参数资料
| 型号： | AD622AR |
| 厂商： | Analog Devices Inc |
| 文件页数： | 5/17页 |
| 文件大小： | 0K |
| 描述： | IC AMP INST LP 18MA 8SOIC |
| 标准包装： | 98 |
| 放大器类型： | 仪表 |
| 电路数： | 1 |
| 转换速率： | 1.2 V/µs |
| -3db带宽： | 1MHz |
| 电流 - 输入偏压： | 2nA |
| 电压 - 输入偏移： | 60µV |
| 电流 - 电源： | 900µA |
| 电流 - 输出 / 通道： | 18mA |
| 电压 - 电源，单路/双路(±)： | ±2.6 V ~ 18 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SO |
| 包装： | 管件 |
AD622
Data Sheet
Rev. E | Page 12 of 16
RF INTERFERENCE
RF rectification is often a problem when amplifiers are used in
applications where there are strong RF signals. The disturbance
may appear as a small dc offset voltage. High frequency signals
can be filtered with a low-pass, RC network placed at the input
of the instrumentation amplifier, as shown in Figure 19. In
addition, this RC input network also provides additional input
overload protection (see the Input Protection section).
RG
REF
VOUT
+IN
–IN
AD622
+
0.1F
10F
+
0.1F
10F
+VS
–VS
CC
1nF
CD
47nF
CC
1nF
R
4.02k
R
4.02k
00777-
017
Figure 19. RFI Suppression Circuit for AD622 Series In-Amps
The filter limits the input signal bandwidth to the following
cutoff frequencies:
)
(2
2
1
C
D
DIFF
C
R
FilterFreq
+
π
=
C
CM
RC
FilterFreq
π
=
2
1
where CD ≥ 10CC.
Figure 19 shows an example where the differential filter
frequency is approximately 400 Hz, and the common-mode
filter frequency is approximately 40 kHz. With this differential
filter in place and operating at gain of 1000, the typical dc offset
shift over a frequency range of 1 Hz to 20 MHz is less than 1.5 V
RTI, and the RF signal rejection of the circuit is better than
71 dB. At a gain of 100, the dc offset shift is well below 1 mV
RTI, and RF rejection is greater than 70 dB.
The input resistors should be selected to be high enough to
isolate the sensor from the CC and C D capacitors but low
enough not to influence system noise. Mismatch between
R × CC at the positive input and R × CC at the negative input
degrades the CMRR of the AD622. Therefore, the CC capacitors
should be high precision types such as NPO/COG ceramics.
The tolerance of the CD capacitor is less critical.
GROUND RETURNS FOR INPUT BIAS CURRENTS
Input bias currents are those currents necessary to bias the
input transistors of an amplifier. There must be a direct return
path for these currents; therefore, when amplifying floating
input sources such as transformers or ac-coupled sources, there
must be a dc path from each input to ground as shown in
Guide to Instrumentation Amplifiers (free from Analog Devices,
Inc.) for more information regarding in-amp applications.
AD622
2
1
8
3
4
5
6
7
+VS
–VS
RG
VOUT
LOAD
–IN
+IN
REF
TO POWER
SUPPLY
GROUND
00777-
018
Figure 20. Ground Returns for Bias Currents with Transformer Coupled Inputs
AD622
2
1
8
3
4
5
6
7
+VS
–VS
RG
VOUT
LOAD
–IN
+IN
REF
TO POWER
SUPPLY
GROUND
00777-
019
Figure 21. Ground Returns for Bias Currents with Thermocouple Inputs
AD622
2
1
8
3
4
5
6
7
+VS
–VS
RG
VOUT
LOAD
–IN
+IN
REF
TO POWER
SUPPLY
GROUND
100k
00777-
020
Figure 22. Ground Returns for Bias Currents with AC-Coupled Inputs
相关PDF资料 |
PDF描述 |
|---|---|
| AD8513AR-REEL7 | IC OPAMP JFET 8MHZ QUAD 14SOIC |
| OP462GS-REEL7 | IC OPAMP GP R-R 15MHZ LN 14SOIC |
| LTC1992-5HMS8#PBF | IC AMP/DVR I/O GAIN-5 DIFF 8MSOP |
| LTC1992-5HMS8 | IC AMP/DVR DIFF I/O GAIN-5 8MSOP |
| LTC1992-5IMS8#PBF | IC AMP/DVR I/O GAIN-5 DIFF 8MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD622AR-REEL | 功能描述:IC AMP INST LP 18MA 8SOIC RoHS:否 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:2,500 系列:- 放大器类型:通用 电路数:1 输出类型:满摆幅 转换速率:0.11 V/µs 增益带宽积:350kHz -3db带宽:- 电流 - 输入偏压:4nA 电压 - 输入偏移:20µV 电流 - 电源:260µA 电流 - 输出 / 通道:20mA 电压 - 电源，单路/双路(±):2.7 V ~ 36 V，±1.35 V ~ 18 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 供应商设备封装:8-SO 包装:带卷 (TR) |
| AD622AR-REEL7 | 功能描述:IC AMP INST LP 18MA 8SOIC RoHS:否 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:1 系列:- 放大器类型:通用 电路数:4 输出类型:满摆幅 转换速率:0.028 V/µs 增益带宽积:105kHz -3db带宽:- 电流 - 输入偏压:3nA 电压 - 输入偏移:100µV 电流 - 电源:3.3µA 电流 - 输出 / 通道:12mA 电压 - 电源，单路/双路(±):2.7 V ~ 12 V，±1.35 V ~ 6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:14-TSSOP 包装:剪切带 (CT) 其它名称:OP481GRUZ-REELCT |
| AD622ARZ | 功能描述:IC AMP INST LP 18MA 8SOIC RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:2,500 系列:- 放大器类型:通用 电路数:4 输出类型:- 转换速率:0.6 V/µs 增益带宽积:1MHz -3db带宽:- 电流 - 输入偏压:45nA 电压 - 输入偏移:2000µV 电流 - 电源:1.4mA 电流 - 输出 / 通道:40mA 电压 - 电源，单路/双路(±):3 V ~ 32 V，±1.5 V ~ 16 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:14-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:14-TSSOP 包装:带卷 (TR) 其它名称:LM324ADTBR2G-NDLM324ADTBR2GOSTR |
| AD622ARZ-R7 | 功能描述:IC AMP INST LP 18MA 8SOIC RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:1 系列:- 放大器类型:通用 电路数:4 输出类型:满摆幅 转换速率:0.028 V/µs 增益带宽积:105kHz -3db带宽:- 电流 - 输入偏压:3nA 电压 - 输入偏移:100µV 电流 - 电源:3.3µA 电流 - 输出 / 通道:12mA 电压 - 电源，单路/双路(±):2.7 V ~ 12 V，±1.35 V ~ 6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:14-TSSOP 包装:剪切带 (CT) 其它名称:OP481GRUZ-REELCT |
| AD622ARZ-RL | 功能描述:IC AMP INST LP 18MA 8SOIC RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:100 系列:- 放大器类型:通用 电路数:1 输出类型:- 转换速率:0.2 V/µs 增益带宽积:- -3db带宽:- 电流 - 输入偏压:100pA 电压 - 输入偏移:30µV 电流 - 电源:380µA 电流 - 输出 / 通道:- 电压 - 电源，单路/双路(±):±2 V ~ 18 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 供应商设备封装:8-SO 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。