- 您现在的位置：买卖IC网 > PDF目录222833 > 74017 (Skyworks Solutions Inc.) On the Direct Conversion Receiver PDF资料下载
参数资料
| 型号： | 74017 |
| 厂商： | Skyworks Solutions Inc. |
| 英文描述： | On the Direct Conversion Receiver |
| 中文描述： | 在直接转换接收器 |
| 文件页数： | 5/10页 |
| 文件大小： | 315K |
| 代理商： | 74017 |
CX74017
On the Direct Conversion Receiver
4
Skyworks Solutions, Inc., Proprietary and Confidential
101735A
Preliminary Data Subject to Change
July 20, 2001
101735A 6_071801
RF band-select
filter
LNA
Wideband filter
RF
IF
RF
DC
0f
f
Wideband IF
f
0
LPF
Image-reject
filter
Figure 6. Wideband IF with Double Conversion.
Direct Conversion Receivers
Direct conversion reception, also referred to as homodyne, or
zero-IF, shown in Figure 7, is the most natural solution to
receiving information vehicled by a carrier. However, it has only
been a decade or so that this type of reception has found
applications other than pagers, for example [13]. For it has
several qualities which make it very suitable for integration as
well as multi-band, multi-standard operation, but severe inherent
obstacles that had for long kept it in the shadow of the
superheterodyne.
RF band-select
filter
LNA
RF
DC
LPF
RF
f
DC
0f
LPF
101735A 7_071801
Figure 7. The Direct Conversion Receiver
First, the image problem is no longer present, since the IF is
zero and the image to the desired channel, for all but single-
sideband signals, is the channel itself. Then, only one LO is
needed, which means only one phase noise contribution. The
need for the bulky, off-chip filters is consequently removed.
Filtering now only occurs at low, that is, baseband, frequencies
with some amplification. This means less current consumption
than at higher frequencies (to drive device parasitics), fewer
components, lower cost, etc. Practically, however, strong out-of-
band interferers or blockers may need to be removed prior to
downconversion in order to avoid desensitizing the receiver by
saturating subsequent stages, as well as producing harmonics
and intermodulation terms, which then appear in baseband.
Such a filter may be placed after the LNA, for example.
DCR, however, brings its own set of issues. The following
paragraphs describe those in more detail.
DC offsets
In direct conversion, as the signal of interest is converted to
baseband very early in the receive chain, without any filtering
other than RF band-selection, various phenomena contribute to
the creation of DC signals, which are directly appearing as
interfering signals in the band of interest.
The LO may be conducted or radiated through an unintended
path to the mixer’s RF input port, thus effectively mixing with
itself, producing an unwanted DC component at the mixer
output, see Figure 8.
Worse still, this LO leakage may reach the LNA input, producing
an even stronger result. This effect presents a high barrier
against the integration of LO, mixer, and LNA on a single silicon
substrate, where numerous mechanisms can contribute to poor
isolation. These include substrate coupling, ground bounce,
bond wire radiation, and capacitive and magnetic coupling.
相关PDF资料 |
PDF描述 |
|---|---|
| 74048-000024A | 24 CONTACT(S), FEMALE, RIGHT ANGLE FFC/FPC CONNECTOR, SOLDER |
| 745075-1 | 50 CONTACT(S), MALE, D SUBMINIATURE CONNECTOR, SOLDER |
| 745075-2 | 50 CONTACT(S), MALE, D SUBMINIATURE CONNECTOR, SOLDER |
| 745075-4 | 50 CONTACT(S), MALE, D SUBMINIATURE CONNECTOR, SOLDER |
| 745075-5 | 50 CONTACT(S), MALE, D SUBMINIATURE CONNECTOR, SOLDER |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 74017-16-61P | 制造商:TE Connectivity / Deutsch 功能描述: |
| 74018 | 功能描述:BIT PWR SLOT 1/4" HEX 6.5MM 50MM RoHS:否 类别:工具 >> 螺钉和螺母驱动器 - 刀片和位 系列:- 标准包装:1 系列:TorqueVario™ 类型:十字槽刀片 尺寸:#2 长度:7.48"（190mm） 特点:绝缘达 10,000V 重量:0.07 磅（31.75g） |
| 74018-10-19P | 功能描述:RECP ASSY 制造商:te connectivity deutsch connectors 系列:* 零件状态:在售 标准包装:25 |
| 74018-10-19P [V003] | 功能描述:RECP ASSY 制造商:te connectivity deutsch connectors 系列:* 零件状态:在售 标准包装:25 |
| 74018-14-44SX | 制造商:TE Connectivity / Deutsch 功能描述:RECEPTACLE CONNECTOR |
发布紧急采购，3分钟左右您将得到回复。