- 您现在的位置：买卖IC网 > PDF目录163730 > 88EM8081XX-SAG2C000-T (MARVELL SEMICONDUCTOR INC) 2 A POWER FACTOR CONTROLLER, 120 kHz SWITCHING FREQ-MAX, PDSO8 PDF资料下载
参数资料
| 型号： | 88EM8081XX-SAG2C000-T |
| 厂商： | MARVELL SEMICONDUCTOR INC |
| 元件分类： | 稳压器 |
| 英文描述： | 2 A POWER FACTOR CONTROLLER, 120 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封装： | GREEN, SOIC-8 |
| 文件页数： | 16/64页 |
| 文件大小： | 667K |
| 代理商： | 88EM8081XX-SAG2C000-T |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页当前第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页
Functional Description
ISNS – Current Sensing / Over Current Protection
Copyright 2010 Marvell
Doc. No. MV-S106340-01 Rev. B
August 6, 2010, Preliminary Information
Document Classification: Proprietary
Page 23
It is important to note that the IC has internal compensation for the loop stability. There is no need for
external compensation.
3.6.2.4
Output Voltage Regulation - Non-isolated Output
When non-isolated, an opto-isolator is not necessary. The output voltage is sensed through the
output divider and the output of the divider is connected directly to the feedback pin FB. The IC then
controls the output voltage in the same way as for the isolated case. It is important to note that the IC
has internal compensation for the loop stability.
3.7
ISNS
– Current Sensing / Over Current Protection
3.7.1
ISNS – Peak Current Sensing
The 88EM8080/88EM8081 LED driver provides power factor correction (PFC) in addition to
providing regulation. Regarding the PFC function, the average input current is varied to be
proportional to the input voltage. This way the average input current will be sinusoidal. This input
current is the same as the primary MOSFET current in a flyback circuit. Therefore, the IC can sense
the MOSFET current and then use average current mode control to implement the PFC function.
The voltage across the resistor in series with MOSFET (connected between MOSFET source pin
and bridge diode negative DC terminal) is used as primary current sensing signal. The primary
MOSFET source pin is grounded to apply a PWM signal between the gate and the source. The
current sense signal in series MOSFET source therefore becomes negative with respect to ground.
The IC uses this negative signal for input current control to provide the PFC function.
3.7.2
ISNS – Average Current Mode Control
The voltage across the primary current sense resistor is proportional to the peak value of switching
current. An RC filter can be used to provide the average current. The output of the RC filter is then
applied to ISNS pin. The internal current loop adjusts the duty cycle so that average current is
sinusoidal. The amplitude of the sinusoidal current is adjusted by the external voltage/current loop to
achieve constant output load voltage/current.
3.7.3
ISNS – Adaptive Over Current Protection
The average current signal at the output of the RC filter is also used for over current protection. The
IC has an internal current comparator with four different internal thresholds for current protection on
ISNS pin as the input voltage signal varies. The input current varies inversely with the AC input
voltage. There are four different OCP thresholds at four different input voltage ranges. The different
Characteristics, on page 16. With these four adaptive over current protection steps the IC provides
almost constant power protection over the entire AC input voltage range.
3.7.4
OCP – Cycle by Cycle Over Current Protection
The voltage across the primary current sense resistor is proportional to the peak value of switching
current. This voltage can be used for cycle by cycle over current protection by the OCP pin. When
the OCP pin is pulled low the IC will shut down and there is no switched output signal at SW pin.
相关PDF资料 |
PDF描述 |
|---|---|
| 890-001-9PA1-2C2-18T | 9 CONTACT(S), MALE, D NANOMINIATURE CONNECTOR, CRIMP, PLUG |
| 890-001-15PA2-2C7-18T | 15 CONTACT(S), MALE, D NANOMINIATURE CONNECTOR, CRIMP, PLUG |
| 890-001-25PA2-2C2-18T | 25 CONTACT(S), MALE, D NANOMINIATURE CONNECTOR, CRIMP, PLUG |
| 890-001-51PA1-2A1-18T | 51 CONTACT(S), MALE, D NANOMINIATURE CONNECTOR, CRIMP, PLUG |
| 890-001-9PA2-2A1-18T | 9 CONTACT(S), MALE, D NANOMINIATURE CONNECTOR, CRIMP, PLUG |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 88EM8082A1-SAG2C000 | 制造商:Marvell 功能描述:?ACTIVE PFC CONTROLLER FOR AC-DC FLYBACK LED APPLICATIONS - Bulk 制造商:Marvell 功能描述:88EM8082 Series - Single-Stage 120 kHz Fly-back AC/DC LED Driver - SOIC-8 |
| 88EM8182B0-SAE2C000-AL00 | 制造商:Marvell 功能描述:?NON-DIMMABLE, TRIAC AC/DC LED DRIVER, 110V/220V, LOW VOLTAG - Trays |
| 88EM8182B0-SAE2C000TAL00 | 制造商:Marvell 功能描述:?NON-DIMMABLE; TRIAC AC/DC LED DRIVER; 110V/220V; LOW VOLTAG - Tape and Reel 制造商:Marvell 功能描述:88EM8182 Series - Fly-back Non-Dimmable LED Driver 110V/220V - 8-Pin SOIC |
| 88EM8183B0-SAE2C000-AL00 | 制造商:MARVELL 功能描述:0 |
| 88EM8183B0-SAE2C000TAL00 | 制造商:Marvell 功能描述:?DIMMABLE; TRIAC AC/DC LED DRIVER; 110V/220V; LOW VOLTAGE + - Tape and Reel 制造商:Marvell 功能描述:Marvell 88EM8183 Series 19V Universal Triac Dimmable LED Driver - SOIC-8 |
发布紧急采购，3分钟左右您将得到回复。