参数资料
型号: 5962-89494022A
厂商: TEXAS INSTRUMENTS INC
元件分类: 运算放大器
英文描述: DUAL OP-AMP, 3750 uV OFFSET-MAX, 1.7 MHz BAND WIDTH, CQCC20
封装: CERAMIC, LCC-20
文件页数: 9/50页
文件大小: 1132K
代理商: 5962-89494022A
TLC272, TLC272A, TLC272B, TLC272Y, TLC277
LinCMOS
PRECISION DUAL OPERATIONAL AMPLIFIERS
SLOS091E – OCTOBER 1987 – REVISED FEBRUARY 2002
17
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
PARAMETER MEASUREMENT INFORMATION
input bias current
Because of the high input impedance of the TLC272 and TLC277 operational amplifiers, attempts to measure
the input bias current can result in erroneous readings. The bias current at normal room ambient temperature
is typically less than 1 pA, a value that is easily exceeded by leakages on the test socket. Two suggestions are
offered to avoid erroneous measurements:
1.
Isolate the device from other potential leakage sources. Use a grounded shield around and between the
device inputs (see Figure 4). Leakages that would otherwise flow to the inputs are shunted away.
2.
Compensate for the leakage of the test socket by actually performing an input bias current test (using
a picoammeter) with no device in the test socket. The actual input bias current can then be calculated
by subtracting the open-socket leakage readings from the readings obtained with a device in the test
socket.
One word of caution: many automatic testers as well as some bench-top operational amplifier testers use the
servo-loop technique with a resistor in series with the device input to measure the input bias current (the voltage
drop across the series resistor is measured and the bias current is calculated). This method requires that a
device be inserted into the test socket to obtain a correct reading; therefore, an open-socket reading is not
feasible using this method.
85
14
V = VIC
Figure 4. Isolation Metal Around Device Inputs
(JG and P packages)
low-level output voltage
To obtain low-supply-voltage operation, some compromise was necessary in the input stage. This compromise
results in the device low-level output being dependent on the common-mode input voltage level as well as the
differential input voltage level. When attempting to correlate low-level output readings with those quoted in the
electrical specifications, these two conditions should be observed. If conditions other than these are to be used,
please refer to Figures 14 through 19 in the Typical Characteristics of this data sheet.
input offset voltage temperature coefficient
Erroneous readings often result from attempts to measure temperature coefficient of input offset voltage. This
parameter is actually a calculation using input offset voltage measurements obtained at two different
temperatures. When one (or both) of the temperatures is below freezing, moisture can collect on both the device
and the test socket. This moisture results in leakage and contact resistance, which can cause erroneous input
offset voltage readings. The isolation techniques previously mentioned have no effect on the leakage since the
moisture also covers the isolation metal itself, thereby rendering it useless. It is suggested that these
measurements be performed at temperatures above freezing to minimize error.
相关PDF资料
PDF描述
5962-89503022A DUAL PULSE; RECTANGULAR, 1.2 MHz, TIMER, CQCC20
TLC556IDG4 DUAL PULSE; RECTANGULAR, 1.2 MHz, TIMER, PDSO14
TLC556MDRG4 DUAL PULSE; RECTANGULAR, 1.2 MHz, TIMER, PDSO14
TLC556MN DUAL PULSE; RECTANGULAR, 1.2 MHz, TIMER, PDIP14
TLC556MJ DUAL PULSE; RECTANGULAR, 1.2 MHz, TIMER, CDIP14
相关代理商/技术参数
参数描述
59628949403PA 制造商:TI 功能描述:*
5962-8949703MXA 制造商:Micross Components, Inc. 功能描述:256KX4 VRAM 400 MIL DIP - Tape and Reel
5962-89502012A 制造商:Rochester Electronics LLC 功能描述:- Bulk
5962-8950201GC 制造商:Intersil Corporation 功能描述:OP AMP SGL GP 15V 8PDIP - Bulk 制造商:Rochester Electronics LLC 功能描述:- Bulk
5962-89503012A 制造商:Texas Instruments 功能描述:Standard Timer Single 20-Pin LCCC Tube 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Texas Instruments 功能描述:STD TIMER SGL 20LCCC - Rail/Tube