- 您现在的位置：买卖IC网 > PDF目录10784 > XRT7295ATIW-F (Exar Corporation)IC LINE RCVR 20SOJ PDF资料下载
参数资料
| 型号： | XRT7295ATIW-F |
| 厂商： | Exar Corporation |
| 文件页数： | 16/18页 |
| 文件大小： | 0K |
| 描述： | IC LINE RCVR 20SOJ |
| 标准包装： | 36 |
| 类型： | 接收器 |
| 驱动器/接收器数： | 1/1 |
| 规程： | DS3，STS-1 |
| 电源电压： | 4.75 V ~ 5.25 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-BSOJ |
| 供应商设备封装： | 20-SOJ |
| 包装： | 管件 |
| 其它名称： | 1016-1356-5 |
XRT7295AT
7
Rev.1.20
DS3 SIGNAL REQUIREMENTS AT THE DSX
Pulse characteristics are specified at the DSX-3, which is
an interconnection and test point referred to as the
cross-connect (see Figure 2.) The cross-connect exists
at the point where the transmitted signal reaches the
distribution frame jack. Table 1 lists the signal
requirements. Currently, two isolated pulse template
requirements exist: the ACCUNET T45 pulse template
(see Table 2 and Figure 4)and the G.703 pulse template
(see Table 3 and Figure 5). Table 2 and Table 3 give the
associated boundary equations for the templates. The
XRT7295AT correctly decodes any transmitted signal
that meets one of these templates at the cross-connect.
Parameter
Specification
Line Rate
44.736 Mbps 20 ppm
Line Code
Bipolar with three-0 substitution (B3ZS)
Test Load
75 W 5%
Pulse Shape
An isolated pulse must fit the template in NO TAG or Figure 5.1 The pulse amplitude may be scaled by
a constant factor to fit the template. The pulse amplitude must be between 0.36vpk and 0.85vpk,
measured at the center of the pulse.
Power Levels
For and all 1s transmitted pattern, the power at 22.368 ± 0.002MHz must be -1.8 to +5.7dBm, and
the power at 44.736 ±0.002MHz must be -21.8dBm to -14.3dBm.2, 3
Notes
1 The pulse template proposed by G.703 standards is shown in Figure 5 and specified in Table 3. The proposed G.703 standards
further state that the voltage in a time slot containing a 0 must not exceed ± 5% of the peak pulse amplitude, except for the residue
of preceding pulses.
2 The power levels specified by the proposed G.703 standards are identical except that the power is to be measured in 3kHz bands.
3 The all 1s pattern must be a pure all 1s signal, without framing or other control bits.
Table 1. DSX-3 Interconnection Specification
Lower Curve
Upper Curve
Time
Equation
Time
Equation
T ± -0.36
0
T±-0.68
0
-0.36 ± T ± +0.28
0.5 (1+sin {p/2}[1+T/0.18])
-0.68 ± T± +0.36
0.5 (1+sin {p/2} [1+T/0.34])
0.28 ± T
0.11e-3.42(T-0.3)
0.36 ± T
0.05 + 0.407e-1.84(T-0.36)
Table 2. DSX-3 Pulse Template Boundaries for ACCUNET T45 Standards (See Figure 4.)
相关PDF资料 |
PDF描述 |
|---|---|
| VI-BNW-MX-F1 | CONVERTER MOD DC/DC 5.5V 75W |
| LTC2846IG#PBF | IC TXRX 3.3V MULTIPROTCOL 36SSOP |
| VI-JTY-MW-S | CONVERTER MOD DC/DC 3.3V 66W |
| VI-BNW-MW | CONVERTER MOD DC/DC 5.5V 100W |
| AD7225KRZ-REEL | IC DAC 8BIT QUAD W/AMP 24SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| XRT7295ATIW-F | 制造商:Exar Corporation 功能描述:T3/E3 LIU IC |
| XRT7295ATIWTR | 功能描述:外围驱动器与原件 - PCI RoHS:否 制造商:PLX Technology 工作电源电压: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:FCBGA-1156 封装:Tray |
| XRT7295ATIWTR-F | 功能描述:外围驱动器与原件 - PCI RoHS:否 制造商:PLX Technology 工作电源电压: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:FCBGA-1156 封装:Tray |
| XRT7295CTIW | 功能描述:总线接收器 DS3/E3/SONET STS-1 Line Receiver RoHS:否 制造商:Texas Instruments 接收机数量:4 接收机信号类型:Differential 接口类型:EIA/TIA-422-B, V.11 工作电源电压:3.3 V 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:TSSOP-16 封装:Reel |
| XRT7295CTIW-F | 功能描述:总线接收器 DS3/E3/SONET STS-1 Line Receiver RoHS:否 制造商:Texas Instruments 接收机数量:4 接收机信号类型:Differential 接口类型:EIA/TIA-422-B, V.11 工作电源电压:3.3 V 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:TSSOP-16 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。