参数资料
| 型号： | AD5421CREZ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 26/36页 |
| 文件大小： | 0K |
| 描述： | IC DAC 16BIT SPI/SRL 28TSSOP |
| 标准包装： | 50 |
| 设置时间： | 50µs |
| 位数： | 16 |
| 数据接口： | 串行，SPI? |
| 转换器数目： | 1 |
| 电压电源： | 单电源 |
| 功率耗散（最大）： | 625mW |
| 工作温度： | -40°C ~ 105°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-SOIC（0.173"，4.40mm 宽）裸露焊盘 |
| 供应商设备封装： | 28-TSSOP 裸露焊盘 |
| 包装： | 管件 |
| 输出数目和类型： | 1 电压，单极 |
| 采样率（每秒）： | * |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页当前第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
AD5421
Data Sheet
Rev. G | Page 32 of 36
APPLICATIONS INFORMATION
Figure 50 shows a typical connection diagram for the AD5421
configured in a HART capable smart transmitter. Such a HART
enabled smart transmitter was developed by Analog Devices as
a reference demo circuit. This circuit, whose block diagram is
shown in Figure 51, was verified and registered as an approved
HART solution by the HART Communication Foundation.
This circuit is available as a Circuit from the Lab at CN0267,
To reduce power dissipation on the chip, a depletion mode
MOSFET (T1), such as a DN2540 or BSP129, can be connected
between the loop voltage and the AD5421, as shown in Figure 50.
If a low loop voltage is used, T1 does not need to be inserted,
In Figure 50, all interface signal lines are connected to the micro-
controller. To reduce the number of interface signal lines, the
LDAC signal can be connected to COM, and the SDO and FAULT
lines can be left unconnected. However, this configuration disables
the use of the fault alert features.
Under normal operating conditions, the voltage between COM
and LOOP does not exceed 1.5 V, and the voltage at LOOP is
negative with respect to COM. If it is possible that the voltage at
LOOP may be forced positive with respect to COM, or if the
voltage difference between LOOP and COM may be forced in
excess of 5 V, a 4.7 V low leakage Zener diode should be placed
between COM and the LOOP pin, as shown in Figure 50, to
protect the AD5421 from potential damage.
DETERMINING THE EXPECTED TOTAL ERROR
The AD5421 can be set up in a number of different configu-
rations, each of which achieves different levels of accuracy, as
described in Table 1 and Table 2. With the internal voltage
reference and internal RSET enabled, a maximum total error
of 0.157% of full-scale range can be expected for the C grade
device over the temperature range of 40°C to +105°C.
Other configurations specify an external voltage reference, an
external RSET resistor, or both an external voltage reference and
external RSET resistor. In these configurations, the specifications
assume that the external voltage reference and external RSET
resistor are ideal. Therefore, the errors associated with these
components must be added to the data sheet specifications to
determine the overall performance. The performance depends
on the specifications of these components.
091
28
-0
55
HART_OUT
ADC_IP
REF
AD5700/AD5700-1
47nF
168nF
300pF
VCC
RL
200k
LOOP–
REXT1
REXT2
DRIVE
COM
REFOUT1 REFIN
R
EG
_SEL
0
R
EG
_SEL
1
R
EG
_SEL
2
REGIN
IODVDD DVDD REGOUT
VLOOP
AD5421
19M
1M
VLOOP
ADuCM360
SYNC
SCLK
SDIN
SDO
RINT/REXT
ALARM_CURRENT_DIRECTION
RANGE1
RANGE0
FAULT
LDAC
COM
TXD
RXD
RTS
CD
R1
470
1.2M
150k
1.2M
150pF
OPTIONAL
RESISTOR
T1
OPTIONAL
MOSFET
DN2540
BSP129
0.1F
SETS REGULATOR
VOLTAGE
CIN
10F
0.1F
1F
0.1F
VZ = 4.7V
4.7F
REFOUT2
OPTIONAL
EMC FILTER
1F
DGND
AGND
Figure 50. AD5421 Application Diagram for HART Capable Smart Transmitter
相关PDF资料 |
PDF描述 |
|---|---|
| AD5422ACPZ-REEL7 | IC DAC 16BIT SRL 40LFCSP |
| AD5441BRMZ-REEL7 | IC DAC 12BIT SERIAL IN 8MSOP |
| AD5445YRU | IC DAC 12BIT PARALL IOUT 20TSSOP |
| AD5446YRM | IC DAC 14BIT MULTIPLYING 10-MSOP |
| AD5447YRU | IC DAC 12BIT DUAL MULT 24-TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD5421CREZ-RL | 功能描述:IC DAC 16BIT SPI/SRL 28TSSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 数模转换器 系列:- 标准包装:47 系列:- 设置时间:2µs 位数:14 数据接口:并联 转换器数目:1 电压电源:单电源 功率耗散（最大）:55µW 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:28-SSOP（0.209"，5.30mm 宽） 供应商设备封装:28-SSOP 包装:管件 输出数目和类型:1 电流，单极；1 电流，双极 采样率（每秒）:* |
| AD5421CREZ-RL7 | 功能描述:IC DAC 16BIT SPI/SRL 28TSSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 数模转换器 系列:- 标准包装:47 系列:- 设置时间:2µs 位数:14 数据接口:并联 转换器数目:1 电压电源:单电源 功率耗散（最大）:55µW 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:28-SSOP（0.209"，5.30mm 宽） 供应商设备封装:28-SSOP 包装:管件 输出数目和类型:1 电流，单极；1 电流，双极 采样率（每秒）:* |
| AD5422 | 制造商:AD 制造商全称:Analog Devices 功能描述:Single Channel, 12/16-Bit, Serial Input, Current Source & Voltage Output DAC |
| AD5422ACPZ | 制造商:AD 制造商全称:Analog Devices 功能描述:Single Channel, 12/16-Bit, Serial Input, Current Source & Voltage Output DAC |
| AD5422ACPZ-REEL | 功能描述:IC DAC 16BIT SRL 40LFCSP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 数模转换器 系列:- 标准包装:47 系列:- 设置时间:2µs 位数:14 数据接口:并联 转换器数目:1 电压电源:单电源 功率耗散（最大）:55µW 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:28-SSOP（0.209"，5.30mm 宽） 供应商设备封装:28-SSOP 包装:管件 输出数目和类型:1 电流，单极；1 电流，双极 采样率（每秒）:* |
发布紧急采购，3分钟左右您将得到回复。