参数资料
| 型号： | AD215AY |
| 厂商： | Analog Devices Inc |
| 文件页数： | 2/12页 |
| 文件大小： | 0K |
| 描述： | IC AMP ISOL LDIST 5MA 44SIP |
| 标准包装： | 1 |
| 放大器类型： | 隔离 |
| 电路数： | 1 |
| 转换速率： | 6 V/µs |
| -3db带宽： | 120kHz |
| 电流 - 输入偏压： | 300pA |
| 电压 - 输入偏移： | 400µV |
| 电流 - 电源： | 40mA |
| 电流 - 输出 / 通道： | 5mA |
| 电压 - 电源，单路/双路(±)： | ±14.25 V ~ 17 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 通孔 |
| 封装/外壳： | 44-SIP，12 引线，偏移引线 |
| 供应商设备封装： | 12-SIP |
| 包装： | 管件 |
AD215
REV. 0
–10–
When gain setting resistors are used, 0.325" channel centers can
still be achieved as shown in Figure 20b.
RG
R
F
C
F
C2
C1
1
2
3
4
5
6
IN
IN COM
+VISO
–VISO
C1, C2 ARE V
ISO FILTER CAPACITORS.
R
F, RG ARE FEEDBACK, GAIN RESISTORS.
C
F IS A FEEDBACK BYPASS CAPACITOR.
RG
R
F
C
F
C2
C1
1
2
3
4
5
6
IN
IN COM
+VISO
–VISO
Figure 20b. PCB Layout for Gain Greater than Unity
APPLICATIONS EXAMPLES
Motor Control
Figure 21 shows an AD215 used in a dc motor control applica-
tion. Its excellent phase characteristics and wide bandwidth are
ideal for this type of application.
1
3
4
38
37
AD215
MOTOR
COMMAND
±10 VOLTS
2
COM
G = 1
ISOLATED
MOTOR
COMMAND
±10V V
C
OUT LO
SHAFT
θ
IMOTOR
MOTOR
OPTICAL
RESOLVER
OR
TACHOMETER
ENCODER
ENCODER FEEDBACK
MOTOR
CONTROL
UNIT
Figure 21. Motor Control Application
Multichannel Data Acquisition
The current drive capabilities of the AD215’s bipolar
±15 V dc
isolated power supply is more than adequate to meet the modest
±800 A supply current requirements for the AD7502 multi-
plexer. Digital isolation techniques should be employed to iso-
late the Enable (EN), A0 and A1 logic control signals.
IN+
IN–
FB
IN COM
OUT HI
OUT LO
1
3
4
AD215
PWR
RTN
–15V
+15V
+VISO
–VISO
6.8F
6
6.8F
G = 1
42
38
(–15V)
GND
(+15V)
EN
A1
A0
AD7502
37
2
5
2
COM
43
44
S1 – S4
S5 – S8
DTL/TTL TO CMOS LEVEL
TRANSLATOR
DECODER/DRIVER
Figure 22. Multichannel Data Acquisition Application
AC Transducer Applications
In applications such as vibration analysis, where the user must
acquire and process the spectral content of a sensor’s signal
rather than its “dc” level, the wideband characteristics of the
AD215 prove most useful. Key specifications for ac transducer
applications include bandwidth, slew rate and harmonic distor-
tion. Since the transducer may be mechanically bonded or
welded to the object under test, isolation is typically required to
eliminate ground loops as well as protect the electronics used in
the data acquisition system. Figure 23 shows an isolated strain
gage circuit employing the AD215 and a high speed operational
amplifier (AD744).
To alleviate the need for an instrumentation amplifier, the
bridge is powered by a bipolar excitation source. Under this ap-
proach the common-mode voltage is
±V
SPAN which is typically
only a few millivolts, rather than the VEXC
2 that would be
achieved with a unipolar excitation source and Wheatstone
bridge configuration.
Using two strain gages with a gage factor of 3 mV/V and a
±1.2 V excitation signal, a ±6.6 mV output signal will result. A
gain setting of 454 will scale this low level signal to
±3 V, which
can then be digitized by a high speed, 100 kHz sampling ADC
such as the AD7870.
The low voltage excitation is used to permit the front-end cir-
cuitry to be powered from the isolated power supplies of the
AD215, which can supply up to
±10 mA of isolated power at
±15 V. The bridge draws only 3.5 mA, leaving sufficient cur-
rent to power the micropower dual BiFET (400
A quiescent
current) and the high speed AD744 BiFET amplifier (4 mA
quiescent current).
相关PDF资料 |
PDF描述 |
|---|---|
| AD521LDZ | IC AMP INST 40MHZ PREC LN 14CDIP |
| AD522BD | IC AMP INST 1.5KHZ LDRIFT 14CDIP |
| AD524CD | IC AMP INST 1MHZ PREC LN 16CDIP |
| AD526SD | IC AMP PGA 10MA 16CDIP |
| AD548KN | IC OPAMP GP 1MHZ LP PREC 8DIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD215BY | 功能描述:IC AMP ISOL LDIST 5MA 44SIP RoHS:否 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:2,500 系列:- 放大器类型:通用 电路数:4 输出类型:- 转换速率:0.6 V/µs 增益带宽积:1MHz -3db带宽:- 电流 - 输入偏压:45nA 电压 - 输入偏移:2000µV 电流 - 电源:1.4mA 电流 - 输出 / 通道:40mA 电压 - 电源，单路/双路(±):3 V ~ 32 V，±1.5 V ~ 16 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:14-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:14-TSSOP 包装:带卷 (TR) 其它名称:LM324ADTBR2G-NDLM324ADTBR2GOSTR |
| AD215BY | 制造商:Analog Devices 功能描述:IC AMP ISOLATION |
| AD215BYZ | 制造商:Analog Devices 功能描述:ISOLATION AMPLIFIER IC PACKAGE/CASE:12-S |
| AD-2164S | 制造商:BOTHHAND 制造商全称:Bothhand USA, LP. 功能描述:ADSL LINE TRANSFORMER |
| AD2-165Q-30000281 | 制造商:Amphenol Commercial 功能描述:RACK & PANEL CONNECTOR 制造商:Amphenol Corporation 功能描述:RACK AND PANEL CONNECTOR |
发布紧急采购，3分钟左右您将得到回复。