参数资料
型号: XC9243B08DDR-G
厂商: Torex Semiconductor Ltd
文件页数: 11/29页
文件大小: 0K
描述: IC REG BUCK SYNC ADJ 2A USP-10B
标准包装: 3,000
类型: 降压(降压)
输出类型: 可调式
输出数: 1
输出电压: 0.9 V ~ 6 V
输入电压: 2.7 V ~ 6 V
频率 - 开关: 2.4MHz
电流 - 输出: 2A
同步整流器:
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 10-UFDFN 裸露焊盘
包装: 带卷 (TR)
供应商设备封装: USP-10B
XC9242/XC9243
Series
■ NOTE ON USE
1.
2.
3.
4.
5.
Please use this IC within the stated maximum ratings. For temporary, transitional voltage drop or voltage rising phenomenon,
the IC is liable to malfunction should the ratings be exceeded.
Where wiring impedance is high, operations may become unstable due to noise and/or phase lag depending on output current.
Please wire the input capacitor (C IN ) and the output capacitor (C L ) as close to the IC as possible.
When the difference between V IN and V OUT is large in PWM control, very narrow pulses will be outputted, and there is the possibility that
some cycles may be skipped completely.
When the difference between V IN and V OUT is small, and the load current is heavy, very wide pulses will be outputted and there is the
possibility that some cycles may be skipped completely.
With the IC, the peak current of the coil is controlled by the current limit circuit. Since the peak current increases when dropout voltage or
load current is high, current limit starts operation, and this can lead to instability. When peak current becomes high, please adjust the coil
inductance value and fully check the circuit operation. In addition, please calculate the peak current according to the following formula:
Ipk = (V IN -V OUT )×OnDuty / (2×L×f OSC ) + I OUT
L : Coil Inductance Value
f OSC : Oscillation Frequency
6. Use of the IC at voltages below the recommended voltage range may lead to instability.
7. This IC should be used within the stated absolute maximum ratings in order to prevent damage to the device.
8. When the IC is used in high temperature, output voltage may increase up to input voltage level at no load because of the leak current of the
P-channel driver transistor.
9. The XC9242/XC9243 uses fold-back circuit limiter. However, fold-back may become “droop” affected by the wiring conditions.
Care
must be taken especially for C IN distance and position.
10. If C L capacitance reduction happens such as in the case of low temperature, the IC may enter unstable operation. Care must be taken for
C L capacitor selection and its capacitance value.
1ch V Lx : 2.0V/di v
2ch V OUT : 50mV/di v
Ta = - 50 ℃
V IN = 3.6V, V OUT = 0.9V, f OSC = 2.4MHz
C IN = 20 μ F(Ceramic)
C L = 14.7 μ F(Ceramic)
I OUT = 300mA
x-axis : 2.0 μ s / div
11. Torex places an importance on improving our products and its reliability.
However, by any possibility, we would request user fail-safe design and post-aging treatment on system or equipment.
11/29
相关PDF资料
PDF描述
XC9303B093KR-G IC REG CTRLR BST PWM 8-MSOP
XC9503B093AR-G IC REG BUCK ADJ 1A DL 10MSOP
XC9519A12AZR-G IC REG BOOST INV ADJ 2A DL 24QFN
XRP29302ETB-L IC REG LDO ADJ 3A TO263-5
XRP2997IDBTR-F IC CONV DDR DDR2 DDR3 8SOIC
相关代理商/技术参数
参数描述
XC9243B08DQR-G 制造商:Torex Semiconductor LTD 功能描述:
XC9246B65CMR-G 制造商:Torex Semiconductor LTD 功能描述:IC REG BUCK ADJ 1A SOT-26W
XC9246B65CMR-G-EVB 制造商:Torex Semiconductor LTD 功能描述:BOARD EVAL FOR XC9246B65
XC9246B75CMR-G 制造商:Torex Semiconductor LTD 功能描述:IC REG BUCK ADJ 1A SOT-26W
XC9246B75CMR-G-EVB 制造商:Torex Semiconductor LTD 功能描述:BOARD EVAL FOR XC9246B75