参数资料
| 型号： | AD8141ACPZ-RL |
| 厂商： | Analog Devices Inc |
| 文件页数： | 11/24页 |
| 文件大小： | 0K |
| 描述： | IC VIDEO AMP TRPL DIFF 24LFCSP |
| 标准包装： | 5,000 |
| 应用： | 驱动器 |
| 输出类型： | 差分 |
| 电路数： | 3 |
| -3db带宽： | 275MHz |
| 转换速率： | 1150 V/µs |
| 电流 - 电源： | 44mA |
| 电压 - 电源，单路/双路(±)： | 4.5 V ~ 5.5 V，±2.25 V ~ 2.75 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-WFQFN 裸露焊盘，CSP |
| 供应商设备封装： | 24-LFCSP-WQ（4x4） |
| 包装： | 带卷 (TR) |
Data Sheet
AD8141/AD8142
Rev. A | Page 19 of 24
SINGLE 5 V SUPPLY APPLICATION INFORMATION
The AD8141 and AD8142 require a nominal voltage of 5 V
across their VS+ and VS power supply pins, and that their EPADs
be connected to system ground; the voltage between VS+ and the
local system ground must be greater than or equal to 2.5 V and
less than or equal to 5 V. These requirements can be met by a
single +5 V supply, or split supplies such as ±2.5 V, +3 V/2 V,
and so on. Operating the AD8141 and AD8142 with ±2.5 V
supplies provides considerable power savings compared with
other drivers operating at ±5 V supplies, without any disadvantages
with regard to input and output ranges in most cases.
The receivers used with the AD8141 and AD8142, such as the
with split supplies, ranging from ±5 V to ±12 V. The split supply
arrangement results in a receiver input common-mode range
that is centered at 0 V relative to the local ground reference and
ranges to within a volt or two from each rail. Ground potential
differences normally exist between the driver end and the receiver
end, and these differences cause the relative common-mode
voltages between the driver and receiver to shift. See Figure 43
for an example.
2 V, VR, CM is 2 V. This is because the receiver ground is shifted
down by 2 V relative to the driver ground, and the common-
mode level on the cable stays constant. It can be seen from this
example that the most margin to absorb ground shifts exists
when the center of the receiver input common-mode voltage
range relative to its ground is the same as the output common-
mode voltage of the driver with respect to its ground.
Most receivers operate with their input common-mode ranges
centered at 0 V; therefore, the best case for the driver is to set its
output common-mode voltage to 0 V. This is not possible for the
using split supplies. If a single 5 V supply is required, the rail-
to-rail output allows the AD8141 output common-mode voltage
to be set to less than 1 V to be as close as possible to the ideal
the AD8142 has internal sync-encoding circuitry that fixes the
nominal output common-mode voltage at 1.5 V above the negative
rail. Each part has a resistive divider on the VOCM input that sets
the nominal output common-mode voltage to 1.5 V above the
negative rail when no external voltage is applied. The divider
consists of a 8.75 kΩ resistor to VS+ and a 3.75 kΩ resistor to VS,
forming a Thevenin equivalent load of 2.6 kΩ to 30% of the
voltage across the supplies. In the single 5 V supply case, the
Thevenin load voltage is 30% of 5 V above 0 V, or 1.5 V.
+
–
09
46
1-
0
41
100
49.9
DRIVER
100
UTP
49.9
+
VR, CM
–
+
VO, CM
–
+ –
VSHIFT
+
–
VOCM
AD8141/AD8142
Figure 43. End-to-End Common-Mode Shifts due to Ground Shifts
相关PDF资料 |
PDF描述 |
|---|---|
| AD8147ACPZ-R2 | IC DRIVER TRPL DIFF VID 24-LFCSP |
| AD817AR | IC OPAMP HS LP 8-SOIC |
| AD818AR | IC VIDEO OPAMP 130MHZ LP 8-SOIC |
| AD828AR | IC VIDEO OPAMP DUAL LP 8-SOIC |
| AD829SQ | IC VIDEO OPAMP HS LN 8-CDIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD8142 | 制造商:AD 制造商全称:Analog Devices 功能描述:Low Cost, Triple Differential Drivers |
| AD8142ACPZ-R2 | 制造商:Analog Devices 功能描述:Video Amp Triple 5.5V 24-Pin LFCSP EP T/R 制造商:Analog Devices 功能描述:LOW COST CAT5 DRIVER - Tape and Reel |
| AD8142ACPZ-R7 | 功能描述:IC AMP VIDEO TRIPLE DR 24-LFCSP RoHS:是 类别:集成电路 (IC) >> 线性 - 放大器 - 视频放大器和频缓冲器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:50 系列:- 应用:TFT-LCD 面板：VCOM 驱动器 输出类型:满摆幅 电路数:1 -3db带宽:35MHz 转换速率:40 V/µs 电流 - 电源:3.7mA 电流 - 输出 / 通道:1.3A 电压 - 电源，单路/双路(±):9 V ~ 20 V，±4.5 V ~ 10 V 安装类型:表面贴装 封装/外壳:8-TSSOP，8-MSOP（0.118"，3.00mm 宽）裸露焊盘 供应商设备封装:8-uMax-EP 包装:管件 |
| AD8142ACPZ-RL | 功能描述:IC VIDEO AMP TRPL DIFF 24LFCSP RoHS:是 类别:集成电路 (IC) >> 线性 - 放大器 - 视频放大器和频缓冲器 系列:- 标准包装:1,000 系列:- 应用:驱动器 输出类型:差分 电路数:3 -3db带宽:350MHz 转换速率:1000 V/µs 电流 - 电源:14.5mA 电流 - 输出 / 通道:60mA 电压 - 电源，单路/双路(±):5 V ~ 12 V，±2.5 V ~ 6 V 安装类型:表面贴装 封装/外壳:20-VFQFN 裸露焊盘 供应商设备封装:20-QFN 裸露焊盘（4x4） 包装:带卷 (TR) |
| AD8142-EVALZ | 制造商:AD 制造商全称:Analog Devices 功能描述:Low Cost, Triple Differential Drivers |
发布紧急采购，3分钟左右您将得到回复。