参数资料
型号: XR17C154IV-F
厂商: Exar Corporation
文件页数: 22/62页
文件大小: 0K
描述: IC UART PCI BUS QUAD 144LQFP
标准包装: 60
特点: *
通道数: 4,QUART
FIFO's: 64 字节
规程: RS485
电源电压: 5V
带自动流量控制功能:
带IrDA 编码器/解码器:
带故障启动位检测功能:
带调制解调器控制功能:
安装类型: 表面贴装
封装/外壳: 144-LQFP
供应商设备封装: 144-LQFP(20x20)
包装: 托盘
xr
XR17C154
REV. 1.3.2
5V PCI BUS QUAD UART
29
4.3.3
Receiver Operation with FIFO
4.4
Automatic Hardware (RTS/CTS or DTR/DSR) Flow Control Operation
Automatic hardware RTS/CTS or DTR/DSR flow control is used to prevent data overrun to the local receiver
FIFO and remote receiver FIFO. The RTS#/DTR# output pin is used to request the remote unit to suspend/
restart data transmission while the CTS#/DSR# input pin is monitored to suspend/restart the local transmitter.
The auto RTS/CTS or DTR/DSR flow control features are individually selected to fit specific application
requirement and enabled through EFR bit-6 and 7 and MCR bit-2 for either RTS/CTS or DTR/DSR control
signals.
Auto RTS flow control must be started by asserting the RTS# output pin LOW (MCR bit-1 = 1). Similarly, Auto
DTR flow control must be started by asserting the DTR# output pin LOW (MCR bit-0 = 1). Figure 14 shows in
detail how automatic hardware flow control works.
FIGURE 13. RECEIVER OPERATION IN FIFO AND FLOW CONTROL MODE
TABLE 10: AUTO RTS/CTS OR DTR/DSR FLOW CONTROL SELECTION
MCR BIT-2
EFR BIT-7
EFR BIT-6
HARDWARE FLOW CONTROL SELECTION
0
1
X
Auto CTS Flow Control Enabled
0
X
1
Auto RTS Flow Control Enabled
1
X
Auto DSR Flow Control Enabled
1
X
1
Auto DTR Flow Control Enabled
X
0
No Hardware Flow Control
Receive Data Shift
Register (RSR)
RXFIFO1
16X or 8X Sampling
Clock (8XMODE Reg.)
E
rror
Fl
ag
s
(64-s
ets)
E
rro
rFl
ags
i
n
LS
R
bi
ts
4:2
64 bytes by 11-
bit wide FIFO
Receive Data Characters
FIFO Trigger=48
Example:
- FIFO trigger level set at 48 bytes
- RTS/DTR hyasteresis set at +/-8 chars.
Data fills to 56
Data falls to 40
Data Bit
Validation
Receive Data
FIFO
(64-byte)
Receive
Data
Receive Data
Byte and Errors
RHR Interrupt (ISR bit-2) is programmed
at FIFO trigger level (RXTRG).
FIFO is Enable by FCR bit-0=1
RTS#/DTR# de-asserts when data fills above
the trigger level to suspend remote transmitter.
Enable by EFR bit-6=1, MCR bit-2.
RTS#/DTR# re-asserts when data falls below
the trigger level to restart remote transmitter.
Enable by EFR bit-6=1, MCR bit-2.
相关PDF资料
PDF描述
XR17C154CV-F IC UART PCI BUS QUAD 144LQFP
ATMEGA165P-16AUR IC AVR MCU 16K 16MHZ 64-TQFP
ATMEGA165PV-8AUR IC AVR MCU 16K 8MHZ 64-TQFP
XR16C864IQTR-F IC UART FIFO 128B QUAD 100QFP
XR16C864CQTR-F IC UART FIFO 128B QUAD 100QFP
相关代理商/技术参数
参数描述
XR17C154IVTR-F 制造商:Exar Corporation 功能描述:UART 4-CH 64Byte FIFO 5V 144-Pin LQFP T/R 制造商:Exar Corporation 功能描述:XR17C154IVTR-F
XR17C158 制造商:EXAR 制造商全称:EXAR 功能描述:5V PCI BUS OCTAL UART
XR17C158CV 功能描述:UART 接口集成电路 UART RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel
XR17C158CV-0A-EVB 功能描述:UART 接口集成电路 Supports C158 144 ld TQFP, PCI Interface RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel
XR17C158CV-F 功能描述:UART 接口集成电路 UART RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel