参数资料
| 型号： | YNV05T06-G |
| 厂商： | Power-One |
| 文件页数： | 8/25页 |
| 文件大小： | 0K |
| 描述： | CONVERT DC/DC 21.78W T/H |
| 标准包装： | 240 |
| 系列： | * |
YNV05T06 DC-DC Converter Data Sheet
3.0-5.5 VDC Input; 0.7525-3.63 VDC Programmable @ 6A
thermocouples to ensure measurement accuracy.
Careful routing of the thermocouple leads will
further minimize measurement error. Refer to Fig.
E for optimum measuring thermocouple location.
Thermal Derating
Load current vs. ambient temperature and airflow
rates are given in Figs. x.1 to x.2 for maximum
temperature of 120°C. Ambient temperature was
varied between 25°C and 85°C, with airflow rates
from 30 to 500 LFM (0.15m/s to 2.5 m/s), for Vin =
5V and Vin = 3.3V, and vertical or horizontal
converter mounting.
For each set of conditions, the maximum load
current was defined as the lowest of:
Power Dissipation
Fig. 3.3V.4 shows the power dissipation vs. load
current plot for Ta = 25oC, airflow rate of 200 LFM
(1 m/s) with vertically or horizontally mounting and
input voltages of 4.5V, 5.0V and 5.5V for 3.3V
output voltage.
Ripple and Noise
The output voltage ripple waveform is measured at
full rated load current. Note that all output voltage
waveforms are measured across a 1 ? F ceramic
capacitor.
The output voltage ripple and input reflected ripple
current waveforms are obtained using the test
setup shown in Fig. F.
Nex -v Series
(i) The output current at which any MOSFET
temperature does not exceed a maximum
specified temperature (120°C) as indicated by the
thermographic image, or
(ii) The maximum current rating of the converter
(6A)
i S
1 ? H
source
inductance
V source
C IN
4 x 47 ? F
ceramic
capacitor
Vin Vout
GND GND
TM
DC/DC
Converter
1 ? F
ceramic
capacitor
C O
47 ? F
ceramic
capacitor
Vout
During normal operation, derating curves with
maximum FET temperature less than or equal to
120 °C should not be exceeded. Temperature on
the PCB at the thermocouple locations shown in
Fig. E should not exceed 120°C in order to
operate inside the derating curves.
Fig. E: Location of the thermocouple for thermal testing.
Efficiency
Fig. x.3 show the efficiency vs. load current plot for
ambient temperature of 25oC, airflow rate of 200
LFM (1 m/s) with vertically or horizontally mounting
and input voltages of 4.5V, 5.0V and 5.5V.
Fig. x.4 show the efficiency vs. load current plot for
ambient temperature of 25oC, airflow rate of 200
LFM (1 m/s) with vertically or horizontally mounting
and input voltages of 3.0V, 3.3V, and 3.6V for
output voltages ? 2.5V.
Fig. F: Test setup for measuring input reflected ripple
currents, i s and output voltage ripple.
MCD10197 Rev. 1.0, 21-Jun-10
Page 8 of 25
www.power-one.com
相关PDF资料 |
PDF描述 |
|---|---|
| OSTV7105250 | TERM BLOCK PLUG 5.08MM 10POS |
| 74LVT162240ADGG,11 | IC INVERTER QUAD 4-INPUT 48TSSOP |
| 74LVT162240ADL,112 | IC INVERTER QUAD 4-INPUT 48SSOP |
| OSTV7143251 | TERM BLOCK PLUG 3.81MM 14POS |
| OSTV7141251 | TERM BLOCK PLUG 3.50MM 14POS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| YNV05T06-GA | 制造商:Power-One 功能描述: |
| YNV05T10 | 制造商:Power-One 功能描述:DC-DC Converter, 3.0-5.5 VDC In., 0.7525-3.63 VDC Programmable @ 10 A, RoHS |
| YNV05T10-0 | 功能描述:DC/DC转换器 RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
| YNV05T10009-0 | 制造商:Power-One 功能描述:DC/DC PS SGL-OUT 0.9V 10A 36.3W 10SIP - Bulk |
| YNV05T10009-0G | 制造商:Power-One 功能描述:DC/DC PS SGL-OUT 0.9V 10A 36.3W 10SIP - Bulk |
发布紧急采购，3分钟左右您将得到回复。