- 您现在的位置：买卖IC网 > PDF目录22188 > AD637JQ (Analog Devices Inc)IC RMS/DC CONV PRECISION 14-CDIP PDF资料下载
参数资料
| 型号： | AD637JQ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 9/21页 |
| 文件大小： | 0K |
| 描述： | IC RMS/DC CONV PRECISION 14-CDIP |
| 产品培训模块： | Introduction to Analog RMS-to-DC Technology: Converters and Applications |
| 标准包装： | 25 |
| 电流 - 电源： | 2.2mA |
| 电源电压： | ±3 V ~ 18 V |
| 安装类型： | 通孔 |
| 封装/外壳： | 14-CDIP（0.300"，7.62mm） |
| 供应商设备封装： | 14-CERDIP |
| 包装： | 管件 |
| 产品目录页面： | 786 (CN2011-ZH PDF) |
| 配用： | AD637-EVALZ-ND - BOARD EVALUATION FOR AD637 |
AD637
STANDARD CONNECTION
The AD637 is simple to connect for a majority of rms
only a single external capacitor is required to set the averaging
time constant. In this configuration, the AD637 computes the
true rms of any input signal. An averaging error, the magnitude
of which is dependent on the value of the averaging capacitor,
is present at low frequencies. For example, if the filter capacitor,
C AV , is 4 μF, the error is 0.1% at 10 Hz and increases to 1% at
3 Hz. To measure ac signals, the AD637 can be ac-coupled by
adding a nonpolar capacitor in series with the input, as shown
20
15
10
5
0
0
±3
±5
±10
±15
±18
SUPPLY VOLTAGE – DUAL SUPPLY (V)
1 BUFF IN
AD637
BUFF
OUT 14
Figure 6. Maximum V OUT vs. Supply Voltage
NC
+V S
4.7k ?
2 NC
3 COMMON
OUTPUT
4 OFFSET
5 CS
BIAS
SQUARER/
DIVIDER
ABSOLUTE
VALUE
25k ?
V IN 13
NC 12
11
+V S
10
–V S
V IN
(OPTIONAL)
+V S
–V S
CHIP SELECT
The AD637 includes a chip select feature that allows the user
to decrease the quiescent current of the device from 2.2 mA to
350 μA. This is done by driving CS, Pin 5, to below 0.2 V dc.
Under these conditions, the output goes into a high impedance
state. In addition to reducing the power consumption,
V OUT = V IN2
DEN
6 INPUT 25k ?
7 dB OUTPUT
9
+ C AV
C AV 8
the outputs of multiple devices can be connected in parallel
to form a wide bandwidth rms multiplexer. Tie Pin 5 high to
disable the chip select.
OPTIONAL TRIMS FOR HIGH ACCURACY
Figure 5. Standard RMS Connection
The performance of the AD637 is tolerant of minor variations
in the power supply voltages; however, if the supplies used
exhibit a considerable amount of high frequency ripple, it is
advisable to bypass both supplies to ground through a 0.1 μF
ceramic disc capacitor placed as close to the device as possible.
The output signal range of the AD637 is a function of the
supply voltages, as shown in Figure 6. The output signal can be
used buffered or nonbuffered, depending on the characteristics
of the load. If no buffer is needed, tie the buffer input (Pin 1) to
common. The output of the AD637 is capable of driving 5 mA
into a 2 kΩ load without degrading the accuracy of the device.
The AD637 includes provisions for trimming out output offset
and scale factor errors resulting in significant reduction in the
maximum total error, as shown in Figure 7. The residual error is
due to a nontrimmable input offset in the absolute value circuit
and the irreducible nonlinearity of the device.
Referring to Figure 8, the trimming process is as follows:
? Offset trim: Ground the input signal (V IN ) and adjust R1 to
give 0 V output from Pin 9. Alternatively, R1 can be adjusted
to give the correct output with the lowest expected value of V IN .
? Scale factor trim: Resistor R4 is inserted in series with the
input to lower the range of the scale factor. Connect the
desired full-scale input to V IN , using either a dc or a calibrated ac
signal, and trim Resistor R3 to give the correct output at Pin 9
(that is, 1 V dc at the input results in a dc output voltage of
l.000 V dc). A 2 V p-p sine wave input yields 0.707 V dc at the
output. Remaining errors are due to the nonlinearity.
Rev. K | Page 8 of 20
相关PDF资料 |
PDF描述 |
|---|---|
| UG2003-T | DIODE ULT FAST 2A 200V DO-15 |
| VI-J03-IZ | CONVERTER MOD DC/DC 24V 25W |
| WSU150-0560 | POWER SUPPLY 100-240V 560MA |
| 592D336X9016R4T15H | CAP TANT 33UF 16V 10% 2824 |
| VI-J01-IZ | CONVERTER MOD DC/DC 12V 25W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD637JR | 功能描述:IC TRUE RMS/DC CONV WDBND 16SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - RMS 至 DC 转换器 系列:- 标准包装:46 系列:- 电流 - 电源:1.2mA 电源电压:±18 V，36 V 安装类型:表面贴装 封装/外壳:16-SOIC（0.295"，7.50mm 宽） 供应商设备封装:16-SOIC W 包装:管件 |
| AD637JR-REEL | 功能描述:IC RMS/DC CONV PRECISION 16-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - RMS 至 DC 转换器 系列:- 标准包装:46 系列:- 电流 - 电源:1.2mA 电源电压:±18 V，36 V 安装类型:表面贴装 封装/外壳:16-SOIC（0.295"，7.50mm 宽） 供应商设备封装:16-SOIC W 包装:管件 |
| AD637JR-REEL7 | 功能描述:IC RMS/DC CONV PRECISION 16-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - RMS 至 DC 转换器 系列:- 标准包装:46 系列:- 电流 - 电源:1.2mA 电源电压:±18 V，36 V 安装类型:表面贴装 封装/外壳:16-SOIC（0.295"，7.50mm 宽） 供应商设备封装:16-SOIC W 包装:管件 |
| AD637JRZ | 功能描述:IC RMS/DC CONV PREC WB 16-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - RMS 至 DC 转换器 系列:- 标准包装:46 系列:- 电流 - 电源:1.2mA 电源电压:±18 V，36 V 安装类型:表面贴装 封装/外壳:16-SOIC（0.295"，7.50mm 宽） 供应商设备封装:16-SOIC W 包装:管件 |
| AD637JRZ | 制造商:Analog Devices 功能描述:RMS to DC Converter (RMS/DC) IC 制造商:Analog Devices 功能描述:IC, RMS-DC CONV, 0.25%, 8MHZ, SOIC-16 |
发布紧急采购，3分钟左右您将得到回复。