- 您现在的位置：买卖IC网 > PDF目录373943 > AD8321AR (ANALOG DEVICES INC) Gain Programmable CATV Line Driver PDF资料下载
参数资料
| 型号： | AD8321AR |
| 厂商： | ANALOG DEVICES INC |
| 元件分类： | 通用总线功能 |
| 英文描述： | Gain Programmable CATV Line Driver |
| 中文描述： | LINE DRIVER, PDSO20 |
| 封装： | MS-013AC, SOIC-20 |
| 文件页数： | 7/19页 |
| 文件大小： | 660K |
| 代理商： | AD8321AR |
AD8321
–7–
REV. 0
OPERATIONAL DESCRIPTION
The AD8321 is a digitally controlled variable gain power ampli-
fier that is optimized for driving a 75
cable. As a multifunc-
tional bipolar device on a single silicon die, it incorporates all
the analog features necessary to accommodate reverse path
(upstream) high speed (5 MHz to 65 MHz) cable data modem
requirements. The AD8321 has an overall gain range of ap-
proximately 53 dB and is capable of greater than 100 MHz
operation at output signal levels exceeding 12 dBm. Overall,
when considering the device’s wide gain range, low distortion,
wide bandwidth and variable load drive, the device can be used
in many variable gain block applications.
AD8321
POWER-
DOWN/
SWITCH
INTER
ATTENUATOR CORE
INV
DATDATA LATCH
DATA SHIFT REGISTER
PWR
AMP
DATEN
CLK
VIN+
VIN–
PD
VOUT
REVERSE
AMP
GND
VCC
SDATA
Figure 22. Functional Block Diagram
The digitally programmable gain is controlled by the three-wire
“SPI” compatible inputs. These inputs are called SDATA
(serial data input port),
DATEN
(data enable low input port)
and CLK (clock input port). See Pin Function Descriptions
and Functional Block diagram. The AD8321 is programmed by
an 8-bit “attenuator” word. When a standard 8-bit word is
used, the first data bit MSB will be shifted out of the 7-bit shift
register during the eighth rising CLK edge. The lower seven
bits will then be loaded into the AD8321’s digital decode sec-
tion when the
DATEN
input is taken high.
The gain of the AD8321 is linear in steps of 0.7526 dB. The
gain transfer function starts at –27.43 dB (at decimal code 0)
and increases 0.7526 dB/LSB. The gain increases up to decimal
code 71. At this point the gain is at its maximum level of 26 dB.
If a decimal word between 71 and 127 is entered, the gain is no
longer incremented and stays at 26 dB. Since the MSB of an 8-bit
word is a “don’t care” bit, at decimal code 128, the AD8321’s
gain returns to its minimum value. The gain vs. gain control
relationship repeats itself as shown in Figure 23 for the upper
127 codes.
The gain transfer function is as follows:
A
V
= 26 dB – ((71 – CODE)
×
0.7526 dB) for CODE
≤
71
A
V
= 26 dB for 71
≤
CODE
≤
127
A
V
= 26 dB + ((199 – CODE)
×
0.7526 dB) for 128
≤
CODE
≤
199
A
V
= 26 dB for 199
≤
CODE
≤
255
where CODE is the decimal equivalent of the 8-bit word loaded in
the AD8321’s data latch (see Figure 23).
GAIN CODE – Decimal
30
20
–300
256
G
10
0
–10
–20
32
224
192
160
128
64
96
Figure 23. Linear-In dB Gain vs. Gain Control
The AD8321 is composed of four analog functions in the
power-up or forward mode. The input amplifier (preamp) which
can be used single-endedly or differentially and provides a maxi-
mum of 12 dB of attenuation. If the input is used in the differ-
ential configuration, it is imperative that the input signals are
180 degrees out of phase and of equal amplitudes. This will
ensure the proper gain accuracy and harmonic performance.
The preamp stage drives a vernier stage that provides the fine
tune gain adjustment. The 0.7526 dB step resolution is imple-
mented in this stage. After the vernier stage, a DAC provides the
bulk of the AD8321’s attenuation (six bits or 36 dB). The signals
in the preamp and vernier gain blocks are differential to im-
prove the PSRR and linearity. A single-ended current is fed
from the DAC into the output stage, which amplifies this cur-
rent to the appropriate level necessary to drive a 75
load. The
output stage utilizes negative feedback to implement a
75
output impedance. This eliminates the need for an exter-
nal 75
matching resistor needed in typical video (or video
filter) termination requirements.
相关PDF资料 |
PDF描述 |
|---|---|
| AD8322ARU-REEL | 5 V CATV Line Driver Coarse Step Output Power Control |
| AD8322-EVAL | 5 V CATV Line Driver Coarse Step Output Power Control |
| AD8322ARU | 5 V CATV Line Driver Coarse Step Output Power Control |
| AD8322 | 5 V CATV Line Driver Coarse Step Output Power Control |
| AD8323ARU-REEL | 5 V CATV Line Driver Fine Step Output Power Control |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD8321AR-REEL | 制造商:Analog Devices 功能描述:SP Amp Line Driver Amp Single 20-Pin SOIC W T/R |
| AD8321ARZ | 功能描述:IC LINE DRIVER CATV 3.3V 20SOIC RoHS:是 类别:集成电路 (IC) >> 线性 - 视频处理 系列:- 产品变化通告:Product Discontinuation 07/Mar/2011 标准包装:3,000 系列:OMNITUNE™ 类型:调谐器 应用:移动电话，手机，视频显示器 安装类型:表面贴装 封装/外壳:65-WFBGA 供应商设备封装:PG-WFSGA-65 包装:带卷 (TR) 其它名称:SP000365064 |
| AD8321ARZ2 | 制造商:AD 制造商全称:Analog Devices 功能描述:Gain Programmable CATV Line DRiver |
| AD8321ARZ-REEL | 功能描述:IC LINE DVR CATV 20-SOIC T/R RoHS:是 类别:集成电路 (IC) >> 线性 - 视频处理 系列:- 产品变化通告:Product Discontinuation 07/Mar/2011 标准包装:3,000 系列:OMNITUNE™ 类型:调谐器 应用:移动电话，手机，视频显示器 安装类型:表面贴装 封装/外壳:65-WFBGA 供应商设备封装:PG-WFSGA-65 包装:带卷 (TR) 其它名称:SP000365064 |
| AD8321ARZ-REEL2 | 制造商:AD 制造商全称:Analog Devices 功能描述:Gain Programmable CATV Line DRiver |
发布紧急采购，3分钟左右您将得到回复。