- 您现在的位置：买卖IC网 > PDF目录97779 > 5962-0722301VFA (TEXAS INSTRUMENTS INC) OP-AMP, 5500 uV OFFSET-MAX, 3000 MHz BAND WIDTH, CDFP16 PDF资料下载
参数资料
| 型号： | 5962-0722301VFA |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 运算放大器 |
| 英文描述： | OP-AMP, 5500 uV OFFSET-MAX, 3000 MHz BAND WIDTH, CDFP16 |
| 封装： | CERAMIC, CFP-16 |
| 文件页数： | 18/30页 |
| 文件大小： | 1043K |
| 代理商： | 5962-0722301VFA |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页当前第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
www.ti.com
Layout Recommendations
SLOS539A – SEPTEMBER 2007 – REVISED OCTOBER 2007
decoupling capacitors should be placed as near
the power-supply pins as possible.
It is recommended to follow the layout of the external
6. Two 0.1
μF capacitors should be placed between
components
near
the
amplifier,
ground
plane
the CM input pins and ground. This limits noise
construction, and power routing of the EVM as
coupled into the pins. One each should be placed
closely as possible. General guidelines are:
to ground near pin 4 and pin 9.
1. Signal routing should be direct and as short as
7. It is recommended to split the ground pane on
possible into and out of the opamp circuit.
layer 2 (L2) as shown below and to use a solid
2. The feedback path should be short and direct
ground on layer 3 (L3). A single-point connection
avoiding vias.
should be used between each split section on L2
3. Ground or power planes should be removed from
and L3.
directly under the amplifier’s input and output
8. A single-point connection to ground on L2 is
pins.
recommended for the input termination resistors
4. An output resistor is recommended on each
R1 and R2. This should be applied to the input
output, as near to the output pin as possible.
gain resistors if termination is not used.
5. Two 10
μF and two 0.1 μF power-supply
Copyright 2007, Texas Instruments Incorporated
25
Product Folder Link(s): THS4513-SP
相关PDF资料 |
PDF描述 |
|---|---|
| 5962-7704301VCA | QUAD OP-AMP, 7000 uV OFFSET-MAX, 1.2 MHz BAND WIDTH, CDIP14 |
| 5962-86860012X | QUAD COMPARATOR, 5000 uV OFFSET-MAX, CQCC20 |
| 5962-8686001EX | QUAD COMPARATOR, 5000 uV OFFSET-MAX, 200 ns RESPONSE TIME, CDIP16 |
| 5962-8687701GA | COMPARATOR, 4000 uV OFFSET-MAX, 200 ns RESPONSE TIME, CQCC20 |
| 5962-8687701PA | COMPARATOR, 4000 uV OFFSET-MAX, 200 ns RESPONSE TIME, CQCC20 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 5962-0722401QXB | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:Rad-Hard 32 bit SPARC V8 Processor |
| 5962-0722901QXA | 功能描述:线性稳压器 - 标准 RoHS:否 制造商:STMicroelectronics 输出类型: 极性: 输出电压:1.8 V 输出电流:150 mA 负载调节: 最大输入电压:5.5 V 线路调整率: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOT-323-5L |
| 5962-0722902QZA | 制造商:Texas Instruments 功能描述:MICROCIRCUIT, VOLTAGE REGULATOR - Rail/Tube |
| 5962-0723001VXC | 制造商:Texas Instruments 功能描述:HIGH PERFORMANCE CLOCK SYNC - Rail/Tube |
| 5962-0724701VXA | 功能描述:数模转换器- DAC 14B,2.4 GSPS DAC RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。