- 您现在的位置：买卖IC网 > PDF目录67335 > 5962-9169201QXC (MAXIM INTEGRATED PRODUCTS INC) 2-CH 16-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL ACCESS, CDIP28 PDF资料下载
参数资料
| 型号： | 5962-9169201QXC |
| 厂商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分类： | ADC |
| 英文描述： | 2-CH 16-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL ACCESS, CDIP28 |
| 封装： | CERAMIC, DIP-28 |
| 文件页数： | 10/39页 |
| 文件大小： | 334K |
| 代理商： | 5962-9169201QXC |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页
MAX6954
The bit is cleared if the switch has not been detected
as pressed by the key-scanning circuit during the last
test. Reading a pressed register does not clear that
register or clear the IRQ output.
Display Test Register
The display test register (Table 36) operates in two
modes: normal and display test. Display test mode
turns all LEDs on (including DPs) by overriding, but not
altering, all controls and digit registers (including the
shutdown register), except for the digit-type register
and the GPIO configuration register. The duty cycle,
while in display test mode, is 7/16 (see the
Choosing
Supply Voltage to Minimize Power Dissipation section).
Selecting External Components RSET and
CSET to Set Oscillator Frequency and
Peak Segment Current
The RC oscillator uses an external resistor, RSET, and
an external capacitor, CSET, to set the frequency, fOSC.
The allowed range of fOSC is 1MHz to 8MHz. RSET also
sets the peak segment current. The recommended val-
ues of RSET and CSET set the oscillator to 4MHz, which
makes the blink frequencies selectable between 0.5Hz
and 1Hz. The recommended value of RSET also sets
the peak current to 40mA, which makes the segment
current adjustable from 2.5mA to 37.5mA in 2.5mA
steps.
ISEG = KL / RSET mA
fOSC = KF / (RSET x CSET) MHz
where:
KL = 2240
KF = 5376
RSET = external resistor in kΩ
CSET = external capacitor in pF
CSTRAY = stray capacitance from OSC pin to GND in
pF, typically 2pF
The recommended value of RSET is 56kΩ and the rec-
ommended value of CSET is 22pF.
The recommended value or RSET is the minimum
allowed value, since it sets the display driver to the
maximum allowed peak segment current. RSET can be
set to a higher value to set the segment current to a
lower peak value where desired. The user must also
ensure that the peak current specifications of the LEDs
connected to the driver are not exceeded.
The effective value of RSET includes not only the actual
external capacitor used, but also the stray capacitance
from OSC to GND. This capacitance is usually in the
1pF to 5pF range, depending on the layout used.
Applications Information
Driving Bicolor LEDs
Bicolor digits group a red and a green die together for
each display element, so that the element can be lit red
or green (or orange), depending on which die (or both)
is lit. The MAX6954 allows each segment’s current to
be set individually from the 1/16th (minimum current
and LED intensity) to 15/16th (maximum current and
LED intensity), as well as off (zero current). Thus, a
bicolor (red-green) segment pair can be set to 256
color/intensity combinations.
Choosing Supply Voltage to Minimize
Power Dissipation
The MAX6954 drives a peak current of 40mA into LEDs
with a 2.2V forward-voltage drop when operated from a
supply voltage of at least 3.0V. The minimum voltage
drop across the internal LED drivers is therefore (3.0V -
2.2V) = 0.8V. If a higher supply voltage is used, the dri-
ver absorbs a higher voltage, and the driver’s power
dissipation increases accordingly. However, if the LEDs
used have a higher forward voltage drop than 2.2V, the
supply voltage must be raised accordingly to ensure
that the driver always has at least 0.8V of headroom.
The voltage drop across the drivers with a nominal 5V
supply (5.0V - 2.2V) = 2.8V is nearly 3 times the drop
across the drivers with a nominal 3.3V supply (3.3V -
2.2V) = 1.1V. In most systems, consumption is an
important design criterion, and the MAX6954 should be
operated from the system’s 3.3V nominal supply. In
other designs, the lowest supply voltage may be 5V.
The issue now is to ensure the dissipation limit for the
MAX6954 is not exceeded. This can be achieved by
inserting a series resistor in the supply to the MAX6954,
ensuring that the supply decoupling capacitors are still
on the MAX6954 side of the resistor. For example, con-
sider the requirement that the minimum supply voltage
to a MAX6954 must be 3.0V, and the input supply
range is 5V ±5%. Maximum supply current is 35mA +
(40mA x 17) = 715mA. Minimum input supply voltage is
4.75V. Maximum series resistor value is (4.75V -
3.0V)/0.715A = 2.44Ω. We choose 2.2Ω ±5%. Worst-
case resistor dissipation is at maximum toleranced
resistance, i.e., (0.715A) 2 x (2.2Ω x 1.05) = 1.18W. The
maximum MAX6954 supply voltage is at maximum
input supply voltage and minimum toleranced resis-
tance, i.e., 5.25V - (0.715A x 2.2Ω x 0.95) = 3.76V.
Low-Voltage Operation
The MAX6954 works over the 2.7V to 5.5V supply
range. The minimum useful supply voltage is deter-
mined by the forward voltage drop of the LEDs at the
4-Wire Interfaced, 2.7V to 5.5V LED Display
Driver with I/O Expander and Key Scan
18
______________________________________________________________________________________
相关PDF资料 |
PDF描述 |
|---|---|
| 5962-9169301MCA | 4 CHANNEL, VIDEO AMPLIFIER, CDIP14 |
| 5962-9169401MCA | 1 CHANNEL, VIDEO AMPLIFIER, CDIP14 |
| 5962-9203101M2A | 1.5 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, CQCC20 |
| 5962-9203101MEA | 1.5 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, CDIP16 |
| 5962-9203103Q2A | 1.5 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, CQCC20 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 5962-9169301M2A | 制造商:Texas Instruments 功能描述:-LIFETIME BUYS TIL 03/03 |
| 5962-9169701MMA | 制造商:e2v Aerospace & Defense 功能描述:SMD MKD 87C51RC-16 PHI-JLCC |
| 5962-9169701MUA | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Intel 功能描述: |
| 5962-9169702MUA | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| 5962-9172201MEA | 制造商:e2v 功能描述:Counter Single 4-Bit Binary UP 16-Pin CDIP 制造商:e2v technologies 功能描述:Counter Single 4-Bit Binary UP 16-Pin CDIP |
发布紧急采购，3分钟左右您将得到回复。