- 您现在的位置：买卖IC网 > PDF目录18714 > 4463-TCE20C460-EK (Silicon Laboratories Inc)KIT EZRADIO TEST CARD SI4463 TX PDF资料下载
参数资料
| 型号： | 4463-TCE20C460-EK |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 19/56页 |
| 文件大小： | 0K |
| 描述： | KIT EZRADIO TEST CARD SI4463 TX |
| 设计资源： | 4463-TCE20C460 BOM 4463-TCE20C460 PCB 4463-TCE20C460 SCH |
| 标准包装： | 1 |
| 系列： | EZRadioPRO® |
| 类型： | 收发器，ISM |
| 频率： | 460MHz |
| 适用于相关产品： | Si4463 |
| 已供物品： | 板 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页当前第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页
Si4464/63/61/60
3.2. Fast Response Registers
The fast response registers are registers that can be read immediately without the requirement to monitor and
check CTS. There are four fast response registers that can be programmed for a specific function. The fast
response registers can be read through API commands, 0x50 for Fast Response A, 0x51 for Fast Response B,
0x53 for Fast Response C, and 0x57 for Fast Response D. The fast response registers can be configured by the
“FRR_CTL_X_MODE” properties.
The fast response registers may be read in a burst fashion. After the initial 16 clock cycles, each additional eight
clock cycles will clock out the contents of the next fast response register in a circular fashion. The value of the
FRRs will not be updated unless NSEL is toggled.
3.3. Operating Modes and Timing
The primary states of the Si446x are shown in Figure 6. The shutdown state completely shuts down the radio to
minimize current consumption. Standby/Sleep, SPI Active, Ready, TX Tune, and RX tune are available to optimize
the current consumption and response time to RX/TX for a given application. API commands START_RX,
START_TX, and CHANGE_STATE control the operating state with the exception of shutdown which is controlled
by SDN, pin 1. Table 9 shows each of the operating modes with the time required to reach either RX or TX mode as
well as the current consumption of each mode. The times in Table 9 are measured from the rising edge of nSEL
until the chip is in the desired state. Note that these times are indicative of state transition timing but are not
guaranteed and should only be used as a reference data point. An automatic sequencer will put the chip into RX or
TX from any state. It is not necessary to manually step through the states. To simplify the diagram it is not shown
but any of the lower power states can be returned to automatically after RX or TX.
Figure 6. State Machine Diagram
Rev 1.2
19
相关PDF资料 |
PDF描述 |
|---|---|
| 4463-TCE20B460-EK | KIT EZRADIO TEST CARD SI4463 TX |
| 4461-TSQ14D868-EK | KIT EZRADIO TEST CARD SI4461 TX |
| 4460-TCE10D868-EK | KIT EZRADIO TEST CARD SI4460 TX |
| 4460-TCE10D434-EK | KIT EZRADIO TEST CARD SI4460 TX |
| SI4844-DEMO | SI4844 EVAL AND DEMO BOARD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 4463-TCE20C868-EK | 功能描述:射频开发工具 4463 20 868 MHz Test Card RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| 4463-TCE20C915-EK | 功能描述:射频开发工具 4463 20 dBm915 MHz Test Card RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| 4463-TCE27F868-EK | 功能描述:射频开发工具 4463 27 dBm 868 MHz Test Card RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| 4463-TCE30E915R-EK | 功能描述:射频开发工具 4463 30 dBm 915 MHz Test Card RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| 4463-TCE30E915S-EK | 功能描述:射频开发工具 4463 30 dBm915 MHz Test Card RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
发布紧急采购，3分钟左右您将得到回复。