参数资料
| 型号： | XRT83L314IB |
| 厂商： | Exar Corporation |
| 文件页数： | 19/84页 |
| 文件大小： | 0K |
| 描述： | IC LIU T1/E1/J1 14CH 304TBGA |
| 标准包装： | 27 |
| 类型： | 线路接口装置（LIU） |
| 驱动器/接收器数： | 14/14 |
| 规程： | T1，E1，J1 |
| 电源电压： | 3.135 V ~ 3.465 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 304-LBGA |
| 供应商设备封装： | 304-TBGA（31x31） |
| 包装： | 托盘 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页当前第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页
XRT83L314
14-CHANNEL T1/E1/J1 LONG-HAUL/SHORT-HAUL LINE INTERFACE UNIT
REV. 1.0.0
22
In T1 mode, RLOS is declared if an incoming signal has no transitions over a period of 175 +/-75 contiguous
pulse intervals. However, the XRT83L314 LIU has a built in analog RLOS so that the user can be notified
when the amplitude of the incoming signal has been attenuated -9dB below the equalizer gain setting. For
example:
In T1 or E1 short haul mode, the equalizer gain setting is 15dB.
Once the input reaches an
amplitude of -24dB below nominal, the LIU will declare RLOS. The RLOS circuitry clears when the input
reaches +3dB relative to where it was declared. This +3dB value is a pre-determined hysteresis so that
transients will not cause the RLOS to clear. In E1 mode, RLOS is declared if an incoming signal has no
transitions for N consecutive pulse intervals, where 10
≤N≤255. According to G.775, no transitions in E1 mode
is defined between -9dB and -35dB below nominal. Figure 14 is a simplified block diagram of the analog
RLOS function. Table 6 summarizes the analog RLOS values for the different equalizer gain settings.
FIGURE 14. ANALOG RECEIVE LOS OF SIGNAL FOR T1/E1/J1
NOTE: For programming the equalizer gain setting on a per channel basis, see the microprocessor register map for details.
2.6.3.2
EXLOS (Extended Loss of Signal)
By enabling the extended loss of signal by programming the appropriate channel register, the digital RLOS is
extended to count 4,096 consecutive zeros before declaring RLOS in T1 and E1 mode. By default, EXLOS is
disabled and RLOS operates in normal mode.
2.6.3.3
AIS (Alarm Indication Signal)
The XRT83L314 adheres to the ITU-T G.775 specification for an all ones pattern. The alarm indication signal
is set to "1" if an all ones pattern (at least 99.9% ones density) is present for T, where T is 3ms to 75ms in T1
mode. AIS will clear when the ones density is not met within the same time period T. In E1 mode, the AIS is
set to "1" if the incoming signal has 2 or less zeros in a 512-bit window. AIS will clear when the incoming signal
has 3 or more zeros in the 512-bit window.
2.6.3.4
NLCD (Network Loop Code Detection)
The Network Loop Code Detection can be programmed to detect a Loop-Up, Loop-Down, or Automatic Loop
Code.
If the network loop code detection is programmed for Loop-Up, the NLCD will be set "High" if a
repeating pattern of "00001" occurs for more than 5 seconds.
If the network loop code detection is
programmed for Loop-Down, the NLCD will be set "High" if a repeating pattern of "001" occurs for more than 5
TABLE 6: ANALOG RLOS DECLARE/CLEAR (TYPICAL VALUES) FOR T1/E1
GAIN SETTING
DECLARE
CLEAR
15dB (Short Haul Mode)
-24dB
-21dB
29dB (Monitoring Gain Mode)
-38dB
-35dB
36dB (Long Haul Mode)
-45dB
-42dB
45dB (Long Haul Mode)
-54dB
-51dB
Normalized up to EQC[4:0] Setting
Declare LOS
Clear LOS
-9dB
+3dB
Clear LOS
Declare LOS
+3dB
-9dB
Normalized up to EQC[4:0] Setting
相关PDF资料 |
PDF描述 |
|---|---|
| XRT75L04IVTR-F | IC LIU E3/DS3/STS-1 4CH 176LQFP |
| VI-23V-IU-F1 | CONVERTER MOD DC/DC 5.8V 200W |
| VE-B1T-MW-F3 | CONVERTER MOD DC/DC 6.5V 100W |
| XRT75L04IVTR | IC LIU E3/DS3/STS-1 4CH 176LQFP |
| VI-23R-IU-F3 | CONVERTER MOD DC/DC 7.5V 200W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| XRT83L314IB-F | 功能描述:时钟合成器/抖动清除器 RoHS:否 制造商:Skyworks Solutions, Inc. 输出端数量: 输出电平: 最大输出频率: 输入电平: 最大输入频率:6.1 GHz 电源电压-最大:3.3 V 电源电压-最小:2.7 V 封装 / 箱体:TSSOP-28 封装:Reel |
| XRT83L314IB-L | 功能描述:LIN 收发器 14 channel, LH/SH T1/E1 LIU RoHS:否 制造商:NXP Semiconductors 工作电源电压: 电源电流: 最大工作温度: 封装 / 箱体:SO-8 |
| XRT83L34 | 制造商:EXAR 制造商全称:EXAR 功能描述:QUAD T1/E1/J1 LH/SH TRANSCEIVER WITH CLOCK RECOVERY AND JITTER ATTENUATOR |
| XRT83L34_05 | 制造商:EXAR 制造商全称:EXAR 功能描述:QUAD T1/E1/J1 LH/SH TRANSCEIVER WITH CLOCK RECOVERY AND JITTER ATTENUATOR |
| XRT83L34ES | 功能描述:外围驱动器与原件 - PCI RoHS:否 制造商:PLX Technology 工作电源电压: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:FCBGA-1156 封装:Tray |
发布紧急采购，3分钟左右您将得到回复。