参数资料
型号: 5962-0721901VHA
厂商: TEXAS INSTRUMENTS INC
元件分类: 运算放大器
英文描述: OP-AMP, 6000 uV OFFSET-MAX, CDFP10
封装: CERAMIC, DFP-10
文件页数: 10/22页
文件大小: 830K
代理商: 5962-0721901VHA
www.ti.com
NON-INVERTING SINGLE-SUPPLY OPERATION
1
2
4
3
5
+VS
FB2
VS
+VS
GND
J3
J4
J6
J5
GND
TP1
C2
3.3 mF
C4
0.1 mF
NC
C8
R8
249 W
R7
+VS
U1
J1
C7
R10
0
R1
49.9 W
THS4304DBV
R2
49.9 W
C9
0
J2
VREF
R3
10 kW
R6
+VS
0.1 mF
C5
0
VREF
3
4
1
5
2
+
DIFFERENTIAL ADC DRIVE AMPLIFIER
SGDS038A – SEPTEMBER 2007 – REVISED OCTOBER 2007
The THS4304 EVM can easily be configured for single 5 V supply operation, as shown in the following
schematic, with no change in performance. This circuit passes dc signals at the input, so care must be taken to
reference (or bias) the input signal to mid-supply.
If dc operation is not required, the amplifier can be ac coupled by inserting a capacitor in series with the input
(C7) and output (C9).
Figure 44. Non-Inverting 5-V Single-Supply Amplifier
The circuit shown in Figure 44 is adapted as shown in Figure 45 to provide a high-performance differential
amplifier drive circuit for use with high-performance ADCs, like the ADS5500 (14 bit 125 MSP ADC). For testing
purposes, the circuit uses a transformer to convert the signal from a single-ended source to differential. If the
input signal source in your application is differential and biased to mid-rail, no transformer is required.
The circuit employs two amplifiers to provide a differential signal path to the ADS5500. A resistor divider (two
10 k
Ω resistors) is used to obtain a mid-supply reference voltage of 2.5 V (VREF) (the same as shown in the
single-supply circuit of Figure 44). Applying this voltage to the one side of RG and to the positive input of the
operational amplifier (via the center-tap of the transformer) sets the input and output common-mode voltage of
the operational amplifiers to mid-rail to optimize their performance. The ADS5500 requires an input
common-mode voltage of 1.5 V. Due to the mismatch in required common-mode voltage, the signal is ac coupled
from the amplifier output, via the two 1 nF capacitors, to the input of the ADC. The CM voltage of the ADS5500 is
used to bias the ADC input to the required voltage, via the 1 k
Ω resistors. Note: 100 μA common-mode current is
drawn by the ADS5500 input stage (at 125 MSPS). This causes a 100 mV shift in the input common-mode
voltage, which does not impact the performance when driving the input to –1 dB of full scale. To offset this effect,
a voltage divider from the power supply can be used to derive the input common-mode voltage reference.
Because the operational amplifiers are configured as non-inverting, the inputs are high impedance. This is
particularly useful when interfacing to a high-impedance source. In this situation, the amplifiers provide
impedance matching and amplification of the signal.
18
Copyright 2007, Texas Instruments Incorporated
Product Folder Link(s): THS4304-SP
相关PDF资料
PDF描述
5962-0722301VFA OP-AMP, 5500 uV OFFSET-MAX, 3000 MHz BAND WIDTH, CDFP16
5962-7704301VCA QUAD OP-AMP, 7000 uV OFFSET-MAX, 1.2 MHz BAND WIDTH, CDIP14
5962-86860012X QUAD COMPARATOR, 5000 uV OFFSET-MAX, CQCC20
5962-8686001EX QUAD COMPARATOR, 5000 uV OFFSET-MAX, 200 ns RESPONSE TIME, CDIP16
5962-8687701GA COMPARATOR, 4000 uV OFFSET-MAX, 200 ns RESPONSE TIME, CQCC20
相关代理商/技术参数
参数描述
5962-0722201VFA 制造商:TI 制造商全称:Texas Instruments 功能描述:RAD-TOLERANT CLASS V, WIDEBAND, FULLY DIFFERENTIAL AMPLIFIER
5962-0722301VFA 制造商:Texas Instruments 功能描述:SP Amp DIFF AMP Single ±2.5V/5V 16-Pin CFPAK Tube 制造商:Rochester Electronics LLC 功能描述: 制造商:Texas Instruments 功能描述:MIL SPEC TI IC PART
5962-0722401QXB 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:Rad-Hard 32 bit SPARC V8 Processor
5962-0722901QXA 功能描述:线性稳压器 - 标准 RoHS:否 制造商:STMicroelectronics 输出类型: 极性: 输出电压:1.8 V 输出电流:150 mA 负载调节: 最大输入电压:5.5 V 线路调整率: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOT-323-5L
5962-0722902QZA 制造商:Texas Instruments 功能描述:MICROCIRCUIT, VOLTAGE REGULATOR - Rail/Tube