参数资料
型号: A4941GLPTR-T
厂商: Allegro Microsystems Inc
文件页数: 5/9页
文件大小: 0K
描述: IC MOTOR DRIVER 3PH 16-TSSOP
标准包装: 1
系列: *
应用: *
输出数: *
电流 - 输出: *
电压 - 负载: *
电源电压: *
工作温度: *
安装类型: 表面贴装
封装/外壳: 16-TSSOP(0.173",4.40mm)裸露焊盘
供应商设备封装: 16-TSSOP-EP
包装: 标准包装
其它名称: 620-1357-6
A4941
the commutation delay period, a CDCOM is asserted, starting
the Blank timer. The Blank signal disables the BEMF detector so
the comparator is not active during the commutation transients.
The next zero crossing, detected on the tri-stated output, causes
FCOM to go high. This triggers the Commutation Delay timer
and the sequence repeats.
CTAP
Connection pin for motor center-tap if available. If not available
(such as with delta type motors), the null point will be generated
internally.
Startup
At startup, commutations are provided by an onboard oscillator.
These commutations are part of the startup scheme, to step the
Three-Phase Sensorless Fan Driver
? PWM also can be used as a control input to start and stop the
motor.
? For PWM applications, input frequencies in the range
15 to 30 kHz are applied directly to the motor windings. If the
PWM duty cycle is very small, then the IC will apply a mini-
mum pulse width of typically 6 μ s. This minimum pulse width
effects the minimum speed. As a result of having a minimum
pulse width, the IC can startup and operate down to very short
duty cycles.
SLEW Input
Enables or disables soft switching by connection as follows:
motor to generate BEMF until legitimate BEMF zero crossings
are detected and normal BEMF sensing commutation is achieved.
Until an appropriate number of FCOM pulses are achieved (96),
100% PWM will be applied to the motor windings.
SLEW Pin Connection
GND
Open
Soft Start Status
Enabled
Disabled
Standby Mode
Driving PWM low for 500 μ s causes the IC to enter a low power
standby mode.
FC Input
This is the logic input to set force commutation time at startup, by
connection as follows:
Lock Detect
Valid FCOM signals must be detected to ensure the motor is not
stalled. If a valid FG is not detected for 2 s, the outputs will be
disabled for 5 s before an auto-restart is attempted.
FG Output
The FG output provides fan speed information to the system.
FC Pin Connection
GND
VBB
Open
Startup Commutation Time
(ms)
100
50
200
FG is an open drain output.
PWM Input
The duty cycle applied to the PWM pin is translated directly
to an average duty cycle applied across the motor windings
to control speed.
? For voltage controlled applications, where V BB controls the
speed, PWM can be left open circuit. PWM is internally pulled-
up to logic high level.
Overcurrent Protection
If needed, a sense resistor can be installed to limit current. (See
Applications Information section for more details.) The current
limit trip point would be set by:
I OCL = 200 mV / R S .
When the trip point is reached, if the threshold voltage, V OCL , is
exceeded, the drivers will be disabled for 25 μ s.
Allegro MicroSystems, LLC
115 Northeast Cutoff
Worcester, Massachusetts 01615-0036 U.S.A.
1.508.853.5000; www.allegromicro.com
5
相关PDF资料
PDF描述
A4950KLJTR-T IC MOTOR DVR FULL-BRIDGE 8-SOIC
A4954ELPTR-T IC PWM MOTOR DVR DUAL 16-ETSSOP
A4960KJPTR-T IC BLDC CTLR BRUSHLESS 32LQFP
A4970SLBTR-T IC PWM MOTOR DVR FULL 24-SOICW
A4973SLBTR-T IC PWM MOTOR DVR FULL 16SOIC
相关代理商/技术参数
参数描述
A4942GESTR-T 功能描述:IC MOTOR FAN DRIVER 3PHASE QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电机和风扇控制器,驱动器 系列:- 标准包装:1 系列:- 应用:直流电机驱动器,步进电机驱动器 评估套件:- 输出数:1 或 2 电流 - 输出:750mA 电压 - 负载:10 V ~ 40 V 电源电压:4.5 V ~ 5.5 V 工作温度:-20°C ~ 70°C 安装类型:表面贴装 封装/外壳:24-BFSOP(0.295",7.50mm 宽) 供应商设备封装:24-SOP 包装:Digi-Reel® 其它名称:MTS62C19A-HS105DKR
A4944GLPTR-T 制造商:Allegro MicroSystems LLC 功能描述:IC FAN DVR BLDC HALL 16TSSOP
A4945GLJTR-T 制造商:ALLEGRO 功能描述:Sensorless Sinusoidal Bldc Fan Driver w/Analog Speed Ctrl
A4945GLTR-T 制造商:ALLEGRO 功能描述:Sensorless Sinusoidal Bldc Fan Driver w/Analog Speed Ctrl 制造商:Allegro MicroSystems LLC 功能描述:Sensorless Sinusoidal Bldc Fan Driver w/Analog Speed Ctrl
A4945KLJTR-T 功能描述:IC FAN DRIVER BLDC 8SOIC 制造商:allegro microsystems, llc 系列:* 零件状态:有效 标准包装:3,000