参数资料
| 型号： | A1240A-1PG132C |
| 厂商： | Microsemi SoC |
| 文件页数： | 2/54页 |
| 文件大小： | 0K |
| 描述： | IC FPGA 4K GATES 132-CPGA COM |
| 标准包装： | 21 |
| 系列： | ACT™ 2 |
| LAB/CLB数： | 684 |
| 输入/输出数： | 104 |
| 门数： | 4000 |
| 电源电压： | 4.5 V ~ 5.5 V |
| 安装类型： | 通孔 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 132-BCPGA |
| 供应商设备封装： | 132-CPGA（34.54x34.54） |
第1页当前第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页
Detailed Specifications
2- 4
R e v ision 8
Static Power Component
Microsemi FPGAs have small static power components that result in lower power dissipation than PALs
or PLDs. By integrating multiple PALs/PLDs into one FPGA, an even greater reduction in board-level
power dissipation can be achieved.
The power due to standby current is typically a small component of the overall power. Standby power is
calculated in Table 2-5 for commercial, worst case conditions.
The static power dissipated by TTL loads depends on the number of outputs driving high or low and the
DC load current. Again, this value is typically small. For instance, a 32-bit bus sinking 4 mA at 0.33 V will
generate 42 mW with all outputs driving low, and 140 mW with all outputs driving high. The actual
dissipation will average somewhere between as I/Os switch states with time.
Active Power Component
Power dissipation in CMOS devices is usually dominated by the active (dynamic) power dissipation. This
component is frequency dependent, a function of the logic and the external I/O. Active power dissipation
results from charging internal chip capacitances of the interconnect, unprogrammed antifuses, module
inputs, and module outputs, plus external capacitance due to PC board traces and load device inputs.
An additional component of the active power dissipation is the totem-pole current in CMOS transistor
pairs. The net effect can be associated with an equivalent capacitance that can be combined with
frequency and voltage to represent active power dissipation.
Equivalent Capacitance
The power dissipated by a CMOS circuit can be expressed by EQ 3.
Power (W) = CEQ * VCC2 * F
EQ 3
Where:
CEQ is the equivalent capacitance expressed in pF.
VCC is the power supply in volts.
F is the switching frequency in MHz.
Equivalent capacitance is calculated by measuring ICC active at a specified frequency and voltage for
each circuit component of interest. Measurements have been made over a range of frequencies at a
fixed value of VCC. Equivalent capacitance is frequency independent so that the results may be used
over a wide range of operating conditions. Equivalent capacitance values are shown in Table 2-6.
Table 2-5 Standby Power Calculation
ICC
VCC
Power
2 mA
5.25 V
10.5 mW
Table 2-6 CEQ Values for Microsemi FPGAs
Item
CEQ Value
Modules (CEQM)
5.8
Input Buffers (CEQI)
12.9
Output Buffers (CEQO)
23.8
Routed Array Clock Buffer Loads (CEQCR)3.9
相关PDF资料 |
PDF描述 |
|---|---|
| 170-050-172L000 | CONN DB50 CRIMP MALE TIN |
| APA750-PQG208A | IC FPGA PROASIC+ 750K 208-PQFP |
| N25S830HAS22I | IC SRAM 256KBIT 20MHZ 8SOIC |
| 180-062-173L030 | CONN DB62 MALE HD CRIMP NICKEL |
| 180-062-173L020 | CONN DB62 MALE HD CRIMP NICKEL |
相关代理商/技术参数 |
参数描述 |
|---|---|
| A1240A-1PG132M | 制造商:Microsemi Corporation 功能描述:FPGA ACT 2 4K GATES 684 CELLS 110MHZ 1.0UM 5V 132CPGA - Trays 制造商:Microsemi Corporation 功能描述:IC FPGA 4K GATES 132-CPGA MIL 制造商:Microsemi Corporation 功能描述:IC FPGA 104 I/O 132CPGA |
| A1240A-1PG160B | 制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:ACT 2 Family FPGAs |
| A1240A-1PG160C | 制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:ACT 2 Family FPGAs |
| A1240A-1PG160I | 制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:ACT 2 Family FPGAs |
| A1240A-1PG160M | 制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:ACT 2 Family FPGAs |
发布紧急采购，3分钟左右您将得到回复。