参数资料
| 型号： | XR88C92CVTR-F |
| 厂商： | Exar Corporation |
| 文件页数： | 15/32页 |
| 文件大小： | 0K |
| 描述： | IC UART FIFO DUAL 44LQFP |
| 标准包装： | 1,000 |
| 特点： | * |
| 通道数： | 2，DUART |
| FIFO's： | 16 字节 |
| 电源电压： | 2.97 V ~ 5.5 V |
| 带自动流量控制功能： | 是 |
| 带CMOS： | 是 |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 44-LQFP |
| 供应商设备封装： | 44-LQFP（10x10） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页当前第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
XR88C92/192
22
Rev. 1.33
START COUNTER/TIMER REGISTER (STCR)
-
Read Only
Reading from this register will start the C/T. Data values
returned should be ignored.
STOP COUNTER/TIMER REGISTER (SPCR) -
Read Only
Reading from this register will stop the C/T. Data values
returned should be ignored.
SET
OUTPUT
PORT
REGISTER
(SOPR) -
Write Only
Output ports (OP0-OP7), when used as general pur-
pose outputs, can be asserted (set to low) by writing a
“1” to the corresponding bit in this register. Once an
output is asserted, it can be negated only by issuing a
command through the Reset Output Port Register (see
below).
However, note that SOPR and ROPR cannot be used to
assert and negate outputs that are programmed for
alternate functions (see description under OPCR). For
example, if OP0 is programmed to output -RTSA (see
'Configuring Multi-purpose Outputs), it cannot be con-
trolled by SOPR or ROPR. In that case, commands from
the Command Register should be issued to assert (CRA
bits 7:4 = 0x8) and negate (CRA bits 7:4 = 0x9) OP0.
SOPR Bit 0-7:
0 = No change (same state).
1 = Assert the corresponding output (Set it low).
RESET OUTPUT PORT REGISTER (ROPR) - Write
Only
Each output port bit can be changed to high state by
writing a “1” to each individual bit.
ROPR Bit 0-7:
0 = No change (same state).
1 = Negate the corresponding output (Set it high).
相关PDF资料 |
PDF描述 |
|---|---|
| XR88C92CJTR-F | IC UART FIFO DUAL 44PLCC |
| ST16C452CJ68TR-F | IC UART W/PAR PORT DUAL 68PLCC |
| ST16C552CJ68TR-F | IC UART FIFO 16B DUAL 68PLCC |
| XR68C681CJTR-F | IC UART CMOS DUAL 44PLCC |
| ST16C2550CJ44TR-F | IC UART FIFO 16B DUAL 44PLCC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| XR88C92IJ | 制造商:EXAR 制造商全称:EXAR 功能描述:DUAL UNIVERSAL ASYNCHRONOUS RECEIVER AND TRANSMITTER |
| XR88C92IJ-F | 功能描述:UART 接口集成电路 Dual Channel UART RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel |
| XR88C92IJTR-F | 功能描述:UART 接口集成电路 Dual Channel UART RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel |
| XR88C92IP | 制造商:EXAR 制造商全称:EXAR 功能描述:DUAL UNIVERSAL ASYNCHRONOUS RECEIVER AND TRANSMITTER |
| XR88C92IV | 制造商:EXAR 制造商全称:EXAR 功能描述:DUAL UNIVERSAL ASYNCHRONOUS RECEIVER AND TRANSMITTER |
发布紧急采购，3分钟左右您将得到回复。