- 您现在的位置：买卖IC网 > PDF目录20235 > A4401KLTR-T (Allegro Microsystems Inc)IC QUASI FLYBACK CONVERTER 8SOIC PDF资料下载
参数资料
| 型号： | A4401KLTR-T |
| 厂商： | Allegro Microsystems Inc |
| 文件页数： | 12/17页 |
| 文件大小： | 0K |
| 描述： | IC QUASI FLYBACK CONVERTER 8SOIC |
| 标准包装： | 1 |
| 显示器类型： | 真空荧光 (VF) |
| 电流 - 电源： | 2.3mA |
| 电源电压： | 7 V ~ 40 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SOICN |
| 包装： | 标准包装 |
| 产品目录页面： | 1141 (CN2011-ZH PDF) |
| 其它名称： | 620-1217-6 |
A4401
Automotive Quasi-Resonant Flyback Control IC
I RMS = I PK × ? ?
? ?
? D ' ? ?
(32)
where I OUT is the maximum load current, and D'(max)
is the duty cycle, limited to 0.3.
Then the rms current in the winding is:
,
? 3 ?
Because the number of turns has already been worked
out, the ampere-turns factor can now be determined.
C11 Resonant Capacitor Selection
The resonance that occurs when the MOSFET, Q1,
turns off is formed by the interaction of the primary
magnetizing inductance and the capacitance between
the LX node (the drain terminal of the MOSFET) and
ground. The design is optimized for a half resonant
period of 1 μ s. This means the resonant capacitor
value can be found from the following formula:
C RES = ? ? R
? ? ×
?
?
After all of the ampere-turns are known for each wind-
ing, the bobbin window can be apportioned to each
winding. It is recommended that the current density in
? T ? 2 1
,
L PRI
where T R is a half resonant period of 1 μ s.
(34)
each winding should be kept below 5 A per mm 2 .
Another consideration when selecting the wire gauge
is the skin depth (depth within which the current
flows), especially at higher frequencies. Skin depth
can be calculated as:
It is advisable to measure the half resonant period in
the application, as the parasitic capacitance between
the LX node and ground can be substantial and may
even be sufficient to meet the requirements with very
little additional capacitance.
δ =
f
75
?
SW
,
(33)
PCB Layout Guidelines
The layout can be considered as two blocks: primary
For example, if 45 kHz were the minimum frequency
at minimum input voltage and maximum load, then
to ensure maximum wire utilization for the first four
switching harmonics, the switching frequency would
be 180 kHz. The conduction depth at 180 kHz would
and secondary:
Primary Block To minimize parasitic noise appearing
on the ground return, and at the LX and ISS nodes,
as well as to maximize the effectiveness of the EMI
equal 0.18 mm, therefore, the wire diameter should
not exceed 0.36 mm. For any particular winding, if the
current rating of the wire is insufficient even though
the wire meets the skin depth criteria, multiple wires
wound in parallel will be necessary.
It is recommended to locate the start and finish of
each winding as close as possible on the bobbin. This
minimizes the “loop area” and reduces the effects of
V BAT
C IN
L PRI
A4401
LX node
MOSFET
Q1
ISS node
R SENSE
noise pick-up.
When winding the high voltage windings, such as for
the anode or grid, it is advisable to insert a layer of
polyester insulating tape between each layer as well as
between adjacent windings.
Figure 3. Main power loop
Minimize this loop area
Allegro MicroSystems, LLC
115 Northeast Cutoff, Box 15036
12
Worcester, Massachusetts 01615-0036 (508) 853-5000
www.allegromicro.com
相关PDF资料 |
PDF描述 |
|---|---|
| 2-530655-3 | CONN HSNG CARDEDGE 12DL POS .156 |
| VE-J3P-CX-B1 | CONVERTER MOD DC/DC 13.8V 75W |
| PCF2111CT/1,112 | IC LCD DRIVER 64SEG 40-VSOP |
| 2-530654-9 | CONN HSNG CARDEDGE 30POS .156 |
| PCF2111CT/1,118 | IC LCD DRIVER 64SEG 40-VSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| A4402 | 制造商:ALLEGRO 制造商全称:Allegro MicroSystems 功能描述:Constant On-Time Buck Converter with Integrated Linear Regulator |
| A4402_1 | 制造商:ALLEGRO 制造商全称:Allegro MicroSystems 功能描述:Constant On-Time Buck Converter with Integrated Linear Regulator |
| A4402_12 | 制造商:ALLEGRO 制造商全称:Allegro MicroSystems 功能描述:The A4402 is a dual-output regulator, combining in a single package a constant on-time buck regulator and a linear regulator (LDO)a??each with adjustable output voltages. |
| A4402ELPTR-T | 功能描述:IC REG DL BUCK/LINEAR 16-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压（降压）同步（3），线性（LDO）（2） 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:* |
| A4402KLPTR-T | 功能描述:IC REG DL BUCK/LINEAR 16-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压（降压）同步（3），线性（LDO）（2） 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:* |
发布紧急采购，3分钟左右您将得到回复。