- 您现在的位置：买卖IC网 > PDF目录24858 > 94227AFLFT (INTEGRATED DEVICE TECHNOLOGY INC) 200 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO48 PDF资料下载
参数资料
| 型号： | 94227AFLFT |
| 厂商： | INTEGRATED DEVICE TECHNOLOGY INC |
| 元件分类： | 时钟产生/分配 |
| 英文描述： | 200 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO48 |
| 封装： | 0.300 INCH, GREEN, MO-118, SSOP-48 |
| 文件页数： | 7/18页 |
| 文件大小： | 151K |
| 代理商： | 94227AFLFT |
15
ICS94227
0446B—12/20/02
Fig. 1
Shared Pin Operation -
Input/Output Pins
The I/O pins designated by (input/output) on the ICS94227
serve as dual signal functions to the device. During initial
power-up, they act as input pins. The logic level (voltage)
that is present on these pins at this time is read and
stored into a 5-bit internal data latch. At the end of Power-
On reset, (see AC characteristics for timing values), the
device changes the mode of operations for these pins to
an output function. In this mode the pins produce the
specified buffered clocks to external loads.
To program (load) the internal configuration register for
these pins, a resistor is connected to either the VDD
(logic 1) power supply or the GND (logic 0) voltage
potential. A 10 Kilohm (10K) resistor is used to provide
both the solid CMOS programming voltage needed during
the power-up programming period and to provide an
insignificant load on the output clock during the subsequent
operating period.
Via to
VDD
Clock trace to load
Series Term. Res.
Programming
Header
Via to Gnd
Device
Pad
2K
W
8.2K
W
Figure 1 shows a means of implementing this function
when a switch or 2 pin header is used. With no jumper is
installed the pin will be pulled high. With the jumper in
place the pin will be pulled low. If programmability is not
necessary, than only a single resistor is necessary. The
programming resistors should be located close to the
series termination resistor to minimize the current loop
area. It is more important to locate the series termination
resistor close to the driver than the programming resistor.
相关PDF资料 |
PDF描述 |
|---|---|
| 94227AFLF | 200 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO48 |
| 08052R102K9AB | KONDENSATOR 1000PF 50V 10ST |
| 08052R103K9AB | KONDENSATOR 0.01UF 50V 10ST |
| 08052R222K9AB | KONDENSATOR 2200PF 50V 10ST |
| 08052R472K9AB | KONDENSATOR 4700PF 50V 10ST |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 9422810001 | 制造商:TE Connectivity 功能描述:Cable Markers Cross Linked Polyolefin White Pack 制造商:TE Connectivity 功能描述:TMS-SCE-3/8-2.0-9 制造商:TE Connectivity 功能描述:MARKER SLEEVE POLYFN WH - Cable Rools/Shrink Tubing 制造商:RAYCHEM / TYCO ELEC 功能描述:Cross Referenced to RAYCHEM / TYCO ELECTRONICS - Part: RYCTMS-SCE-3/8-2.0-9 |
| 942281N002 | 制造商:TE Connectivity 功能描述:942281N002 |
| 942281N003 | 制造商:TE Connectivity 功能描述:Cable Accessories Marker Sleeve Pink 制造商:TE Connectivity 功能描述:TMS-SCE-3/8-2.0-9-CS7333 - Bulk |
| 94228BFLF | 制造商:Integrated Device Technology Inc 功能描述:94228BFLF - Rail/Tube 制造商:IDT 功能描述:IDT 94228BFLF PLL |
| 94228BFLFT | 制造商:Integrated Device Technology Inc 功能描述:PROGRAMMABLE PLL CLOCK GEN DUAL 48SSOP - Tape and Reel |
发布紧急采购，3分钟左右您将得到回复。