参数资料
| 型号： | 101-0488 |
| 厂商： | Rabbit Semiconductor |
| 文件页数： | 22/90页 |
| 文件大小： | 0K |
| 描述： | MODULE RABBITCORE RCM2210 |
| 标准包装： | 1 |
| 系列： | RabbitCore® |
| 模块/板类型： | 单板计算机模块 |
| 适用于相关产品： | RCM2210 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页当前第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页
User’s Manual
23
4.2 Serial Communication
The RCM2200 board does not have an RS-232 or an RS-485 transceiver directly on the
board. However, an RS-232 or RS-485 interface may be incorporated on the board the
RCM2200 is mounted on. For example, the Prototyping Board supports a standard
RS-232 transceiver chip.
4.2.1 Serial Ports
There are four serial ports designated as Serial Ports A, B, C, and D. All four serial ports
can operate in an asynchronous mode up to the baud rate of the system clock divided by
64. An asynchronous port can handle 7 or 8 data bits. A 9th bit address scheme, where an
additional bit is sent to mark the first byte of a message, is also supported. Serial Ports A
and B can also be operated in the clocked serial mode. In this mode, a clock line synchro-
nously clocks the data in or out. Either of the two communicating devices can supply the
clock. When the Rabbit 2000 provides the clock, the baud rate can be up to 80% of the
system clock frequency divided by 128, or 138,240 bps for a 22.1 MHz clock speed.
Serial Port A is available only on the programming port, and so is likely to be inconve-
nient to interface with.
4.2.2 Ethernet Port
Figure 6 shows the pinout for the RJ-45 Ethernet port (J2). Note that some Ethernet con-
nectors are numbered in reverse to the order used here.
Figure 6. RJ-45 Ethernet Port Pinout
Two LEDs are placed next to the RJ-45 Ethernet
jack, one to indicate an Ethernet link (LNK) and one
to indicate Ethernet activity (ACT).
The Ethernet signals are also available on header J4.
The ACK and LNK signals can be used to drive LEDs
on the user board the RCM2200 is connected to.
The transformer/connector assembly ground is con-
nected to the RCM2200 printed circuit board digital
ground via a 0
resistor, R29, as shown in Figure 7.
Figure 7. Isolation Resistor R29
ETHERNET
RJ-45 Plug
1. E_Tx+
2. E_Tx
3. E_Rx+
6. E_Rx
1
8
RJ-45 Jack
RJ-45 Ethernet Plug
R29
Chassis
Ground
Board
Ground
相关PDF资料 |
PDF描述 |
|---|---|
| AT45DB321B-TC | IC FLASH 32MBIT 20MHZ 32TSOP |
| AT45DB011B-SC | IC FLASH 1MBIT 20MHZ 8SOIC |
| SOMOMAP3530-11-1670EFCR | SYSTEM ON MODULE LV OMAP3530 |
| 395-030-523-202 | CARD EDGE 30POS DL .100X.200 BLK |
| 395-030-523-201 | CARD EDGE 30POS DL .100X.200 BLK |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 101-0492 | 功能描述:单板计算机 OP6800 RoHS:否 制造商:Ampro By ADLINK 外观尺寸:EPIC 处理器类型:Intel Atom D510 频率:1.66 GHz 存储容量:2 GB (max) 存储类型:DDR2, L2 Cache 接口类型:Ethernet, PS/2, SATA, Serial, USB 工作电源电压:5 V, 12 V 功耗:13 W 最大工作温度:+ 70 C 尺寸:165.1 mm x 114.3 mm |
| 101-0494 | 功能描述:模块化系统 - SOM RCM2250 RABBITCORE RoHS:否 制造商:Digi International 外观尺寸:ConnectCore 9P 处理器类型:ARM926EJ-S 频率:150 MHz 存储容量:8 MB, 16 MB 存储类型:NOR Flash, SDRAM 接口类型:I2C, SPI, UART 工作电源电压:3.3 V 最大工作温度:+ 85 C 尺寸:1.97 in x 1.97 in x 6.1 in |
| 101-0495 | 功能描述:处理器配件 Baseplate RoHS:否 制造商:Olimex Ltd. 产品:Cable 用于: |
| 101-0497 | 功能描述:单板计算机 OP6810 RoHS:否 制造商:Ampro By ADLINK 外观尺寸:EPIC 处理器类型:Intel Atom D510 频率:1.66 GHz 存储容量:2 GB (max) 存储类型:DDR2, L2 Cache 接口类型:Ethernet, PS/2, SATA, Serial, USB 工作电源电压:5 V, 12 V 功耗:13 W 最大工作温度:+ 70 C 尺寸:165.1 mm x 114.3 mm |
| 10104997-00C-10B | 功能描述:高速/模块连接器 XCEDE 2W 6PVH 6COL RoHS:否 制造商:Molex 系列:iPass 产品类型: 排数: 列数: 位置/触点数量:38 安装角:Right 节距:0.8 mm 安装风格:Plug 端接类型:SMD/SMT 外壳材料:Thermoplastic 触点材料:High Performance Alloy (HPA) 触点电镀:Gold |
发布紧急采购，3分钟左右您将得到回复。