VLA504-01 Desaturation Detector
The Powerex VLA504-01 incorporates short circuit pro-
tection using desaturation detection as described above.
A flow chart for the logical operation of the short-circuit
protection is shown in Figure 2. When a desaturation
is detected the hybrid gate driver performs a soft shut
down of the IGBT and starts a timed (t timer ) 1.5ms lock
out. The soft turn-off helps to limit the transient voltage
that may be generated while interrupting the large short
circuit current flowing in the IGBT. During the lock out
the driver pulls Pin 8 low to indicate the fault status.
Normal operation of the driver will resume after the lock-
out time has expired and the control input signal returns
to its off state.
Adjustment of Trip Time
RG
INPUT
DELAY
ttrip
AND
COMPARE
SHUTDOWN
GATE
DRIVE
Vtrip
IGBT
MODULE
G
C
The VLA504-01 has a default short-circuit detection
time delay (t TRIP ) of approximately 2.5μs. This will
prevent erroneous detection of short-circuit conditions
as long as the series gate resistance (R G ) is near the
minimum recommended value for the module being
used. The 2.5μs delay is appropriate for most applica-
tions so adjustment will not be necessary. However, in
some low frequency applications it may be desirable
Rev. 04/07
E
Figure 1. Desaturation Detector
E
to use a larger series gate resistor to slow the switch-
ing of the IGBT, reduce noise, and limit turn-off tran-
sient voltages. When RG is increased, the switching
delay time of the IGBT will also increase. If the delay
相关PDF资料 |
PDF描述 |
|---|---|
| VLA507-01 | IC IGBT GATE DVR ISO 3A |
| VLA513-01 | IC IGBT GATE DVR ISO 5A |
| VLLDU-1-30W | IC LED DRVR STP-DWN 5PCB |
| VNC2 DEBUG MODULE | MOD VINCULUM-II DEBUGGR/PROGRAMR |
| VPROG-1-S-LQFP48 | VPROG-1 SOCKET/ADAPTER 48-LQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| VLA504-01R | 制造商:ISAHAYA 制造商全称:Isahaya Electronics Corporation 功能描述:DRIVER FOR IGBT MODULES |
| VLA507 | 制造商:POWEREX 制造商全称:Powerex Power Semiconductors 功能描述:Hybrid IC IGBT Gate Driver |
| VLA507_12 | 制造商:POWEREX 制造商全称:Powerex Power Semiconductors 功能描述:BG2C-Universal Gate Drive Prototype Board |
| VLA507-01 | 功能描述:IC IGBT GATE DVR ISO 3A RoHS:是 类别:集成电路 (IC) >> PMIC - MOSFET，电桥驱动器 - 外部开关 系列:- 标准包装:5 系列:- 配置:低端 输入类型:非反相 延迟时间:600ns 电流 - 峰:12A 配置数:1 输出数:1 高端电压 - 最大（自引导启动）:- 电源电压:14.2 V ~ 15.8 V 工作温度:-20°C ~ 60°C 安装类型:通孔 封装/外壳:21-SIP 模块 供应商设备封装:模块 包装:散装 配用:BG2A-NF-ND - KIT DEV BOARD FOR IGBT 其它名称:835-1063 |
| VLA507-01R | 制造商:ISAHAYA 制造商全称:Isahaya Electronics Corporation 功能描述:HYBRID IC DRIVER FOR IGBT MODULES |
发布紧急采购，3分钟左右您将得到回复。