- 您现在的位置：买卖IC网 > PDF目录18714 > 4463-TCE27F868-EK (Silicon Laboratories Inc)KIT EZRADIO TEST CARD SI4463 TX PDF资料下载
参数资料
| 型号： | 4463-TCE27F868-EK |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 41/56页 |
| 文件大小： | 0K |
| 描述： | KIT EZRADIO TEST CARD SI4463 TX |
| 设计资源： | 4463-TCE27F868 BOM 4463-TCE27F868 PCB 4463-TCE27F868 SCH |
| 标准包装： | 1 |
| 系列： | EZRadioPRO® |
| 类型： | 收发器，ISM |
| 频率： | 868MHz |
| 适用于相关产品： | Si4463 |
| 已供物品： | 板 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页当前第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页
4 ? 2
32 ? 768
Si4464/63/61/60
7. RX Modem Configuration
The Si446x can easily be configured for different data rate, deviation, frequency, etc. by using the WDS settings
calculator, which generates an initialization file for use by the host MCU.
8. Auxiliary Blocks
8.1. Wake-up Timer and 32 kHz Clock Source
The chip contains an integrated wake-up timer that can be used to periodically wake the chip from sleep mode. The
wake-up timer runs from either the internal 32 kHz RC Oscillator, or from an external 32 kHz XTAL.
The wake-up timer can be configured to run when in sleep mode. If WUT_EN = 1 in the GLOBAL_WUT_CONFIG
property, prior to entering sleep mode, the wake-up timer will count for a time specified defined by the
GLOBAL_WUT_R and GLOBAL_WUT_M properties. At the expiration of this period, an interrupt will be generated
on the nIRQ pin if this interrupt is enabled in the INT_CTL_CHIP_ENABLE property. The microcontroller will then
need to verify the interrupt by reading the chip interrupt status either via GET_INT_STATUS or a fast response
register. The formula for calculating the Wake-Up Period is as follows:
WUT_R
WUT = WUT_M ? ----------------------------- ? ms ?
The RC oscillator frequency will change with temperature; so, a periodic recalibration is required. The RC oscillator
is automatically calibrated during the POWER_UP command and exits from the Shutdown state. To enable the
recalibration feature, CAL_EN must be set in the GLOBAL_WUT_CONFIG property, and the desired calibration
period should be selected via WUT_CAL_PERIOD[2:0] in the same API property. During the calibration, the
32 kHz RC oscillator frequency is compared to the 30 MHz XTAL and then adjusted accordingly. The calibration
needs to start the 30 MHz XTAL, which increases the average current consumption; so, a longer CAL_PERIOD
results in a lower average current consumption. The 32 kHz XTAL accuracy is comprised of both the XTAL
parameters and the internal circuit. The XTAL accuracy can be defined as the XTAL initial error + XTAL aging +
XTAL temperature drift + detuning from the internal oscillator circuit. The error caused by the internal circuit is
typically less than 10 ppm.
Rev 1.2
41
相关PDF资料 |
PDF描述 |
|---|---|
| 4463-TCE20C915-EK | KIT EZRADIO TEST CARD SI4463 TX |
| DR-TXC100-315 | BOARD EVALUATION 315MHZ TXC100 |
| 4463-TCE20C868-EK | KIT EZRADIO TEST CARD SI4463 TX |
| 4463-TCE20C460-EK | KIT EZRADIO TEST CARD SI4463 TX |
| 4463-TCE20B460-EK | KIT EZRADIO TEST CARD SI4463 TX |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 4463-TCE30E915R-EK | 功能描述:射频开发工具 4463 30 dBm 915 MHz Test Card RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| 4463-TCE30E915S-EK | 功能描述:射频开发工具 4463 30 dBm915 MHz Test Card RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| 4463-TSQ20D169-EK | 功能描述:射频开发工具 4463 20 dBm 169 MHz Test Card RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| 4463-TSQ27F169-EK | 功能描述:射频开发工具 4463 27 dBm 169 MHz Test Card RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| 4464 | 功能描述:以太网和电信连接器 SHIELD CONNECTOR RoHS:否 制造商:Pulse 产品:Modular Jacks 性能类别: USOC 代码:RJ45 位置/触点数量: 安装风格:Through Hole 端口数量:1 x 1 型式:Female 屏蔽: 电流额定值: 电压额定值: 触点电镀: 外壳材料:Thermoplastic IP 等级: |
发布紧急采购，3分钟左右您将得到回复。