参数资料
型号: 73S1209F-44IMR/F/P
厂商: Maxim Integrated Products
文件页数: 94/123页
文件大小: 0K
描述: IC SMART CARD READER PROG 44-QFN
产品培训模块: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
标准包装: 2,500
系列: 73S12xx
核心处理器: 80515
芯体尺寸: 8-位
速度: 24MHz
连通性: I²C,智能卡,UART/USART
外围设备: LED,POR,WDT
输入/输出数: 9
程序存储器容量: 32KB(32K x 8)
程序存储器类型: 闪存
RAM 容量: 2K x 8
电压 - 电源 (Vcc/Vdd): 2.7 V ~ 5.5 V
振荡器型: 内部
工作温度: -40°C ~ 85°C
封装/外壳: 44-VFQFN 裸露焊盘
包装: 带卷 (TR)
73S1209F Data Sheet
DS_1209F_004
Figure 15: Asynchronous Activation Sequence Timing
VCC
IO
RST
CLK
t1
t2
t3
t4
t5
Firmware sets
VCCSEL to 00
CMDVCCnB
t5 delay or
Card Event
t1: Time after either a “card event” occurs or firmware sets the VCCSela and VCCSelb bits to 0 (see
t5, VCCOff_tmr) occurs until RST is asserted low.
t2: Time after RST goes low until CLK stops.
t3: Time after CLK stops until IO goes low.
t4: Time after IO goes low until VCC is powered down.
t5: Delayed VCC off time (in ETUs per VCCOff_tmr bits). Only in effect due to firmware deactivation.
Figure 16: Deactivation Sequence
1.7.13.3 Data Reception/Transmission
When a 12Mhz crystal is used, the smart card UART will generate a 3.69Mhz (default) clock to both
smart card interfaces. This will allow approximately 9600bps (1/ETU) communication during ATR (ISO
7816 default). As part of the PPS negotiation between the smart card and the reader, the firmware may
determine that the smart card parameters F & D may be changed. After this negotiation, the firmware
may change the ETU by writing to the SFR FDReg to adjust the ETU and CLK. The firmware may also
change the smart card clock frequency by writing to the SFR SCCLK (SCECLK for external interface).
Independent clock frequency control is provided to each smart card interface. Clock stop high or Clock
stop low is supported in asynchronous mode. Figure 17 shows the ETU and CLK control circuits. The
firmware determines when clock stop is supported by the smart card and when it is appropriate to go into
that mode (and when to come out of it). The smart card UART is clocked by the same clock that is
provided to the selected smart card. The transition between smart card clocks is handled in hardware to
eliminate any glitches for the UART during switchover. The external smart card clock is not affected
when switching the UART to communicate with the internal smart card.
72
Rev. 1.2
相关PDF资料
PDF描述
73S1209F-44IM/F/P IC SMART CARD READER PROG 44-QFN
AKSPT-G-BLU-R CONN SHUNT 2.54MM GOLD 6.0MM BLU
AKSNT-Z-RED-R CONN SHUNT 2.54MM TIN 4.5MM RED
AKSNT-Z-BLUE-R CONN SHUNT 2.54MM TIN 4.5MM BLUE
EDJ4G0 SHUNT .100" BLACK W/HANDLE
相关代理商/技术参数
参数描述
73S1209F-44M/F/PD 功能描述:8位微控制器 -MCU RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
73S1209F-44MR/F/PD 功能描述:8位微控制器 -MCU RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
73S1209F-68IM/F 功能描述:8位微控制器 -MCU Contained 80515-Soc Serial Hst Interface RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
73S1209F-68IM/F/P 功能描述:IC SMART CARD READER PROG 68-QFN RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微控制器, 系列:73S12xx 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:260 系列:73S12xx 核心处理器:80515 芯体尺寸:8-位 速度:24MHz 连通性:I²C,智能卡,UART/USART,USB 外围设备:LED,POR,WDT 输入/输出数:9 程序存储器容量:64KB(64K x 8) 程序存储器类型:闪存 EEPROM 大小:- RAM 容量:2K x 8 电压 - 电源 (Vcc/Vdd):2.7 V ~ 5.5 V 数据转换器:- 振荡器型:内部 工作温度:-40°C ~ 85°C 封装/外壳:68-VFQFN 裸露焊盘 包装:管件
73S1209F-68IMR/F 功能描述:8位微控制器 -MCU Contained 80515-SoC Serial Hst Interface RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT